Antioxidant and UV-blocking activity of PVA/tannin-based bioplastics in food packaging application.

In this study, bioplastics with antioxidant and UV protection properties based on tannin and PVA were created for packaging uses. Using a hot water extraction method at various extraction temperatures (60-100 °C), tannins were removed from the bark of Acacia mangium. Tannins with the best antioxidant activity were extracted at 80 °C. In order to create bioplastic formulations (PVA/Tannins), the extract is then employed. The non-heating bioplastic method's preparation (M3) stage produced the highest levels of antioxidant activity. Therefore, subsequent tests were conducted using the non-heating method (M3). On the opacity, UV protective activity, antioxidant capacity, mechanical strength, thermal stability, and water vapor permeability of the resultant bioplastics, the impact of tannin concentration (0.1-0.5 g) was examined. The findings of the experiments demonstrate that PVA/Tannin bioplastics are less transparent than pure PVA. The PVA/tannin bioplastics that are formed, on the whole, show strong antioxidant and UV protection action. Comparing PVA/Tannin bioplastics to pure PVA also revealed a small improvement in thermal stability and tensile strength. In PVA bioplastics with resistant tannins, moisture content was marginally greater even at low tannin concentrations (0.1 g). Based on the findings, bioplastics made from PVA and the tannin A. mangium have the potential to be used to create packaging that is UV and active antioxidant resistant. It can be applied as the second (inner) layer of the primary packaging to protect food freshness and nutrition due to their antioxidant activity.

Physical and Chemical Properties of Acacia mangium Lignin Isolated from Pulp Mill Byproduct for Potential Application in Wood Composites.

The efficient isolation process and understanding of lignin properties are essential to determine key features and insights for more effective lignin valorization as a renewable feedstock for the production of bio-based chemicals including wood adhesives. This study successfully used dilute acid precipitation to recover lignin from black liquor (BL) through a single-step and ethanol-fractionated-step, with a lignin recovery of ~35% and ~16%, respectively. The physical characteristics of lignin, i.e., its morphological structure, were evaluated by scanning electron microscopy (SEM). The chemical properties of the isolated lignin were characterized using comprehensive analytical techniques such as chemical composition, solubility test, morphological structure, Fourier-transform infrared spectroscopy (FTIR), 1H and 13C Nuclear Magnetic Resonance (NMR), elucidation structure by pyrolysis-gas chromatography-mass spectroscopy (Py-GCMS), and gel permeation chromatography (GPC). The fingerprint analysis by FTIR detected the unique peaks corresponding to lignin, such as C=C and C-O in aromatic rings, but no significant differences in the fingerprint result between both lignin. The 1H and 13C NMR showed unique signals related to functional groups in lignin molecules such as methoxy, aromatic protons, aldehyde, and carboxylic acid. The lower insoluble acid content of lignin derived from fractionated-step (69.94%) than single-step (77.45%) correlated to lignin yield, total phenolic content, solubility, thermal stability, and molecular distribution. It contradicted the syringyl/guaiacyl (S/G) units' ratio where ethanol fractionation slightly increased syringyl unit content, increasing the S/G ratio. Hence, the fractionation step affected more rupture and pores on the lignin morphological surface than the ethanol-fractionated step. The interrelationships between these chemical and physicochemical as well as different isolation methods were investigated. The results obtained could enhance the wider industrial application of lignin in manufacturing wood-based composites with improved properties and lower environmental impact.

Toxicity and Feeding Deterrent Effect of 2-Methylanthraquinone from the Wood Extractives of Tectona grandis on the Subterranean Termites Coptotermes formosanus and Reticulitermes speratus.

No-choice feeding tests using ethanol, chloroform, and acetone extractives of teak (Tectona grandis) heartwood clearly showed feeding deterrent activity and toxicity to the subterranean termite Reticulitermes speratus. The amount of 2-methylanthraquinone (MAQ) in teak wood extractives was not related to the feeding deterrents or toxicity, as shown by the no-choice feeding tests conducted using crude extractives containing various amounts of MAQ, MAQ alone, and fractions of crude extractives. As a native pest, the subterranean termite Coptotermes formosanus was more tolerant to the fractions of crude extractives than Reticulitermes speratus, and the mortality observed in C. formosanus was not due to the presence of MAQ.

The Efficacy of Organo-Complex-Based Wood Preservative Formula Against Dry-Wood Termite Cryptotermes cynocephalus Light.

The utilization of pesticides often leaves residues which potentially pollute the environment. This journal issue has been encouraging some researchers to find an environmentally friendly insecticide by a cheaper wood preservative method. The International Standard for Phytosanitary Measures 15 (ISPM 15) [1] that is adopted in wood packaging protection in Europe is not suitable for tropical countries like Indonesia. Therefore, the treatment by Organo-Complex-based wood preservation, which consists of copper chromium combined with natural organic compounds, is proposed for effective treatment at a lower cost. The bioassay test was subjected to dry wood termite Cryptotermes cynocephalus Light. The result showed that wood materials treated by 10 ppm Organo-Complex formula gave good results which were indicated by the low consumption and the fast termination of the termites. The toxicity analysis of C-C organic compound solution is classified as grade IV (WHO, 2003) [2], or not harmful. Analysis of the residual content four weeks after the spraying treatment showed a significant reduction in the inorganic content (copper chromate complex), in the range of 35%, and in extracts of natural materials (natural extracts), above 80%.