The Effect of Acromioplasty or Bursectomy on the Results of Arthroscopic Repair of Full Thickness Rotator Cuff Tears: Does the Acromion Type Affect These Results?

Objectives: The aim of this study was to investigate the effect of subacromial decompression on the results of full thickness rotator cuff repair applied arthroscopically. Examination was also made of the effect of acromion type on the subacromial decompression procedure in patients applied with arthroscopic rotator cuff repair. Methods: The study included a total of 150 patients, comprising 102 (68%) females and 48 (32%) males with a full thickness rotator cuff tear repaired arthroscopically. The patients were separated into three groups of 50. Group A comprised those with acromioplasty and bursectomy applied additional to the repair. In Group B, only bursectomy was performed additional to the repair and in Group C, only rotator cuff repair was applied. Evaluation was made of the post-operative long-term pain and functional results. Results: The mean age of the cases was 65.63±9.22 years (range, 46-86 years). The affected side was right side in 95 (63.3%) cases and left side in 55 (36.7%). No statistically significant difference was determined between the groups according to the post-operative Constant Murley and ASES scores (p>0.05). In the paired comparisons, the post-operative VAS scores of Group C were higher than those of Groups A and B (p=0.018, p=0.029, p<0.05). No statistically significant difference was determined between Group A and Group B in respect of the post-operative VAS scores (p>0.05). Conclusion: In the arthroscopic repair of full thickness rotator cuff tears, neither acromioplasty, coracoacromial ligament loosening nor bursectomy were determined to have any positive effect on the results. Whatever the acromion type, there is no need for an additional subacromial decompression procedure after rotator cuff repair, in respect of pain and functional outcomes. Only acromial spurs should be gently removed paying attention to the coraco-acromial ligament.

Forty-five-degree or higher insertion angles are required to penetrate the opposite cortex in bicortical applications of Kirschner wires: an in vitro study on sheep bones.

PURPOSE: Slippage of the wires over the opposite cortex from the endosteal side is frequent and can lead to insufficient stability. This in vitro biomechanical study was planned to investigate the angle of wire insertion that leads to trans cortex perforation. METHODS: Long bones of sheep were cut longitudinally into two pieces and half bones were stabilised on a frame. Three orthopaedic surgeons performed the experiment using ten wires of four different diameters at two different drilling speeds. Each wire was introduced from the endosteal side at angles starting at 30° in 5° increments until perforation. When perforation was achieved, the angle was recorded. To determinate the critical angle of perforation, receiver operating characteristic (ROC) curve analyses was performed. Two-way factorial analysis of variance (ANOVA) and Kruskal-Wallis tests were used for statistical comparisons. RESULTS: Kirschner-wire insertion angles of ≥ 45° provided perforation with a percentage of 83.9 %. Wire diameter, drilling speed and surgeon variables had no effect on perforation angles (p > 0.05). CONCLUSION: If preoperative evaluation of fractures to be fixed by K wires reveals the need for oblique wire insertion angle < 45°, a standard trocar-tip K wire application would lead to slippage of the wire tip on the endosteal surface of the opposite cortex. According to this study, the operative plan should be changed if such obliquity of the K wire is mandatory during bicortical applications.