Wireless excitation of quartz crystals immersed in an aqueous fluid.

A novel toroidal coil geometry able to induce remote acoustic waves in quartz crystals has been evaluated for the development of (bio)sensors. Remote acoustic generation in air was obtained for two alternative toroidal coils, with corresponding electrical impedance changes of 40 Omega for a PDMS- and 140 Omega for a ferrite-supported toroid respectively. It was found that the range of remote acoustic generation relative to the spiral coil standard was much improved, increasing the axial separation of their resonant sensing element from 0.1 mm to 20 mm, thereby allowing electromagnetic wave penetration across glass walls and fluid media to be utilised. Consideration of the transduction mechanism, along with measured cyclic changes in acoustic signal as a function of rotation, indicated that the large PDMS toroidal coil produced an asymmetric electric field. It was shown for the first time that a quartz crystal blank fully immersed in an aqueous fluid could support chemically sensitive shear acoustic standing waves that were excited and detected remotely. A signal to noise ratio of 30 ratio 1 at 20.13 MHz was achieved by placing a ferrite supported toroidal coil on the lower side of a glass beaker containing a 12 x 0.25 mm AT crystal blank and 1 mL of water. This discovery allows wireless shear acoustic wave measurements to be performed with total separation between the electronic detection system and assays undertaken in fluidic systems.

Planar coil excitation of multifrequency shear wave transducers.

A transducer format that replaces the electrode of an acoustic resonator with a planar spiral coil is used to extract multifrequency spectral information from adsorbed protein films. Both amorphous silica and crystalline piezoelectric resonators are driven to resonance by forces induced across an air gap by magnetic direct generation and piezoelectric excitation induced by the electromagnetic field of the coil. Inspection of the harmonic frequencies between 6 MHz and 0.6 GHz indicates that the response of these two resonator types is described by different families of shear acoustic standing waves, with similar acoustic features to the quartz crystal microbalance. Exposure of the devices to protein solutions results in reproducible shifts of their harmonic frequencies, up to a maximum of 15 kHz and increasing linearly with frequency and operating mode. The gradient, determined from the ratio of the frequency change to the operating frequency was determined as 21.5 x 10(-6) for the quartz device and 60.9 x 10(-6) for the silica device. Consistency with the Sauerbrey equation for the piezoelectric linear shear mode was comparable at a predicted value of 22.5 x 10(-6), but not for the radial shear mode of the silica device at 12.7 x 10(-6). Opportunities resulting from the wide bandwidth of the planar coil excitation and choice of acoustic mode are discussed with respect to acoustic fingerprinting of adsorbed proteins.

The application of the acoustic spectrophonometer to biomolecular spectrometry: a step towards acoustic "fingerprinting".

A tunable acoustic biosensor for investigating the properties of biomolecules at the solid-liquid interfaces is described. In its current, format the device can be tuned to frequencies between 6.5 MHz and 1.1 GHz in order to provide a unique detection feature: a variable evanescent wave thickness at the sensor surface. The key to its successful implementation required the careful selection of antennae designs that could induce shear acoustic waves at the solid-liquid interface. This non-contact format makes it possible to recover resonant shear acoustic waves over 100 different harmonic frequencies as a result of the electrical characteristics of the spiral coil. For testing this multifrequency sensing concept the surface of a quartz disc was exposed to solutions of immunoglobulin G (IgG) to form an adsorbed monolayer, whence protein A and IgG were added again in order to form multilayers. Spectra at frequencies between 6 and 600 MHz were generated for each successive layer and revealed two characteristic phases: an initial phase at the low megahertz frequencies consistent with the conventional Sauerbrey relation, and a possible additional phase towards the high megahertz to gigahertz frequencies, that we believe relates to the structure of the biomolecular film. This two-phase behaviour evident from differences between high and low frequencies, rather than from any distinct frequency transition, was anticipated from the reduction in evanescent wave thickness down to nanometre dimensions, and thin film resonance phenomena that are known to occur for film and fluid systems. These measurements suggested that the single element acoustic biosensor we present here may form the basis from which to generate acoustic molecular spectra, or "acoustic fingerprints", in a manner akin to optical spectroscopy.

The acoustic spectrophonometer: a novel bioanalytical technique based on multifrequency acoustic devices.

