Tailored Sugar-Mediated Porous Particle Structures for Improved Dispersion of Drug Nanoparticles in Spray-Freeze-Drying.

We fabricated porous particles incorporating sugars (mannitol, sucrose, or dextran) and fenofibrate nanoparticles (FNPs) by using spray-freeze-drying (SFD). The type of sugar significantly influenced the pore architecture of the resulting SFD particles. Rapid freezing of droplets containing dextran produced ice encapsulation within a dextran matrix, forming porous dextran particles. In the presence of FNPs, the particle size (approximately 4 µm) and pore volume (0.3 cm3/g) of SFD dextran were barely affected. In contrast, SFD particles derived from mannitol and sucrose exhibited denser structures with a lower pore volume than dextran. SFD mannitol incorporating FNPs produced porous structures. FNPs containing surfactant and polymer, which reduced surface tension and increased viscosity, promoted the formation of small droplets with a polymeric structure and porous particles with a relatively sharp size distribution with a median around 5 µm. FNPs were uniformly distributed in SFD dextran, which featured large pore structures, whereas in SFD mannitol, the Raman signal of FNPs was more broadly distributed across the powder samples. Both morphologies contributed to enhancing the FNP dispersibility within a redispersed suspension of SFD particles. FNPs in SFD mannitol and dextran matrices maintained their particle size distribution from before SFD, showing no aggregation upon redispersion. Dextran formed a highly porous network irrespective of the presence of FNPs, whereas mannitol tended to alter the particle attributes upon FNP inclusion. In conclusion, SFD particles derived from dextran and mannitol might help to increase FNP dispersibility by increasing the formation of porous architectures.

Improvement in Inhalation Properties of Theophylline and Levofloxacin by Co-Amorphization and Enhancement in Its Stability by Addition of Amino Acid as a Third Component.

Co-amorphous systems are amorphous formulations stabilized by the miscible dispersion of small molecules. This study aimed to design a stable co-amorphous system for the co-delivery of two drugs to the lungs as an inhaled formulation. Theophylline (THE) and levofloxacin (LEV) were used as model drugs for treating lung infection with inflammation. Leucine (LEU) or tryptophan (TRP) was employed as the third component to improve the inhalation properties. The co-amorphous system containing THE and LEV in an equal molar ratio was successfully prepared via spray drying where reduction of the particle size and change to the spherical morphology were observed. The addition of LEU or TRP at a one-tenth molar ratio to THE-LEV did not affect the formation of the co-amorphous system, but only TRP acted as an antiplasticizer. The Fourier transform infrared spectroscopy spectra revealed intermolecular interactions between THE and LEV in the co-amorphous system that were retained after the addition of LEU or TRP. The co-amorphous THE-LEV system exhibited better in vitro aerodynamic performance than a physical mixture of these compounds and permitted the simultaneous delivery of both drugs in various stages. The co-amorphous THE-LEV system crystallized at 40 °C, and this crystallization was not prevented by LEU. However, THE-LEV-TRP maintained its amorphous state for 1 month. Thus, TRP can act as a third component to improve the physical stability of the co-amorphous THE-LEV system, while maintaining the enhanced aerodynamic properties.

Designing a Novel Coamorphous Salt Formulation of Telmisartan with Amlodipine to Enhance Permeability and Oral Absorption.

Coamorphous formulation is a useful approach for enhancing the solubility of poorly water-soluble drugs via intermolecular interactions. In this study, a hydrogen-bonding-based coamorphous system was developed to improve drug solubility, but it barely changed the apparent permeability (Papp) of the drug. This study aimed to design a novel coamorphous salt using ionic interactions to improve drug permeability and absorption. Telmisartan (TMS), with an acidic group, was used to form a coamorphous salt with basic amlodipine (AML). Evaluation of the physicochemical properties confirmed the formation of a coamorphous salt via ionic interactions between the amine group of AML and the carboxyl group of TMS at a molar ratio of 1:1. The coamorphous salt of TMS/AML enhanced the partitioning of both drugs into octanol, indicating increased lipophilicity owing to the interaction between TMS and AML. The coamorphous salt dramatically enhanced TMS solubility (99.8 times that of untreated TMS) and decreased AML solubility owing to the interaction between TMS and AML. Although the coamorphous salt showed a decreased Papp in the permeation study in the presence of a thicker unstirred water layer (UWL) without stirring, Papp increased in the presence of a thinner UWL with stirring. The oral absorption of TMS from the coamorphous salt increased by up to 4.1 times compared to that of untreated TMS, whereas that of AML remained unchanged. Although the coamorphous salt with increased lipophilicity has a disadvantage in terms of diffusion through the UWL, the UWL is thin in human/animal bodies owing to the peristaltic action of the digestive tract. Dissociation of the coamorphous salt on the membrane surface could contribute to the partitioning of the neutral form of drugs to the membrane cells compared with untreated drugs. As a result, coamorphous salt formation has the advantage of improving the membrane permeation and oral absorption of TMS, owing to the enhanced solubility and supply of membrane-permeable free TMS on the surface of the membrane.

The Enhanced Skin Permeation of Flavonoids Via the Application of a Coamorphous in a Microemulsion Formulation.

