Significant Surface Spin Effects and Exchange Bias in Iron Oxide-Based Hollow Magnetic Nanoparticles.

Exchange bias (EB) properties have become especially important in hollow magnetic nanoparticles (MNPs) due to the versatility and reduced size of these materials. In this work, we present the synthesis and study of the EB properties of iron-oxide-based hollow MNPs and their precursors Fe/iron oxide MNPs with core/void/shell structure. The two mechanisms involved in EB generation were investigated: the frozen spins present in the nanograins that form the nanoparticles and the surface spins. The effect of external parameters on the coercivity (HC), remanence (MR), exchange bias field (HEB) and frozen spins, such as cooling field (HFC) and temperature, was investigated. Both HC and HEB present a maximum threshold above which their values begin to decrease with HFC, showing a new trend of HEB with HFC and allowing modulation on demand. The existence of surface spins, present on the outer and inner surfaces, was demonstrated, and an intrinsic EB phenomenon (HEB = 444 Oe for hollow iron oxide-based MNPs of 13.1 nm) with significant magnetization (MS~50 emu/g) was obtained. Finally, core/void/shell MNPs of 11.9 nm prior to the formation of the hollow MNPs showed a similar behavior, with non-negligible HEB, highlighting the importance of surface spins in EB generation.

A Milestone in the Chemical Synthesis of Fe3O4 Nanoparticles: Unreported Bulklike Properties Lead to a Remarkable Magnetic Hyperthermia.

Among iron oxide phases, magnetite (Fe3O4) is often the preferred one for nanotechnological and biomedical applications because of its high saturation magnetization and low toxicity. Although there are several synthetic routes that attempt to reach magnetite nanoparticles (NPs), they are usually referred as "IONPs" (iron oxide NPs) due to the great difficulty in obtaining the monophasic and stoichiometric Fe3O4 phase. Added to this problem is the common increase of size/shape polydispersity when larger NPs (D > 20 nm) are synthesized. An unequivocal correlation between a nanomaterial and its properties can only be achieved by the production of highly homogeneous systems, which, in turn, is only possible by the continuous improvement of synthesis methods. There is no doubt that solving the compositional heterogeneity of IONPs while keeping them monodisperse remains a challenge for synthetic chemistry. Herein, we present a methodical optimization of the iron oleate decomposition method to obtain Fe3O4 single nanocrystals without any trace of secondary phases and with no need of postsynthetic treatment. The average dimension of the NPs, ranging from 20 to 40 nm, has been tailored by adjusting the total volume and the boiling point of the reaction mixture. Mössbauer spectroscopy and DC magnetometry have revealed that the NPs present a perfectly stoichiometric Fe3O4 phase. The high saturation magnetization (93 (2) A·m2/kg at RT) and the extremely sharp Verwey transition (at around 120 K) shown by these NPs have no precedent. Moreover, the synthesis method has been refined to obtain NPs with octahedral morphology and suitable magnetic anisotropy, which significantly improves the magnetic hyperthemia performance. The heating power of properly PEGylated nano-octahedrons has been investigated by AC magnetometry, confirming that the NPs present negligible dipolar interactions, which leads to an outstanding magnetothermal efficiency that does not change when the NPs are dispersed in environments with high viscosity and ionic strength. Additionally, the heat production of the NPs within physiological media has been directly measured by calorimetry under clinically safe conditions, reasserting the excellent adequacy of the system for hyperthermia therapies. To the best of our knowledge, this is the first time that such bulklike magnetite NPs (with minimal size/shape polydispersity, minor agglomeration, and exceptional heating power) are chemically synthesized.

Shaping Up Zn-Doped Magnetite Nanoparticles from Mono- and Bimetallic Oleates: The Impact of Zn Content, Fe Vacancies, and Morphology on Magnetic Hyperthermia Performance.

