RESUMO
Pyrolysis of nitrogen containing biofuels generates isocyanic acid (ICA) and we here studied if ICA also is present in cauterization smoke. Air sampling was performed when animal technicians that had developed airway symptoms worked with dehorning. Tissue heated in a laboratory model was used to mimic cauterization. ICA in air at the workplace exceeded 10 times the national exposure limit. In the laboratory, the ICA generated per mg tissue from heated hair, horn and nail was 13.9 ± 7.8, 24.0 ± 4.1 and 32.0 ± 2.9 µg, respectively. Three workers were medically examined and two were diagnosed with asthma and a third had severe airway problem that resembled asthma. The study shows that high levels of ICA are generated during cauterization of nitrogen-containing tissue. If this could trigger airway symptoms deserves to be investigated further.
Assuntos
Cauterização/veterinária , Cianatos/análise , Fumaça/efeitos adversos , Fumaça/análise , Poluição do Ar/efeitos adversos , Poluição do Ar/análise , Animais , Asma , HumanosRESUMO
BACKGROUND: Additive manufacturing (AM) is a rapidly expanding new technology involving challenges to occupational health. Here, metal exposure in an AM facility with large-scale metallic component production was investigated during two consecutive years with preventive actions in between. METHODS: Gravimetric analyzes measured airborne particle concentrations, and filters were analyzed for metal content. In addition, concentrations of airborne particles <300 nm were investigated. Particles from recycled powder were characterized. Biomonitoring of urine and dermal contamination among AM operators, office personnel, and welders was performed. RESULTS: Total and inhalable dust levels were almost all below occupational exposure limits, but inductively coupled plasma mass spectrometry showed that AM operators had a significant increase in cobalt exposure compared with welders. Airborne particle concentrations (<300 nm) showed transient peaks in the AM facility but were lower than those of the welding facility. Particle characterization of recycled powder showed fragmentation and condensates enriched in volatile metals. Biomonitoring showed a nonsignificant increase in the level of metals in urine in AM operators. Dermal cobalt and a trend for increasing urine metals during Workweek Year 1, but not in Year 2, indicated reduced exposure after preventive actions. CONCLUSION: Gravimetric analyses showed low total and inhalable dust exposure in AM operators. However, transient emission of smaller particles constitutes exposure risks. Preventive actions implemented by the company reduced the workers' metal exposure despite unchanged emissions of particles, indicating a need for careful design and regulation of the AM environments. It also emphasizes the need for relevant exposure markers and biomonitoring of health risks.