RESUMO
High-intensity (â¼1 TW/cm2 and higher) region formed in the propagation of â¼60 GW, 90 fs Ti:Sapphire laser pulse on a â¼100 m path in air spans for several tens of meters and includes a plasma filament and a postfilament light channel. The intensity in this extended region is high enough to generate an infrared supercontinuum wing and to initiate laser-induced discharge in the gap between the electrodes. In the experiment and simulations, we delay the high-intensity region along the propagation direction by inserting metal-wire meshes with square cells at the laser system output. We identify the presence of a high-intensity region from the clean-spatial-mode distributions, appearance of the infrared supercontinuum wing, and occurrence of the laser-induced discharge. In the case of free propagation (without any meshes), the onset of the high-intensity zone is at 40-52 m from the laser system output with â¼30 m extension. Insertion of the mesh with 3 mm cells delays the beginning of the high-intensity region to 49-68 m with the same â¼30 m extension. A decrease in the cell size to 1 mm leads to both delay and shrinking of the high-intensity zone to 71-73 m and 6 m, respectively. Three-dimensional simulations in space confirm the mesh-induced delay of the high-intensity zone as the cell size decreases.
RESUMO
By rotating the four-section π-shifted phase plate in the transverse plane relatively to the axes of the elliptical beam of 800-nm, 1.1-mJ, 35-fs pulse propagating in air, we switch between the regime of four parallel plasma channels and the regime of spatial symmetry breakup followed by on-axis plasma channel formation identified on the burnt paper images of the beam. Relaxation of the π-phase shift for 45° phase plate rotation is demonstrated explicitly in 3D+time carrier wave resolved numerical simulations yielding the initial step-like phase distribution degradation along the plasma region. This degradation becomes negligible as the angle between the ellipse major axis and the π-phase break line decreases to 15°.
RESUMO
We developed a model of femtosecond filamentation which includes high-order Kerr effect and an arbitrary polarization of a laser pulse. We show that a circularly polarized pulse has maximum filament intensity. Also, we show that, independently of the initial pulse polarization, the value of a maximum filament intensity tends to the maximum intensity of either linearly or circularly polarized pulse.