A validation study for vinyl electrical tape end matches.

Fracture matches are considered the strongest conclusion in the forensic examination of rigid materials, such as glass, metal, and paint. However, publications that support the fracture matching of polymeric films, such as tape backings, are limited. This study was designed to determine the validity and error rate associated with conducting end-match (fracture match) examinations on vinyl electrical tape. Test designs varied the source roll of tape, test preparer, or mode of separation from the roll. Results indicated that each affected the resulting severed tape ends. The analysts examining the end matches also had an effect on the results. Eight end matches in the study were not identified by the initial analysts and were considered inconclusive. One end match was misidentified, resulting in one false positive and an error rate of 0.049%. These results support a comprehensive physical and chemical tape comparison regardless of indications of an end match.

Electrospray diagnostics by Fourier analysis of current oscillations and fast imaging.

The different spraying modes in electrospray ionization sources exhibit large variations in their ion yield and stability. To achieve consistently optimal ion production, active control of the spray parameters is desirable. To diagnose the changes in spraying mode, the spray current and its Fourier spectrum were monitored under a wide range of conditions, that is, as a function of the spray voltage, liquid flow rate, and composition. Most Fourier spectra indicated a strong dc component, a low-frequency branch at low flow rates and applied voltages, and a high-frequency branch and their harmonics. Changing of these parameters resulted in several spraying mode changes that were reflected in the Fourier spectra of the spray current. Significant mode changes and the malformation of the Taylor cone were detected as peak shifts or sudden changes in the spectrum quality. This was confirmed by fast imaging that showed a reduction in the size of the Taylor cone under hydrophobic tip conditions and rapid periodic ejection of filaments and droplets for high conductivity solutions. Comparing the oscillation frequencies of Taylor cones of different sizes, good correlation was found with the frequencies of capillary waves on comparablly sized liquid spheres. Spray stability was also linked with the positional stability of the contact line between the liquid meniscus and the capillary tip.