A measurement technique similar to optical absorption spectroscopy but based on evanescent acoustic waves is described in this paper. This format employs a planar spiral coil to vibrate a single crystal of quartz from 6 to 400 MHz, in order to measure multifrequency acoustic spectra. Consistency with the defined Sauerbrey and Kanazawa terms K1 and K2 when applied to multiple frequencies was found for these specific operating conditions in terms of a significant fit between the measured and calculated values: For an IgG surface density of 13.5 ng mm(-2) the measured value of K1 is 22.5 x 10(-6) and the calculated value is 20.4 x 10(-6), whilst for glycerol viscous loadings of 5.131 cP the measured value of K2 is 0.47 and the calculated value is 0.54. Thus for these specific surface loadings the multifrequency data fits to the predictions of the Sauerbrey model to within 10% and to Kanazawa model within 13%. However collective frequency shifts for 5.131 cP solutions of sucrose, dextran and glucose were found to exhibit an unanticipated additional variability (R2 < 0.4) with frequency, but retained a square root of frequency dependency within a factor 2 of the interpolated K2 values. The response to the 5.131 cP dextran solution was found to be significantly below the other isoviscous solutions, with a substantially reduced frequency shift and K2 value than would be expected from its bulk viscosity. In comparison with these viscous solutions, IgG protein films consistently produced linear frequency shifts with little scatter (R2 > 0.96) that were proportional to the operating frequency, and fully consistent with the Sauerbrey model under these specific conditions. A t-test value of 14.52 was calculated from the variance and mean of the two groups, and demonstrates that the acoustic spectrophonometer can be used to distinguish between the acoustic impedance characteristics of two chemical systems that are not clearly differentiable at a single operating frequency.

Hypersonic evanescent waves generated with a planar spiral coil.

A planar spiral coil has been used to induce hypersonic evanescent waves in a quartz substrate with the unique ability to focus the acoustic wave down onto the chemical recognition layer. These special sensing conditions were achieved by investigating the application of a radio frequency current to a coaxial waveguide and spiral coil, so that wideband repeating electrical resonance conditions could be established over the MHz to GHz frequency range. At a selected operating frequency of 1.09 GHz, the evanescent wave depth of a quartz crystal hypersonic resonance is reduced to 17 nm, minimising unwanted coupling to the bulk fluid. Verification of the validity of the hypersonic resonance was carried out by characterising the system electrically and acoustically: Impedance calculations of the combined coil and coaxial waveguide demonstrated an excellent fit to the measured data, although above 400 MHz a transition zone was identified where unwanted impedance is parasitic of the coil influence efficiency, so the signal-to-noise ratio is reduced from 3000 to 300. Acoustic quartz crystal resonances at intervals of precisely 13.2138 MHz spacing, from the 6.6 MHz ultrasonic range and onto the desired hypersonic range above 1 GHz, were incrementally detected. Q factor measurements demonstrated that reductions in energy lost from the resonator to the fluid interface were consistent with the anticipated shrinkage of the evanescent wave with increasing operating frequency. Amplitude and frequency reduction in contact with a glucose solution was demonstrated at 1.09 GHz. The complex physical conditions arising at the solid-liquid interface under hypersonic entrainment are discussed with respect to acceleration induced slippage, rupture, longitudinal and shear radiation and multiphase relaxation affects.

[Evaluation of the use of an environmental medicine consulting center]. / Auswertung der Inanspruchnahme einer umweltmedizinischen Beratungsstelle.

At the Environmental Medical Consulting Centre 1677 consultations were carried out in 1991. The centre is established at the Medical Institute of Environmental Hygiene in Düsseldorf. There were 1129 (68%) short questions and 309 (18%) detailed consultations by phone or by letter. The most of the questions were asked by the general population. Other questions came from people at health offices, from general practitioners and from hospitals. No detail information about some socio-demographic data of this group was taken. The overwhelming topics of the questions were toxicological problems of harmful substances in indoor air or about the use of some products containing harmful substances. 239 (14%) people of the whole group got an appointment for a detailed medical consultation. Only data from 158 patients--visiting the office during January and September 1991--were evaluated in detail. On average the patients examined were 40 years old and mostly with a higher school degree. The most of the people complained about permanent polysomatic symptoms. A defined exposure was diagnosed for 31 (20%) patients, which resulted from pollution at work, at home or from the environment. The term Sick-Building-Syndrome were used for further 16 (10%) patients. In conclusion, the results of the study reveal a need of consultation with a specific orientation in Environmental Medicine. But, because of lack of data from other consulting offices in order to compare the results, no quantification of the need could be estimated.