Uncovering the Electronic State Interplay at Metal Oxide Electron Transport Layer/Nonfullerene Acceptor Interfaces in Stable Organic Photovoltaic Devices.

The implementation of sputter-deposited TiOx as an electron transport layer in nonfullerene acceptor-based organic photovoltaics has been shown to significantly increase the long-term stability of devices compared to conventional solution-processed ZnO due to a decreased photocatalytic activity of the sputtered TiOx. In this work, we utilize synchrotron-based photoemission and absorption spectroscopies to investigate the interface between the electron transport layer, TiOx prepared by magnetron sputtering, and the nonfullerene acceptor, ITIC, prepared in situ by spray deposition to study the electronic state interplay and defect states at this interface. This is used to unveil the mechanisms behind the decreased photocatalytic activity of the sputter-deposited TiOx and thus also the increased stability of the organic solar cell devices. The results have been compared to similar measurements on anatase TiOx since anatase TiOx is known to have a strong photocatalytic activity. We show that the deposition of ITIC on top of the sputter-deposited TiOx results in an oxidation of Ti3+ species in the TiOx and leads to the emergence of a new O 1s peak that can be attributed to the oxygen in ITIC. In addition, increasing the thickness of ITIC on TiOx leads to a shift in the O 1s and C 1s core levels toward higher binding energies, which is consistent with electron transfer at the interface. Resonant photoemission at the Ti L-edge shows that oxygen vacancies in sputtered TiOx lie mostly in the surface region, which contrasts the anatase TiOx where an equal distribution between surface and subsurface oxygen vacancies is observed. Furthermore, it is shown that the subsurface oxygen vacancies in sputtered TiOx are strongly reduced after ITIC deposition, which can reduce the photocatalytic activity of the oxide, while the oxygen vacancies in model anatase TiOx are not affected upon ITIC deposition. This difference can explain the inferior photocatalytic activity of the sputter-deposited TiOx and thus also the increased stability of devices with sputter-deposited TiOx used as an electron transport layer.

FlexPES: a versatile soft X-ray beamline at MAX†IV Laboratory.

FlexPES is a soft X-ray beamline on the 1.5 GeV storage ring at MAX IV Laboratory, Sweden, providing horizontally polarized radiation in the 40-1500 eV photon energy range and specializing in high-resolution photoelectron spectroscopy, fast X-ray absorption spectroscopy and electron-ion/ion-ion coincidence techniques. The beamline is split into two branches currently serving three endstations, with a possibility of adding a fourth station at a free port. The refocusing optics provides two focal points on each branch, and enables either focused or defocused beam on the sample. The endstation EA01 at branch A (Surface and Materials Science) is dedicated to surface- and materials-science experiments on solid samples at ultra-high vacuum. It is well suited not only to all flavours of photoelectron spectroscopy but also to fast (down to sub-minute) high-resolution X-ray absorption measurements with various detectors. Branch B (Low-Density Matter Science) has the possibility to study gas-phase/liquid samples at elevated pressures. The first endstation of this branch, EB01, is a mobile setup for various ion-ion and electron-ion coincidence techniques. It houses a versatile reaction microscope, which can be used for experiments during single-bunch or multi-bunch delivery. The second endstation, EB02, is based on a rotatable chamber with an electron spectrometer for photoelectron spectroscopy studies on primarily volatile targets, and a number of peripheral setups for sample delivery, such as molecular/cluster beams, metal/semiconductor nanoparticle beams and liquid jets. This station can also be used for non-UHV photoemission studies on solid samples. In this paper, the optical layout and the present performance of the beamline and all its endstations are reported.

Interlayer Coupling of a Two-Dimensional Kondo Lattice with a Ferromagnetic Surface in the Antiferromagnet CeCo2P2.

The f-driven temperature scales at the surfaces of strongly correlated materials have increasingly come into the focus of research efforts. Here, we unveil the emergence of a two-dimensional Ce Kondo lattice, which couples ferromagnetically to the ordered Co lattice below the P-terminated surface of the antiferromagnet CeCo2P2. In its bulk, Ce is passive and behaves tetravalently. However, because of symmetry breaking and an effective magnetic field caused by an uncompensated ferromagnetic Co layer, the Ce 4f states become partially occupied and spin-polarized near the surface. The momentum-resolved photoemission measurements indicate a strong admixture of the Ce 4f states to the itinerant bands near the Fermi level including surface states that are split by exchange interaction with Co. The temperature-dependent measurements reveal strong changes of the 4f intensity at the Fermi level in accordance with the Kondo scenario. Our findings show how rich and diverse the f-driven properties can be at the surface of materials without f-physics in the bulk.

Electronic structure of the [Ni(Salen)] complex studied by core-level spectroscopies.

