Testing of Novel Total Elbow Prostheses Using Active Motion Experimental Setup.

PURPOSE: The goal of this study was to test a novel uncemented and unconstrained total elbow arthroplasty (Kaufmann total elbow) design that is stabilized through a ligament reconstruction. METHODS: We quantified the implant stability after 25,000 cycles, which represents the time between implantation and when ligament and bone healing has occurred. We used an active motion experimental setup that applies tendon loads via pneumatic cylinders and reproduces the forearm-originating dynamic stabilizers of the elbow. The novel total elbow arthroplasty was actuated for 5,000 full flexion-extension cycles at 5 different shoulder positions. Four Sawbones and 4 cadaver elbows were employed. Angular laxity and implant stability were recorded prior to testing and after each 5,000-loading cycle. RESULTS: Four Sawbones and 4 cadaver elbows were implanted with the uncemented total elbow arthroplasty and did not demonstrate fixation failure or substantial laxity after 25,000 cycles of loading imparted at different shoulder positions. CONCLUSIONS: Our findings demonstrate that the Kaufmann total elbow replacement implanted into cadaver and Sawbones specimens did not exhibit fixation failure or excessive laxity after 25,000 cycles. CLINICAL RELEVANCE: An uncemented, nonmechanically linked total elbow arthroplasty that gains component fixation using intramedullary screws and employs a ligament reconstruction to stabilize the elbow has the potential to be a valuable management option, particularly in younger patients.

Strength of Humeral and Ulnar Intramedullary Screw Fixation.

PURPOSE: The goal of this study was to test the pullout strength of intramedullary (IM) screws from within the humerus to establish their ability to seat an uncemented elbow arthroplasty. METHODS: Six humerus and 6 ulna Sawbones specimens were drilled with a drill bit diameter of 5/16 inches, and the inner cortex was hand tapped for a ⅜-16 thread. A ⅜-16 custom-made titanium screw with an outer bolt diameter of 3/8 inches and 16 threads per inch was inserted by hand into the tapped holes. The specimens were then axially tensile loaded at a rate of 5 mm per minute until either the screw began to pull out from the bone or a fracture was noted. RESULTS: Intramedullary screw fixation in the humerus achieved an average pullout strength of 1,439 pound-force (6,401 N), and IM screw fixation in the ulna achieved an average pullout strength of 882 pound-force (3,923 N). A fracture was noted in 3 humeral specimens, with 3 screws pulling out. In the ulna, the IM axial load caused a fracture in 5 specimens, and in 1 specimen, the screw pulled out. CONCLUSIONS: Our findings demonstrate that IM screw fixation can create a tensile force within the screw that is greater than that required to generate the calculated level of compression between the implant and bone. CLINICAL RELEVANCE: This may be beneficial in ensuring fixation between arthroplasty components and bone.