IGSF3 is a homophilic cell adhesion molecule that drives lung metastasis of melanoma by promoting adhesion to vascular endothelium.

The immunoglobulin superfamily (IgSF) is one of the largest families of cell-surface molecules involved in various cell-cell interactions, including cancer-stromal interactions. In this study, we undertook a comprehensive RT-PCR-based screening for IgSF molecules that promote experimental lung metastasis in mice. By comparing the expression of 325 genes encoding cell-surface IgSF molecules between mouse melanoma B16 cells and its highly metastatic subline, B16F10 cells, we found that expression of the immunoglobulin superfamily member 3 gene (Igsf3) was significantly enhanced in B16F10 cells than in B16 cells. Knockdown of Igsf3 in B16F10 cells significantly reduced lung metastasis following intravenous injection into C57BL/6 mice. IGSF3 promoted adhesion of B16F10 cells to vascular endothelial cells and functioned as a homophilic cell adhesion molecule between B16F10 cells and vascular endothelial cells. Notably, the knockdown of IGSF3 in either B16F10 cells or vascular endothelial cells suppressed the transendothelial migration of B16F10 cells. Moreover, IGSF3 knockdown suppressed the extravasation of B16F10 cells into the lungs after intravenous injection. These results suggest that IGSF3 promotes the metastatic potential of B16F10 cells in the lungs by facilitating their adhesion to vascular endothelial cells.

Trans-homophilic interaction of CADM1 promotes organ infiltration of T-cell lymphoma by adhesion to vascular endothelium.

The initial step of organ infiltration of malignant cells is the interaction with host vascular endothelial cells, which is often mediated by specific combinations of cell adhesion molecules. Cell adhesion molecule 1 (CADM1) is overexpressed in adult T-cell leukemia/lymphoma (ATL) and provides a cell-surface diagnostic marker. CADM1 promotes the adhesion of ATL cells to vascular endothelial cells and multiple organ infiltration in mice. However, its binding partner on host cells has not yet been identified. In this study, we show that CADM1 promotes transendothelial migration of ATL cells in addition to the adhesion to vascular endothelial cells. Moreover, CADM1 enhances liver infiltration of mouse T-cell lymphoma cells, EL4, after tail vein injection, whereas a CADM1 mutant lacking adhesive activity did not. Among the known CADM1-binding proteins expressed in primary endothelial cells, only CADM1 and CADM4 could induce morphological extension of ATL cells when plated onto glass coated with these proteins. Furthermore, CADM1-mediated liver infiltration of EL4 cells was canceled in conventional and vascular endothelium-specific Cadm1 knockout mice, whereas it was not canceled in Cadm4 knockout mice. These results suggest that CADM1 on host vascular endothelial cells is required for organ infiltration of ATL and other T-cell lymphomas expressing CADM1.

In-situ catalytic upgrading of bio-oil from rapid pyrolysis of biomass over hollow HZSM-5 with mesoporous shell.

To solve the issue of narrow micropores in traditional protonic type Zeolite Socony Mobil-5 (HZSM-5) catalysts in the restricting of large-molecular reactants/products diffusion, hollow HZSM-5 with a mesoporous shell was prepared using a hydrothermal method combined with a tetrapropylammonium hydroxide (TPAOH) treatment process. Applying for in-situ catalyst upgrading of bio-oil from rapid pyrolysis of biomass, the obtained most efficient catalyst of Hollow(30)-TP resulted in aromatic hydrocarbon yields in the range of 78.49-78.67% for cellulose and hemicellulose, which is much greater than those using the traditional HZSM-5 (61.06-68.26%). Furthermore, in the case using real biomass (cedar) with an optimal biomass/catalyst weight ratio of 1:2, the aromatic hydrocarbon yield reached up to 80.16%. In addition, this catalyst exhibited excellent reusability and regeneration property due to the increased accessibility to the acid sites in the hollow HZSM-5 for the improving of the reaction rate as well as the reducing of coking.

Hydrogen-rich gas production from steam co-gasification of banana peel with agricultural residues and woody biomass.

Steam co-gasification of banana peel with other biomass, i.e., Japanese cedar wood, rice husk and their mixture, was carried out for the hydrogen-rich gas production in a fixed-bed reactor. For the co-gasification process, the banana peels were physically mixed with rice husk, Japanese cedarwood and their mixture respectively by different mixing weight ratios. The effects of reaction temperature and the addition amount of banana peel on the gas production yield were investigated by comparing the experimental data with the calculated ones based on the individual biomass gasification at the same condition. It was found that the banana peel with a high content of alkali and alkaline earth metal (AAEM) species exhibited not only high gasification reactivity but also a significant enhancing catalytic effect on the co-gasification process at the low temperature, especially with the biomass containing no silica species. The high content of silica species in the rice husk had a negative effect on the gasification reactivity of banana peel during the co-gasification since it could hinder the release of AAEM from the biomass and/or lead to the possible formation of inactive alkaline silicates. However, the combination of these three samples with the suitable weight ratio could improve the gasification performance at the low temperature due to the synergetic effect provided by high contents of potassium and calcium from banana peel and cedarwood respectively. Moreover, the addition of calcined seashells as the CaO source could further improve the gas production yield, especially the hydrogen gas yield at a relatively low gasification temperature of 750 ℃.

Quantitative Analysis of Interaction Between CADM1 and Its Binding Cell-Surface Proteins Using Surface Plasmon Resonance Imaging.

