Effects of Substitution on Cytotoxicity of Diphenyl Ditelluride in Cultured Vascular Endothelial Cells.

Among organic-inorganic hybrid molecules consisting of organic structure(s) and metal(s), only few studies are available on the cytotoxicity of nucleophilic molecules. In the present study, we investigated the cytotoxicity of a nucleophilic organotellurium compound, diphenyl ditelluride (DPDTe), using a cell culture system. DPDTe exhibited strong cytotoxicity against vascular endothelial cells and fibroblasts along with high intracellular accumulation but showed no cytotoxicity and had less accumulation in vascular smooth muscle cells and renal epithelial cells. The cytotoxicity of DPDTe decreased when intramolecular tellurium atoms were replaced with selenium or sulfur atoms. Electronic state analysis revealed that the electron density between tellurium atoms in DPDTe was much lower than those between selenium atoms of diphenyl diselenide and sulfur atoms of diphenyl disulfide. Moreover, diphenyl telluride did not accumulate and exhibit cytotoxicity. The cytotoxicity of DPDTe was also affected by substitution. p-Dimethoxy-DPDTe showed higher cytotoxicity, but p-dichloro-DPDTe and p-methyl-DPDTe showed lower cytotoxicity than that of DPDTe. The subcellular distribution of the compounds revealed that the compounds with stronger cytotoxicity showed higher accumulation rates in the mitochondria. Our findings suggest that the electronic state of tellurium atoms in DPDTe play an important role in accumulation and distribution of DPDTe in cultured cells. The present study supports the hypothesis that nucleophilic organometallic compounds, as well as electrophilic organometallic compounds, exhibit cytotoxicity by particular mechanisms.

Determination of brominated flame retardants including polybrominated diphenyl ethers, pentabromoethylbenzene, hexabromobiphenyl, and decabromodiphenyl ethane in sediment samples: Validation of a rapid and efficient clean-up method and application to a sediment core from Lake Biwa, Japan.

The development of rapid and efficient analytical method for the determination of legacy and current-use brominated flame retardants (BFRs) has been performed due to environmental concern related to these pollutants. In the present study, we used an automated clean-up device equipped with pre-packed micro-column sets (containing sulfuric acid impregnated silica gel and silver-modified alumina) to develop an effective purification method for polybrominated diphenyl ethers (PBDEs), pentabromoethylbenzene, hexabromobiphenyl, and decabromodiphenyl ethane (DBDPE) in sediment extracts. Matrix-spiked sediments (n = 6) and the Standard Reference Material® 1944 samples (n = 6) were tested. Our method showed acceptable accuracy, repeatability, and sensitivity for almost all the target compounds with reduced processing time, labor requirement, and solvent amounts as compared to conventional clean-up method (e.g., sulfuric acid treatment and self-packed chromatographic columns). The validated method was applied to sediment core samples (n = 16) collected in 2019 from Lake Biwa, the largest lake in Japan. PBDEs were detected in sediment samples of 0-13 cm depth (dated between 1990 and 2019) at relatively low concentrations (median 5.7; range 2.6-9.4 ng/g dry weight). PBDE profiles were dominated by BDE-209, which accounted for 91 ± 10% of total PBDEs. Among other BFRs, only DBDPE was found in sediment layers of 0-9 cm depth (deposited between 2005 and 2019). DBDPE concentrations ranged from 0.43 to 1.6 (median 0.71) ng/g and showed increasing trend toward shallower depths.

Substitutional and interstitial impurity p-type doping of thermoelectric Mg2Si: a theoretical study.

The narrow-gap magnesium silicide semiconductor Mg2Si is a promising mid-temperature (600-900 K) thermoelectric material. It intrinsically possesses n-type conductivity, and n-type dopants are generally used for improving its thermoelectric performance; however, the synthesis of p-type Mg2Si is relatively difficult. In this work, the hole doping of Mg2Si with various impurity atoms is investigated by performing first principles calculations. It is found that the Ag-doped systems exhibit comparable formation energies ΔE calculated for different impurity sites (Mg, Si, and interstitial 4b ones), which may explain the experimental instability of their p-type conductivity. A similar phenomenon is observed for the systems incorporating alkali metals (Li, Na, and K) since their ΔE values determined for Mg (p-type) and 4b (n-type) sites are very close. Among boron group elements (Ga and B), Ga is found to be favorable for hole doping because it exhibits relatively small ΔE values for Si (p-type) sites. Furthermore, the interstitial insertion of Cl and F atoms into the crystal lattice leads to hole doping because of their high electronegativity.

Validation of high-throughput measurement system with microwave-assisted extraction, fully automated sample preparation device, and gas chromatography-electron capture detector for determination of polychlorinated biphenyls in whale blubber.

Validation of a high-throughput measurement system with microwave-assisted extraction (MAE), fully automated sample preparation device (SPD), and gas chromatography-electron capture detector (GC-ECD) for the determination of polychlorinated biphenyls (PCBs) in minke whale blubber was performed. PCB congeners accounting for > 95% of the total PCBs burden in blubber were efficiently extracted with a small volume (20 mL) of n-hexane using MAE due to simultaneous saponification and extraction. Further, the crude extract obtained by MAE was rapidly purified and automatically substituted to a small volume (1 mL) of toluene using SPD without using concentrators. Furthermore, the concentration of PCBs in the purified and concentrated solution was accurately determined by GC-ECD. Moreover, the result of accuracy test using a certified material (SRM 1588b; Cod liver oil) showed good agreement with the NIST certified concentration values. In addition, the method quantification limit of total-PCB in whale blubbers was 41 ng g(-1). This new measurement system for PCBs takes only four hours. Consequently, it indicated this method is the most suitable for the monitoring and screening of PCBs in the conservation of the marine ecosystem and safe distribution of foods.