The nature and structure of occupied and empty valence electronic states (molecular orbitals, MOs) of the [Ni(Salen)] molecular complex (NiO2N2C16H14) have been studied by X-ray photoemission and absorption spectroscopy combined with density functional theory (DFT) calculations. As a result, the composition of the high-lying occupied and low-lying unoccupied electronic states has been identified. In particular, the highest occupied molecular orbital (HOMO) of the complex is found to be predominantly located on the phenyl rings of the salen ligand, while the states associated with the occupied Ni 3d-derived molecular orbitals (MOs) are at higher binding energies. The lowest unoccupied molecular orbital (LUMO) is also located on the salen ligand and is formed by the 2pπ orbitals of carbon atoms in phenyl groups of the salen macrocycle. The unoccupied MOs above the LUMO reflect σ- and π-bonding between Ni and its nearest neighbours. All valence states have highly mixed character. The specific nature of the unoccupied Ni 3d-derived σ-MO is a consequence of donor-acceptor chemical bonding in [Ni(Salen)].

One Precursor but Two Types of Graphene Nanoribbons: On-Surface Transformations of 10,10'-Dichloro-9,9'-bianthryl on Ag(111).

On-surface synthesis has emerged in the last decade as a method to create graphene nanoribbons (GNRs) with atomic precision. The underlying premise of this bottom-up strategy is that precursor molecules undergo a well-defined sequence of inter- and intramolecular reactions, leading to the formation of a single product. As such, the structure of the GNR is encoded in the precursors. However, recent examples have shown that not only the molecule, but also the coinage metal surface on which the reaction takes place, plays a decisive role in dictating the nanoribbon structure. In this work, we use scanning probe microscopy and X-ray photoelectron spectroscopy to investigate the behavior of 10,10'-dichloro-9,9'-bianthryl (DCBA) on Ag(111). Our study shows that Ag(111) can induce the formation of both seven-atom wide armchair GNRs (7-acGNRs) and 3,1-chiral GNRs (3,1-cGNRs), demonstrating that a single molecule on a single surface can react to different nanoribbon products. We additionally show that coadsorbed dibromoperylene can promote surface-assisted dehydrogenative coupling in DCBA, leading to the exclusive formation of 3,1-cGNRs.

Evidence for Anisotropic Electronic Coupling of Charge Transfer States in Weakly Interacting Organic Semiconductor Mixtures.

We present a comprehensive investigation of the charge-transfer (CT) effect in weakly interacting organic semiconductor mixtures. The donor-acceptor pair diindenoperylene (DIP) and N,N'-bis(2-ethylhexyl)-1,7-dicyanoperylene-3,4/9,10-bis(dicarboxyimide) (PDIR-CN2) has been chosen as a model system. A wide range of experimental methods was used in order to characterize the structural, optical, electronic, and device properties of the intermolecular interactions. By detailed analysis, we demonstrate that the partial CT in this weakly interacting mixture does not have a strong effect on the ground state and does not generate a hybrid orbital. We also find a strong CT transition in light absorption as well as in photo- and electroluminescence. By using different layer sequences and compositions, we are able to distinguish electronic coupling in-plane vs out-of-plane and, thus, characterize the anisotropy of the CT state. Finally, we discuss the impact of CT exciton generation on charge-carrier transport and on the efficiency of photovoltaic devices.

Spin Orientation of Two-Dimensional Electrons Driven by Temperature-Tunable Competition of Spin-Orbit and Exchange-Magnetic Interactions.

Finding ways to create and control the spin-dependent properties of two-dimensional electron states (2DESs) is a major challenge for the elaboration of novel spin-based devices. Spin-orbit and exchange-magnetic interactions (SOI and EMI) are two fundamental mechanisms that enable access to the tunability of spin-dependent properties of carriers. The silicon surface of HoRh2Si2 appears to be a unique model system, where concurrent SOI and EMI can be visualized and controlled by varying the temperature. The beauty and simplicity of this system lie in the 4f moments, which act as a multiple tuning instrument on the 2DESs, as the 4f projections parallel and perpendicular to the surface order at essentially different temperatures. Here we show that the SOI locks the spins of the 2DESs exclusively in the surface plane when the 4f moments are disordered: the Rashba-Bychkov effect. When the temperature is gradually lowered and the system experiences magnetic order, the rising EMI progressively competes with the SOI leading to a fundamental change in the spin-dependent properties of the 2DESs. The spins rotate and reorient toward the out-of-plane Ho 4f moments. Our findings show that the direction of the spins and the spin-splitting of the two-dimensional electrons at the surface can be manipulated in a controlled way by using only one parameter: the temperature.

Ionic Liquid Ordering at an Oxide Surface.