The cell adhesion molecule (CADM) family of the immunoglobulin superfamily (IgSF) comprises four members, CADM1-CADM4, and participates in the formation of epithelial and synaptic adhesion through cell-cell homophilic and heterophilic interactions. To identify the partners that interact with each member of the CADM family proteins, we set up a platform for multiple detection of the extracellular protein-protein interactions using surface plasmon resonance imaging (SPRi) and analyzed the interactions between the CADM family proteins and 10 IgSF of their structurally related cell adhesion molecules. SPRi analysis identified a new interaction between CADM1 and CADM4, where this heterophilic interaction was shown to be involved in morphological spreading of adult T-cell leukemia (ATL) cells expressing CADM1 when incubated on CADM4-coated glass. Moreover, class-I MHC-restricted T-cell-associated molecule (CRTAM) was identified to show the highest affinity to CADM1 among its binding partners by comparing the dissociation constants calculated from the SPR sensorgrams. These results suggest that the SPRi platform would provide a novel screening tool to characterize extracellular protein-protein interactions among cell-surface and secreted proteins, including IgSF molecules.

Steam reforming of tar derived from lignin over pompom-like potassium-promoted iron-based catalysts formed on calcined scallop shell.

In order to understand the improvement effect of potassium (K) on the catalytic activity of iron-loaded calcined scallop shell (CS) for the steam reforming tar derived from biomass, various K precursors were applied for the catalyst preparation. It is found that pompom-like iron-based particles with a mesoporous structure were easily formed on the surface of calcined scallop shell (CS) when K2CO3 was used as K precursor while no such kind of microsphere was formed when other kinds of K precursors such as KOH and KNO3 were applied. The optimum K-loading amount for the preparation of this catalyst was investigated. Based on the experimental results obtained, a mechanism for the formation of these microspheres was proposed. This pompom-like potassium-promoted iron-based catalyst showed a better catalytic activity and reusability for the steam reforming of tar derived from lignin.

High production volume chemical amine oxides [C8-C20] category environmental risk assessment.

An environmental assessment of amine oxides has been conducted under the OECD SIDS High Production Volume (HPV) Program via the Global International Council of Chemical Associations (ICCA) Amine Oxides Consortium. Amine oxides are primarily used in conjunction with surfactants in cleaning and personal care products. Given the lack of persistence or bioaccumulation, and the low likelihood of these chemicals partitioning to soil, the focus of the environmental assessment is on the aquatic environment. In the United States, the E-FAST model is used to estimate effluent concentrations in the United States from manufacturing facilities and from municipal facilities resulting from consumer product uses. Reasonable worst-case ratios of predicted environmental concentration (PEC) to predicted no effect concentration (PNEC) range from 0.04 to 0.003, demonstrating that these chemicals are a low risk to the environment.

Human health risk assessment of long chain alcohols.

Representative chemicals from the long chain alcohols category have been extensively tested to define their toxicological hazard properties. These chemicals show low acute and repeat dose toxicity with high-dose effects (if any) related to minimal liver toxicity. These chemicals do not show evidence of activity in genetic toxicity tests or to the reproductive system or the developing organism. These chemicals also are not sensitizers. Irritation is dependant on chain length; generally, alcohols in the range C(6-)C(11) are considered as irritant, intermediate chain lengths (C(12-)C(16)) alcohols are considered to be mild irritants and chain lengths of C(18) and above are considered non-irritants. These chemicals are broadly used across the consumer products industry with highest per person consumer exposures resulting from use in personal care products. Margins of exposure adequate for the protection of human health are documented for the uses of these chemicals.

Environmental properties of long chain alcohols. Part 1: Physicochemical, environmental fate and acute aquatic toxicity properties.

This paper summarises the physicochemical, biodegradation and acute aquatic ecotoxicity properties of long chain aliphatic alcohols. Properties of pure compounds are shown to follow somewhat predictable trends, which are amenable to estimation by quantitative structure-activity relationships ((Q)SARs). This allows predictions of data relating to human and environmental safety profiles and patterns. These alcohols have been shown to be rapidly degradable under standard conditions up to C(18). Furthermore, evidence suggests that longer chain lengths are also rapidly biodegradable. While logK(ow) values suggest possible bioaccumulation potential, available data suggest that these substances are not as bioaccumulative as estimations would predict. For acute aquatic toxicity, solubility limits the possibility of effects being appropriately observed and become increasingly challenging above C(12). Further, a model has been developed for multi-component mixtures which give an excellent account of aquatic ecotoxicity allowing for the prediction of acute effects of un-tested mixtures.

An overview of hazard and risk assessment of the OECD high production volume chemical category--long chain alcohols [C(6)-C(22)] (LCOH).

This review summarizes the findings of the assessment report for the category, long chain alcohols (LCOH) with a carbon chain length range of C(6)-C(22) covering 30 substances, and >1.5million tonnes/year consumed globally. The category was evaluated under the Organization for Economic Co-operation and Development (OECD) high production volume chemicals program in 2006. The main findings of the assessment include: (1) no unacceptable human or environmental risks were identified; (2) these materials are rapidly and readily biodegradable; (3) a parabolic relationship was demonstrated between carbon chain length and acute and chronic aquatic toxicity; (4) category-specific (quantitative) structure-activity relationships were developed enabling prediction of properties across the entire category; (5) LCOH occur naturally in the environment in an equilibrium between synthesis and degradation; (6) industry coming together and sharing resources results in minimizing the need for additional animal tests, produces cost savings, and increases scientific quality of the assessment.