RESUMO
We introduce a novel method for fabricating perovskite solar modules using selective spin-coating on various Au/ITO patterned substrates. These patterns were engineered for two purposes: (1) to enhance selectivity of monolayers primarily self-assembling on the Au electrode, and (2) to enable seamless interconnection between cells through direct contact of the top electrode and the hydrophobic Au connection electrode. Utilizing SAMs-treated Au/ITO, we achieved sequential selective deposition of the electron transport layer (ETL) and the perovskite layer on the hydrophilic amino-terminated ITO, while the hole transport layer (HTL) was deposited on the hydrophobic CH3-terminated Au connection electrodes. Importantly, our approach had a negligible impact on the series resistance of the solar cells, as evidenced by the measured specific contact resistivity of the multilayers. A significant outcome was the production of a six-cell series-connected solar module with a notable average PCE of 8.32%, providing a viable alternative to the conventional laser scribing technique.
RESUMO
In this study, we explore how the strategic positioning of conductive yarns influences the performance of plated knit strain sensors fabricated using commercial knitting machines with both conductive and non-conductive yarns. Our study reveals that sensors with conductive yarns located at the rear, referred to as 'purl plated sensors', exhibit superior performance in comparison to those with conductive yarns at the front, or 'knit plated sensors'. Specifically, purl plated sensors demonstrate a higher sensitivity, evidenced by a gauge factor ranging from 3 to 18, and a minimized strain delay, indicated by a 1% strain in their electromechanical response. To elucidate the mechanisms behind these observations, we developed an equivalent circuit model. This model examines the role of contact resistance within varying yarn configurations on the sensors' sensitivity, highlighting the critical influence of contact resistance in conductive yarns subjected to wale-wise stretching on sensor responsiveness. Furthermore, our findings illustrate that the purl plated sensors benefit from the vertical movement of non-conductive yarns, which promotes enhanced contact between adjacent conductive yarns, thereby improving both the stability and sensitivity of the sensors. The practicality of these sensors is confirmed through bending cycle tests with an in situ monitoring system, showcasing the purl plated sensors' exceptional reproducibility, with a standard deviation of 0.015 across 1000 cycles, and their superior sensitivity, making them ideal for wearable devices designed for real-time joint movement monitoring. This research highlights the critical importance of conductive yarn placement in sensor efficacy, providing valuable guidance for crafting advanced textile-based strain sensors.
RESUMO
Si-based anodes for Li-ion batteries (LIBs) are considered to be an attractive alternative to graphite due to their higher capacity, but they have low electrical conductivity and degrade mechanically during cycling. In the current study, we report on a mass-producible porous Si-CoSi2-C composite as a high-capacity anode material for LIBs. The composite was synthesized with two-step milling followed by a simple chemical etching process. The material conversion and porous structure were characterized by X-ray diffraction, X-ray photoelectron spectroscopy, and electron microscopy. The electrochemical test results demonstrated that the Si-CoSi2-C composite electrode exhibits greatly improved cycle and rate performance compared with conventional Si-C composite electrodes. These results can be ascribed to the role of CoSi2 and inside pores. The CoSi2 synthesized in situ during high-energy mechanical milling can be well attached to the Si; its conductive phase can increase electrical connection with the carbon matrix and the Cu current collectors; and it can accommodate Si volume changes during cycling. The proposed synthesis strategy can provide a facile and cost-effective method to produce Si-based materials for commercial LIB anodes.