RESUMO
Imidacloprid is still a widely used neonicotinoid insecticide that is banned in many countries because of the associated environmental risks. Due to the inefficiency of conventional wastewater treatments for pesticide removal, new treatment methods are being investigated. Electrochemical methods, including electrocoagulation (EC), seem to be promising alternatives considering their effectiveness in removing various pollutants from wastewater. The aim of this study was to investigate the effects of electrode material, current density, ultrasound, and operation time on the efficiency of imidacloprid removal from a model solution by EC. The combination of aluminum electrodes and 20 A of applied current for 20 min resulted in total imidacloprid degradation. A simplified energy balance was introduced as a form of process evaluation. Combining ultrasound with EC resulted in 7% to 12% greater efficacy than using only EC.
Assuntos
Nitrocompostos , Praguicidas , Poluentes Químicos da Água , Águas Residuárias , Eliminação de Resíduos Líquidos/métodos , Neonicotinoides , Eletrocoagulação , Eletrodos , AlumínioRESUMO
Due to its high solubility in water, a large amount of the neonicotinoid insecticide acetamiprid persisting in the soil of treated crops enters surface water or groundwater. The aim of this study was to investigate the photocatalytic degradation of acetamiprid in an aqueous medium. The experiments were carried out in an annular suspension reactor operating in recirculated batch mode and using a UV-A lamp as the radiation source. An appropriate modification of the commercial TiO2-P25 photocatalyst was carried out to reduce its band gap energy and electron-hole recombination as well as to extend the visible light range of TiO2. The photodegradation study was carried out using a three-factor two-stage Box-Behnken experimental design to investigate the main effects and interactions between the operating variables, such as solution pH, initial concentration of acetamiprid, and amount of photocatalyst. The efficiency of the processes was determined by high performance liquid chromatography. The first-order pseudo-reaction kinetic model, as a simplification of the models of Langmuir-Hinshelwood under conditions of relatively low acetamiprid concentration, was applied and the reaction rate constants were estimated. The results of the study showed that the initial concentration of the pollutant was the most influential factor for the photocatalytic degradation process. Using ANOVA analysis, a linear model was established to predict the system behaviour at different operating conditions. The highest conversion and rate constant of acetamiprid degradation were recorded in the experiment with the lowest tested concentration of acetamiprid (2â mg/L), the average concentration of photocatalyst (60â mg) and at pH 8.