Evaluating the cost of robotic-assisted total and unicompartmental knee arthroplasty.

As uptake of robotic-assisted arthroplasty increases there is a need for economic evaluation of the implementation and ongoing costs associated with robotic surgery. The aims of this study were to describe the in-hospital cost of robotic-assisted total knee arthroplasty (RA-TKA) and robotic-assisted unicompartmental knee arthroplasty (RA-UKA) and determine the influence of patient characteristics and surgical outcomes on cost. This prospective cohort study included adult patients (≥ 18 years) undergoing primary unilateral RA-TKA and RA-UKA, at a tertiary hospital in Sydney between April 2017 and June 2021. Patient characteristics, surgical outcomes, and in-hospital cost variables were extracted from hospital medical records. Differences between outcomes for RA-TKA and RA-UKA were compared using independent sample t-tests. Logistic regression was performed to determine drivers of cost. Of the 308 robotic-assisted procedures, 247 were RA-TKA and 61 were RA-UKA. Surgical time, time in the operating room, and length of stay were significantly shorter in RA-UKA (p < 0.001); whereas RA-TKA patients were older (p = 0.002) and more likely to be discharged to in-patient rehabilitation (p = 0.009). Total in-hospital cost was significantly higher for RA-TKA cases (AU$18580.02 vs $13275.38; p < 0.001). Robotic system and maintenance cost per case was AU$3867.00 for TKA and AU$5008.77 for UKA. Patients born overseas and lower volume robotic surgeons were significantly associated with higher total cost of RA-UKA. Increasing age and male gender were significantly associated with higher total cost of RA-TKA. Total cost was significantly higher for RA-TKA than RA-UKA. Robotic system costs for RA-UKA are inflated by the software cost relative to the volume of cases compared with RA-TKA. Cost is an important consideration when evaluating long term benefits of robotic-assisted knee arthroplasty in future studies to provide evidence for the economic sustainability of this practice.

Intercondylar Notch Width as a Risk Factor for Medial Femoral Condyle Osteochondritis Dissecans in Skeletally Immature Patients.

BACKGROUND: Juvenile osteochondritis dissecans (OCD) of the medial femoral condyle (MFC) is one of the most common causes of knee pain in adolescents. Wilson sign reproduces knee pain with internal rotation of the tibia during extension of the knee from 90 to 30 degrees due to impingement of the tibial eminence on the MFC. This impingement may result in microtrauma and contribute to lesion formation. The purpose of this study was to evaluate anatomic factors that may increase the likelihood of impingement by using magnetic resonance imaging scans of patients with MFC OCD lesions to measure tibial eminence height and femoral notch width. METHODS: A retrospective, case-control study was performed using the radiology database at our institution between July 2009 and February 2014. Magnetic resonance imagings of patients with MFC OCD lesions and matched controls were identified. For each patient, tibial eminence height and femoral notch width were measured and then normalized for patient size [creating the tibial eminence height normalized, and the notch width index (NWI), respectively]. Values for OCD and control knees were compared using Student t test. Interrater and intrarater reliability were calculated using intraclass correlation coefficients. RESULTS: Thirty-five MFC OCD patients and matched controls were identified. Comparison of the groups showed a significantly smaller NWI in MFC OCD knees than in the matched controls (0.2620±0.0248 vs. 0.2886 ±0.0323, P=0.0003). There was no difference in tibial eminence height normalized between groups (0.1387±0.0161 vs. 0.1428±0.0108, P=0.21). Interrater and intrarater reliability of all measurements was good to excellent (0.81 to 1.00) when measurements were made using bony margins. CONCLUSIONS: Knees with MFC OCD lesions have significantly smaller NWIs than matched controls. This anatomic factor may increase the likelihood of tibial eminence impingement and contribute to OCD lesion formation. LEVEL OF EVIDENCE: Level III-case-control study.

The diagnostic accuracy of Böhler's angle in fractures of the calcaneus.

BACKGROUND: Böhler's historical tuber-joint angle of the calcaneus has been used since 1931. Surprisingly, there is a paucity of literature on its use. OBJECTIVES: To confirm the normal range for Böhler's angle and determine the angle with the highest accuracy in the diagnosis of calcaneal fractures. METHODS: A retrospective cohort study was performed. The study cohort comprised 424 patients spanning a 5-year period from April 2005 to March 2010. Böhler's angle was measured by two independent observers on lateral x-ray study using the digital angle tool from the Picture Archival and Communication System. Data were analyzed using Stata 8 statistical software package. RESULTS: The mean Böhler's angle in patients without calcaneal fracture was 29.4°. In this group there was no difference in Böhler's angle between male and female patients, left and right feet, or across age. In those patients with calcaneal fractures, a Böhler's angle below 25° was moderately predictive of calcaneal fracture (sensitivity = 100%, specificity = 82%), an angle below 23° was highly predictive of calcaneal fracture (sensitivity = 100%, specificity = 89%), and an angle below 21° was strongly suggestive of calcaneal fracture (sensitivity = 99%, specificity = 99%). A Böhler's angle of ≤ 20° had the highest diagnostic accuracy. CONCLUSION: A Böhler's angle of 20° or less is highly accurate in determining the presence or absence of calcaneal fracture. Böhler's angle serves as a useful screening tool in fracture diagnosis.

Optimum take-off angle in the long jump.

In this study, we found that the optimum take-off angle for a long jumper may be predicted by combining the equation for the range of a projectile in free flight with the measured relations between take-off speed, take-off height and take-off angle for the athlete. The prediction method was evaluated using video measurements of three experienced male long jumpers who performed maximum-effort jumps over a wide range of take-off angles. To produce low take-off angles the athletes used a long and fast run-up, whereas higher take-off angles were produced using a progressively shorter and slower run-up. For all three athletes, the take-off speed decreased and the take-off height increased as the athlete jumped with a higher take-off angle. The calculated optimum take-off angles were in good agreement with the athletes' competition take-off angles.