The currently existing magnetic hyperthermia treatments usually need to employ very large doses of magnetic nanoparticles (MNPs) and/or excessively high excitation conditions (H × f > 1010 A/m s) to reach the therapeutic temperature range that triggers cancer cell death. To make this anticancer therapy truly minimally invasive, it is crucial the development of improved chemical routes that give rise to monodisperse MNPs with high saturation magnetization and negligible dipolar interactions. Herein, we present an innovative chemical route to synthesize Zn-doped magnetite NPs based on the thermolysis of two kinds of organometallic precursors: (i) a mixture of two monometallic oleates (FeOl + ZnOl), and (ii) a bimetallic iron-zinc oleate (Fe3-y Zn y Ol). These approaches have allowed tailoring the size (10-50 nm), morphology (spherical, cubic, and cuboctahedral), and zinc content (Zn x Fe3-x O4, 0.05 < x < 0.25) of MNPs with high saturation magnetization (≥90 Am2/kg at RT). The oxidation state and the local symmetry of Zn2+ and Fe2+/3+ cations have been investigated by means of X-ray absorption near-edge structure (XANES) spectroscopy, while the Fe center distribution and vacancies within the ferrite lattice have been examined in detail through Mössbauer spectroscopy, which has led to an accurate determination of the stoichiometry in each sample. To achieve good biocompatibility and colloidal stability in physiological conditions, the Zn x Fe3-x O4 NPs have been coated with high-molecular-weight poly(ethylene glycol) (PEG). The magnetothermal efficiency of Zn x Fe3-x O4@PEG samples has been systematically analyzed in terms of composition, size, and morphology, making use of the latest-generation AC magnetometer that is able to reach 90 mT. The heating capacity of Zn0.06Fe2.9 4O4 cuboctahedrons of 25 nm reaches a maximum value of 3652 W/g (at 40 kA/m and 605 kHz), but most importantly, they reach a highly satisfactory value (600 W/g) under strict safety excitation conditions (at 36 kA/m and 125 kHz). Additionally, the excellent heating power of the system is kept identical both immobilized in agar and in the cellular environment, proving the great potential and reliability of this platform for magnetic hyperthermia therapies.

Highly Reproducible Hyperthermia Response in Water, Agar, and Cellular Environment by Discretely PEGylated Magnetite Nanoparticles.

Local heat generation from magnetic nanoparticles (MNPs) exposed to alternating magnetic fields can revolutionize cancer treatment. However, the application of MNPs as anticancer agents is limited by serious drawbacks. Foremost among these are the fast uptake and biodegradation of MNPs by cells and the unpredictable magnetic behavior of the MNPs when they accumulate within or around cells and tissues. In fact, several studies have reported that the heating power of MNPs is severely reduced in the cellular environment, probably due to a combination of increased viscosity and strong NP agglomeration. Herein, we present an optimized protocol to coat magnetite (Fe3O4) NPs larger than 20 nm (FM-NPs) with high molecular weight PEG molecules that avoid collective coatings, prevent the formation of large clusters of NPs and keep constant their high heating performance in environments with very different ionic strengths and viscosities (distilled water, physiological solutions, agar and cell culture media). The great reproducibility and reliability of the heating capacity of this FM-NP@PEG system in such different environments has been confirmed by AC magnetometry and by more conventional calorimetric measurements. The explanation of this behavior has been shown to lie in preserving as much as possible the magnetic single domain-type behavior of nearly isolated NPs. In vitro endocytosis experiments in a colon cancer-derived cell line indicate that FM-NP@PEG formulations with PEGs of higher molecular weight (20 kDa) are more resistant to endocytosis than formulations with smaller PEGs (5 kDa), showing quite large uptake mean-life (τ > 5 h) in comparison with other NP systems. The in vitro magnetic hyperthermia was performed at 21 mT and 650 kHz during 1 h in a pre-endocytosis stage and complete cell death was achieved 48 h posthyperthermia. These optimal FM-NP@PEG formulations with high resistance to endocytosis and predictable magnetic response will aid the progress and accuracy of the emerging era of theranostics.

Outstanding heat loss via nano-octahedra above 20 nm in size: from wustite-rich nanoparticles to magnetite single-crystals.