The interaction of the ionic liquid [C4 C1 Im][BF4 ] with anatase TiO2 , a model photoanode material, has been studied using a combination of synchrotron radiation photoelectron spectroscopy and near-edge X-ray absorption fine structure spectroscopy. The system is of interest as a model for fundamental electrolyte-electrode and dye-sensitized solar cells. The initial interaction involves degradation of the [BF4 ]- anion, resulting in incorporation of F into O vacancies in the anatase surface. At low coverages, [C4 C1 Im][BF4 ] is found to order at the anatase(101) surface via electrostatic attraction, with the imidazolium ring oriented 32±4° from the anatase TiO2 surface. As the coverage of ionic liquid increases, the influence of the oxide surface on the topmost layers is reduced and the ordering is lost.

Correlating structure and electronic band-edge properties in organolead halide perovskites nanoparticles.

After having emerged as primary contenders in the race for highly efficient optoelectronics materials, organolead halide perovskites (OHLP) are now being investigated in the nanoscale regime as promising building blocks with unique properties. For example, unlike their bulk counterpart, quantum dots of OHLP are brightly luminescent, owing to large exciton binding energies that cannot be rationalized solely on the basis of quantum confinement. Here, we establish the direct correlation between the structure and the electronic band-edge properties of CH3NH3PbBr3 nanoparticles. Complementary structural and spectroscopic measurements probing long-range and local order reveal that lattice strain influences the nature of the valence band and modifies the subtle stereochemical activity of the Pb(2+) lone-pair. More generally, this work demonstrates that the stereochemical activity of the lone-pair at the metal site is a specific physicochemical parameter coupled to composition, size and strain, which can be employed to engineer novel functionalities in OHLP nanomaterials.

Exciton Binding Energy and the Nature of Emissive States in Organometal Halide Perovskites.

Characteristics of nanoscale materials are often different from the corresponding bulk properties providing new, sometimes unexpected, opportunities for applications. Here we investigate the properties of 8 nm colloidal nanoparticles of MAPbBr3 perovskites and contrast them to the ones of large microcrystallites representing a bulk. X-ray spectroscopies provide an exciton binding energy of 0.32 ± 0.10 eV in the nanoparticles. This is 5 times higher than the value of bulk crystals (0.084 ± 0.010 eV), and readily explains the high fluorescence quantum yield in nanoparticles. In the bulk, at high excitation concentrations, the fluorescence intensity has quadratic behavior following the Saha-Langmuir model due to the nongeminate recombination of charges forming the emissive exciton states. In the nanoparticles, a linear dependence is observed since the excitation concentration per particle is significantly less than one. Even the bulk shows linear emission intensity dependence at lower excitation concentrations. In this case, the average excitation spacing becomes larger than the carrier diffusion length suppressing the nongeminate recombination. From these considerations we obtain the charge carrier diffusion length in MAPbBr3 of 100 nm.

From Graphene Nanoribbons on Cu(111) to Nanographene on Cu(110): Critical Role of Substrate Structure in the Bottom-Up Fabrication Strategy.

Bottom-up strategies can be effectively implemented for the fabrication of atomically precise graphene nanoribbons. Recently, using 10,10'-dibromo-9,9'-bianthracene (DBBA) as a molecular precursor to grow armchair nanoribbons on Au(111) and Cu(111), we have shown that substrate activity considerably affects the dynamics of ribbon formation, nonetheless without significant modifications in the growth mechanism. In this paper we compare the on-surface reaction pathways for DBBA molecules on Cu(111) and Cu(110). Evolution of both systems has been studied via a combination of core-level X-ray spectroscopies, scanning tunneling microscopy, and theoretical calculations. Experimental and theoretical results reveal a significant increase in reactivity for the open and anisotropic Cu(110) surface in comparison with the close-packed Cu(111). This increased reactivity results in a predominance of the molecular-substrate interaction over the intermolecular one, which has a critical impact on the transformations of DBBA on Cu(110). Unlike DBBA on Cu(111), the Ullmann coupling cannot be realized for DBBA/Cu(110) and the growth of nanoribbons via this mechanism is blocked. Instead, annealing of DBBA on Cu(110) at 250 °C results in the formation of a new structure: quasi-zero-dimensional flat nanographenes. Each nanographene unit has dehydrogenated zigzag edges bonded to the underlying Cu rows and oriented with the hydrogen-terminated armchair edge parallel to the [1-10] direction. Strong bonding of nanographene to the substrate manifests itself in a high adsorption energy of -12.7 eV and significant charge transfer of 3.46e from the copper surface. Nanographene units coordinated with bromine adatoms are able to arrange in highly regular arrays potentially suitable for nanotemplating.