Evaluation of the pit and fissure system in primary and permanent molars with micro-computed tomography and 3D printing.

This study aimed to characterize the anatomical and physiological features of pits and fissures in primary and permanent molars by microtomographic (micro-CT) examination and three-dimensional (3D) printing. The occlusal surfaces of 84 primary molars and 60 permanent third molars were examined. The samples were scanned with micro-CT and the occlusal surface separated. The areas of the crown, its occlusal part, and fissures and pits were calculated. Digital impression of the occlusal surface was created and 3D printed. The frequency of different fissure types was determined by direct observation. Data were subjected to statistical analysis using Mann-Whitney U Test and chi-square test (p < 0.05). There was statistically significant difference between the ratio of occlusal surface and the crown area for the molars in primary and permanent dentitions (24.78% and 28.85% respectively, p < 0.05). In terms of the percentage ratio of the fissure area to the occlusal surface (24.24% and 22.30%) and the fissure area to the crown (6.02% and 6.52%), no significant difference was observed (p > 0.05). V-shaped fissures were predominant in both primary and permanent teeth, with a higher occurrence in primary dentition (59.48%, p < 0.05). Permanent molars exhibited a higher prevalence of I-type and U-type fissure configurations compared to primary molars (p < 0.05), with I-type fissures being the least common in primary molars. In both dentitions there was no statistically significant difference in the prevalence of IK-configuration (p > 0.05). The fissure depth was significantly greater in permanent molars than primary molars (p < 0.05). In conclusion, this study revealed remarkable diversity in fissure morphology among primary and permanent molars.

Micro-computed tomography (micro-CT) evaluation of root canal morphology in immature maxillary third molars.

The endodontic treatment of immature permanent teeth with necrotic pulp is a significant clinical challenge. The success of regenerative endodontic procedure is highly dependent on disinfection of the root canal and an accurate anatomical knowledge of the root canal. The aim of this study was to use micro-computed tomography (micro-CT) analysis to investigate the configuration of root canals in the upper permanent third maxillary molars with incomplete root development in their coronal, apical and middle third portions. Thirty immature third permanent maxillary molars were scanned using a micro-CT system. Then, we measured the diameters and areas of the root canal in the coronal, middle and apical third of the roots. The ratio between the long and short diameter of each root canal was then calculated and the canals were divided into several groups: round, oval, long oval, flat and irregular. The round configuration was not observed in the distobuccal and mesiobuccal roots in any of their anatomical regions. Oval and long oval canals predominated in the distobuccal root. The greatest variations were observed in the mesiobuccal root, with the ribbon-shaped canal predominating in the middle region and an irregular shape in the apical region. In the coronal region of the palatal canal, the round configuration predominated; in the middle third, we observed an almost equivalent distribution between round and oval configurations; apically, the oval shape predominated. In conclusion, we observed significant complexity and variation in the morphology and configuration of root canals in immature permanent molars, thus generating additional obstacles for the success of regenerative endodontics.