Bioelectricity production from the anodic inoculation of Geobacter sulfurreducens DL-1 bacteria in constructed wetlands-microbial fuel cells.

Environmental pollution problems caused by the use of fossil fuels have led to the search for renewable energy sources to mitigate greenhouse gas emissions. In addition, constructed wetlands-microbial fuel cells (CW-MFC) could contribute to sustainable development, considering that this technology focuses on the production of bioelectricity. One of the main challenges of CW-MFCs is to potentiate their bioelectrochemical performance. Therefore, this research used the Geobacter sulfurreducens DL-1 bacterium (biofilm) as a bioelectrocatalyst to increase bioelectricity generation. For this, three bioreactors were built as CW-MFCs, using Juncus effusus root exudates and Philodendron cordatum macrophytes as endogenous substrates. The biofilm was developed in a nutrient broth acetate fumarate and directly inoculated onto the anodes of each CW-MFC. The results of bioelectrochemical analyses showed that the biofilm generated more bioelectricity when it consumed the exudates of the Juncus effusus macrophyte, resulting in a maximum performance of 107 mW/m2 power density, -361 mV anodic potential, 290 mV cathodic potential, and 124 Ω internal resistance, using a concentration of 27.5 mg/L of total organic carbon as an endogenous substrate. The results determined that the quantity of root exudates consumed by the anodic biofilm is directly related to the production of bioelectricity in CW-MFCs.

Identification of sugars as root exudates of the macrophyte species Juncus effusus and Philodendron cordatum in constructed wetland-microbial fuel cells during bioelectricity production.

Constructed wetland-microbial fuel cells (CW-MFCs) systems are a sustainable technology capable of producing bioelectricity and treating wastewater simultaneously. It is also possible to obtain bioelectricity from the photosynthetic substrates obtained by the rhizodeposition of macrophytes, where the electroactive microorganisms present in the rhizosphere use these compounds as biofuel. In the present study, the bioelectricity production capacity of Juncus effusus and Philodendron cordatum species was evaluated in a CW-MFC without an external carbon source. The Juncus effusus species showed a higher bioelectrochemical performance, as they recorded a maximum voltage of 399 mV, a power density of 63.7 mW/m2, a volumetric power density of 15.9 W/m3, an internal resistance of 200 Ω, an anodic potential of -368 mV, and a cathodic potential of 229 mV. In addition, different types of carbohydrates in the form of sugars (sucrose, fructose, galactose, and glucose) were quantified by liquid chromatography, with concentrations of 100-450 µg/L. Chromatographic analysis were performed from the root exudates released in the effluent of both species of macrophyte. Sucrose and glucose were the types of sugars that produced the largest amount with portions of up to 35% and 24%, respectively. Sugars are compounds that worked as electron donors for the production of bioelectricity by using endogenous substrates that fed the anodic biofilm. Consumption was 45-55% for sucrose and 40-65% for glucose. Of the different macrophytes evaluated in the CW-MFCs, it was observed that the production of bioelectricity differs mainly due to the quantity of the root exudates released in the rhizosphere.

Bioelectricity production using shade macrophytes in constructed wetlands-microbial fuel cells.

The coupling of constructed wetlands (CW) to microbial fuel cells (MFC) has become a promising hybrid technology due to its high compatibility to generate electricity and remove pollutants from wastewater. In the present study, the bioelectricity production generated from constructed wetlands-microbial fuel cells (CW-MFCs) was evaluated using four species of shade macrophytes: Aglaonema commutatum, Epipremnum aureum, Dranacaena braunni, and Philodendron cordatum. The CW-MFCs were operated in a continuous upflow mode with a hydraulic retention time (HRT) of 4 d. The systems were fed with synthetic water without an external carbon source. The bioelectrochemical systems were operated under diffuse radiation conditions (shadow). Philodendron cordatum was the macrophyte species that produced a maximum voltage of 103 mV, with a power density of 12.5 mW/m2. High voltages were obtained when the diffuse radiation in the CW-MFCs was 3000-4000 µmol.m2/s. The maximum production of root exudates was 20.6 mg/L as total organic carbon for the Philodendron cordatum species. Philodendron cordatum was the macrophyte species that obtained high conversion efficiency (0.0014%), compared to other macrophyte species (< 0.0008%). In the CW-MFCs systems it was observed that the bioelectricity production was mainly due to the quantity of the root exudates released into the rhizospheres of the plants.

Domestic wastewater treatment and power generation in continuous flow air-cathode stacked microbial fuel cell: Effect of series and parallel configuration.

In this study, a continuous flow stack consisting of 40 individual air-cathode MFC units was used to determine the performance of stacked MFC during domestic wastewater treatment operated with unconnected individual MFC and in series and parallel configuration. The voltages obtained from individual MFC units were of 0.08-1.1 V at open circuit voltage, while in series connection, the maximum power and current density were 2500 mW/m2 and 500 mA/m2 (4.9 V), respectively. In parallel connection, the maximum power and current density was 5.8 mW/m2 and 24 mA/m2, respectively. When the cells were not connected to each other MFC unit, the main bacterial species found in the anode biofilms were Bacillus and Lysinibacillus. After switching from unconnected to series and parallel connections, the most abundant species in the stacked MFC were Pseudomonas aeruginosa, followed by different Bacilli classes. This study demonstrated that when the stacked MFC was switched from unconnected to series and parallel connections, the pollutants removal, performance electricity and microbial community changed significantly. Voltages drops were observed in the stacked MFC, which was mainly limited by the cathodes. These voltages loss indicated high resistances within the stacked MFC, generating a parasitic cross current.

Performance of air-cathode stacked microbial fuel cells systems for wastewater treatment and electricity production.

Two different air-cathode stacked microbial fuel cell (MFC) configurations were evaluated under continuous flow during the treatment of municipal wastewater and electricity production at a hydraulic retention time (HRT) of 3, 1, and 0.5 d. Stacked MFC 1 was formed by 20 individual air-cathode MFC units. The second stacked MFC (stacked MFC 2) consisted of 40 air-cathode MFC units placed in a shared reactor. The maximum voltages produced at closed circuit (1,000 Ω) were 170 mV for stacked MFC 1 and 94 mV for stacked MFC 2. Different power densities in each MFC unit were obtained due to a potential drop phenomenon and to a change in chemical oxygen demand (COD) concentrations inside reactors. The maximum power densities from individual MFC units were up to 1,107 mW/m2 for stacked MFC 1 and up to 472 mW/m2 for stacked MFC 2. The maximum power densities in stacked MFC 1 and MFC 2 connected in series were 79 mW/m2 and 4 mW/m2, respectively. Electricity generation and COD removal efficiencies were reduced when the HRT was decreased. High removal efficiencies of 84% of COD, 47% of total nitrogen, and 30% of total phosphorus were obtained during municipal wastewater treatment.