Improving the permeability and solubility of poorly water-soluble compounds is a major difficulty in skin permeation. In this study, we investigated whether using a pharmaceutical technique such as applying coamorphous to a microemulsion enhances the skin permeation of polyphenolic compounds. The melt-quenching technique created the coamorphous system between naringenin (NRG) and hesperetin (HPT), two polyphenolic compounds with poor water solubility. By creating a supersaturated state, the aqueous solution of coamorphous NRG/HPT demonstrated improved NRG and HPT skin permeation. However, as both compounds precipitated, the supersaturation ratio decreased. In contrast to crystal compounds, incorporating coamorphous material into microemulsions enabled the preparation of microemulsions in a wider formulation range. Additionally, compared to microemulsions with crystal compounds and an aqueous suspension of coamorphous, microemulsions with coamorphous NRG/HPT increased skin permeation of both compounds by more than four times. These results suggested that interactions between NRG and HPT are maintained in the microemulsion and enhance both compounds' skin permeation. An approach for improving the skin permeation of poorly water-soluble chemicals would be to apply a coamorphous system to a microemulsion.

Effect of Solubility Improvement via Formation of an Amorphous Composite of Indomethacin and Sulindac on Membrane Permeability.

The importance of permeability as well as solubility of the drug has been recognized in improving the solubility of poorly water-soluble drugs. This study investigated the impact of amorphous composites of indomethacin (IMC) and sulindac (SLD) on the membrane permeability of drugs. The IMC/SLD (1/1) formulation prepared by dry grinding was amorphous with a single glass transition temperature. The Fourier transform IR spectra and Raman spectra revealed formation of hydrogen bonds between the OH group of IMC and the carbonyl group of SLD. These results suggest that an amorphous composite was formed between IMC and SLD through hydrogen bonding. The amount of dissolved IMC and SLD from the amorphous composite of IMC/SLD (1/1) was higher than that of the untreated IMC or SLD in the dissolution test. The permeated amounts and permeation rates of both drugs were enhanced by increasing the solubility of the amorphous composite. Conversely, the apparent membrane permeability coefficients (Papp) were almost same for untreated drugs and amorphous composites. In the case of hydroxypropyl-ß-cyclodextrin and sodium dodecyl sulfate, Papp of the drugs decreased with the addition of these compounds, although the drug solubility was enhanced by the solubilization effect. This study revealed that an amorphous composite formed through hydrogen bonding is an attractive pharmaceutical way to enhance the permeated amount and permeation rate without changing the Papp of both the drugs.

Solubility and Permeability Improvement of Quercetin by an Interaction Between α-Glucosyl Stevia Nanoaggregates and Hydrophilic Polymer.

The effect of composite formation between α-glucosyl stevia (Stevia-G) and hydrophilic polymers on solubility and permeability enhancement of quercetin hydrate (QUE) was evaluated. Polyvinylpyrrolidone K-30 (PVP), hydroxypropyl methylcellulose 2910-E (HPMC), and hydroxypropyl cellulose SSL (HPC) were selected as candidate hydrophilic polymers. Fluorescence studies with pyrene and curcumin suggested composite formation occurs between Stevia-G aggregate and polymers. Furthermore, the strength of interaction between Stevia-G aggregate and polymers was as follows: PVP > HPMC > HPC. Evaporated particles (EVPs) of QUE with Stevia-G and polymers showed synergic QUE solubility enhancement. Solubility of QUE from the EVPs was enhanced in the following order: Stevia-G/PVP > Stevia-G/HPMC > Stevia-G/HPC, in accordance with the degree of interaction. Enhanced membrane permeability of QUE from the EVPs of Stevia-G/PVP was confirmed using Caco-2 cells. The amount of QUE that permeated Caco-2 cells from the EVPs of Stevia-G/PVP was 13.7-, 4.7-, and 2.1-fold higher than that of the untreated QUE powder, EVPs of Stevia-G, and EVPs of PVP, respectively. These results indicated that the composite formed by Stevia-G and PVP can dramatically enhance the solubility and membrane permeability of QUE.

Molecular dynamics study of thermodynamic stability and dynamics of [Li(glyme)]+ complex in lithium-glyme solvate ionic liquids.

Equimolar mixtures of glymes and organic lithium salts are known to produce solvate ionic liquids, in which the stability of the [Li(glyme)]+ complex plays an important role in determining the ionic dynamics. Since these mixtures have attractive physicochemical properties for application as electrolytes, it is important to understand the dependence of the stability of the [Li(glyme)]+ complex on the ion dynamics. A series of microsecond molecular dynamics simulations has been conducted to investigate the dynamic properties of these solvate ionic liquids. Successful solvate ionic liquids with high stability of the [Li(glyme)]+ complex have been shown to have enhanced ion dynamics. Li-glyme pair exchange rarely occurs: its characteristic time is longer than that of ion diffusion by one or two orders of magnitude. Li-glyme pair exchange most likely occurs through cluster formation involving multiple [Li(glyme)]+ pairs. In this process, multiple exchanges likely take place in a concerted manner without the production of energetically unfavorable free glyme or free Li+ ions.