High-Efficiency Single-Cell Containment Microdevices Based on Fluid Control.

In this study, we developed a comb-shaped microfluidic device that can efficiently trap and culture a single cell (bacterium). Conventional culture devices have difficulty in trapping a single bacterium and often use a centrifuge to push the bacterium into the channel. The device developed in this study can store bacteria in almost all growth channels using the flowing fluid. In addition, chemical replacement can be performed in a few seconds, making this device suitable for culture experiments with resistant bacteria. The storage efficiency of microbeads that mimic bacteria was significantly improved from 0.2% to 84%. We used simulations to investigate the pressure loss in the growth channel. The pressure in the growth channel of the conventional device was more than 1400 PaG, whereas that of the new device was less than 400 PaG. Our microfluidic device was easily fabricated by a soft microelectromechanical systems method. The device was highly versatile and can be applied to various bacteria, such as Salmonella enterica serovar Typhimurium and Staphylococcus aureus.

Efficient Generation of Microdroplets Using Tail Breakup Induced with Multi-Branch Channels.

In recent years, research on the application of microdroplets in the fields of biotechnology and chemistry has made remarkable progress, but the technology for the stable generation of single-micrometer-scale microdroplets has not yet been established. In this paper, we developed an efficient and stable single-micrometer-scale droplet generation device based on the fragmentation of droplet tails, called "tail thread mode", that appears under moderate flow conditions. This method can efficiently encapsulate microbeads that mimic cells and chemical products in passively generated single-micrometer-scale microdroplets. The device has a simple 2D structure; a T-junction is used for droplet generation; and in the downstream, multi-branch channels are designed for droplet deformation into the tail. Several 1-2 µm droplets were successfully produced by the tail's fragmentation; this continuous splitting was induced by the branch channels. We examined a wide range of experimental conditions and found the optimal flow rate condition can be reduced to one-tenth compared to the conventional tip-streaming method. A mold was fabricated by simple soft lithography, and a polydimethylsiloxane (PDMS) device was fabricated using the mold. Based on the 15 patterns of experimental conditions and the results, the key factors for the generation of microdroplets in this device were examined. In the most efficient condition, 61.1% of the total droplets generated were smaller than 2 µm.