Most studies on magnetic nanoparticle-based hyperthermia utilize iron oxide nanoparticles smaller than 20 nm, which are intended to have superparamagnetic behavior (SP-MNPs). However, the heating power of larger magnetic nanoparticles with non-fluctuating or fixed magnetic dipoles (F-MNPs) can be significantly greater than that of SP-MNPs if high enough fields (H > 15 mT) are used. But the synthesis of larger single nanocrystals of magnetite (Fe3O4) with a regular shape and narrow size distribution devoid of secondary phases remains a challenge. Iron oxide nanoparticles, grown over 25 nm, often present large shape and size polydispersities, twinning defects and a significant fraction of the wüstite-type (FeO) paramagnetic phase, resulting in degradation of magnetic properties. Herein, we introduce an improved procedure to synthesize monodisperse F-MNPs in the range of 25 to 50 nm with a distinct octahedral morphology and very crystalline magnetite phase. We unravel the subtle phase transformation that takes place during the synthesis by a thorough study in several non-optimized nanoparticles presenting a core-shell structure or composed of magnetite-type clusters embedded in a wüstite lattice. Optimized magnetite samples present a slight decrease in the saturation magnetization compared to bulk magnetite, which is successfully explained by the presence of Fe2+ vacancies. However, due to the high quality of these samples, AC magnetometry measurements have shown excellent specific absorption rates (>1000 W gFe3O4-1 at 40 mT and 300 kHz). Most importantly, the magnetic response and the hyperthermia performance of properly coated F-MNPs are kept basically unaltered in media with very different viscosities and ionic strength. Finally, using a physical model based on single magnetic domain approaches, we derive a novel connection between the octahedral shape and the high hyperthermia performance.

Measurement of a pauli and orbital paramagnetic state in bulk gold using x-ray magnetic circular dichroism spectroscopy.

We show that bulk gold (Au) exhibits temperature-independent paramagnetism in an external magnetic field by x-ray magnetic circular dichroism spectroscopy at the Au L(2) and L(3) edges. Using the sum-rule analysis, we obtained a magnetic moment of 1.3 × 10(-4) µB/atom in an external magnetic field of 10 T and a paramagnetic susceptibility of 8.9 × 10(-6) for the 5d orbit. The induced paramagnetism in bulk Au is characterized by a large (≈ 30%) orbital contribution. This orbital component was retained even when Au atoms formed nanoparticles, playing an important role in stabilizing the spontaneous spin polarization in the Au nanoparticles.

Chemically induced permanent magnetism in Au, Ag, and Cu nanoparticles: localization of the magnetism by element selective techniques.

We report a direct observation of the intrinsic magnetization behavior of Au in thiol-capped gold nanoparticles with permanent magnetism at room temperature. Two element specific techniques have been used for this purpose: X-ray magnetic circular dichroism on the L edges of the Au and 197Au Mössbauer spectroscopy. Besides, we show that silver and copper nanoparticles synthesized by the same chemical procedure also present room-temperature permanent magnetism. The observed permanent magnetism at room temperature in Ag and Cu dodecanethiol-capped nanoparticles proves that the physical mechanisms associated to this magnetization process can be extended to more elements, opening the way to new and still not-discovered applications and to new possibilities to research basic questions of magnetism.

Structural, thermal, spectroscopic, specific-heat, and magnetic studies of (C5H18N3)[Fe3(HPO3)6].3H2O: a new organically templated iron(III) phosphite with a pillared structure formed by the interpenetration of two subnets.

A new open framework iron(III) phosphite with formula (C5H18N3)[Fe3(HPO3)6].3H2O has been prepared by hydrothermal synthesis with N-(2-aminoethyl)-1,3-propanediamine as a templating agent. The crystal structure was solved from single-crystal X-ray diffraction data in the trigonal space group R. The unit cell parameters are a= 8.803(1) A and c= 25.292(2) A with Z = 3. The complex pillared structure can be described as two interpenetrating subnets, one organic, [(C5H18N3).3H2O]3+, and one inorganic, [Fe3(HPO3)6]3-. In the inorganic subnet, the pillars are formed by FeO6 trimers linked by vertex sharing phosphite groups, while in the cationic subnet the organic molecules act like pillars. With increasing temperature, the flexibility of the structure allows contraction due to dehydration followed by thermal expansion before reaching the thermal stability limit. The Dq and Racah parameters calculated for (C5H18N3)[Fe3(HPO3)6].3H2O are Dq = 965, B = 1080, and C = 2472 cm(-1). Mössbauer spectroscopy confirms the trivalent oxidation state of iron cations and the crystallographic multiplicities of their sites. The ESR spectra show isotropic signals with a g-value of 2.00(1). Specific-heat measurements show a three-dimensional (lambda-type) peak at a critical temperature Tc = 32 K. The value of the entropy at saturation is 46 J/mol K, very near the expected value of 44.7 J/mol K for the iron(III) cations with S = 5/2. Magnetic measurements indicate a three-dimensional antiferromagnetic ordering below 32 K and a reorientation of spins below 15 K with an incomplete cancellation of spins due to triangular interactions inherent to the structure.