Ambient exposure to fine particulate matter with oxidative potential affects oxidative stress biomarkers in pregnancy.

Prenatal exposures to ambient particulate matter (PM2.5) from traffic may generate oxidative stress, and thus contribute to adverse birth outcomes. We investigated whether PM2.5 constituents from brake and tire wear affect levels of oxidative stress biomarkers (malondialdehyde (MDA), 8-hydroxy-2'-deoxyguanosine (8-OHdG)) using urine samples collected up to three times during pregnancy in 156 women recruited from antenatal clinics at the University of California Los Angeles. Land use regression models with co-kriging were employed to estimate average residential outdoor concentrations of black carbon (BC), PM2.5 mass, PM2.5 metal components, and three PM2.5 oxidative potential metrics during the 4-weeks prior to urine sample collection. 8-OHdG concentrations in mid-pregnancy increased by 24.8% (95% CI: 9.0, 42.8) and 14.3% (95% CI: 0.4%, 30.0%) per interquartile range (IQR) increase in PM2.5 mass and BC, respectively. The brake wear marker (barium) and the oxidative potential metrics were associated with increased MDA concentration in the 1st sample collected (10-17 gestational week), but 95% CIs included the null. Traffic-related air pollution contributed in early to mid-pregnancy to oxidative stress generation previously linked to adverse birth outcomes.

Ozone Loss on Painted Surfaces: Dependence on Relative Humidity, Aging, and Exposure to Reactive SVOCs.

Ozone and its oxidation products result in negative health effects when inhaled. Despite painted surfaces being the most abundant surface in indoor spaces, surface loss remains one of the largest uncertainties in the indoor ozone budget. Here, ozone uptake coefficients (γO3) on painted surfaces were measured in a flow-through reactor where 79% of the inner surfaces were removable painted glass sheets. Flat white paint initially had a high uptake coefficient (8.3 × 10-6) at 20% RH which plateaued to 1.1 × 10-6 as the paint aged in an indoor office over weeks. Increasing the RH from 0 to 75% increased γO3 by a factor of 3.0, and exposure to 134 ppb of α-terpineol for 1 h increased γO3 by a factor of 1.6 at 20% RH. RH also increases α-terpineol partitioning to paint, further increasing ozone loss, but the type of paint (flat, eggshell, satin, semigloss) had no significant effect. A kinetic multilayer model captures the dependence of γO3 on RH and the presence of α-terpineol, indicating the reacto-diffusive depth for O3 is 1 to 2 µm. Given the similarity of the kinetics on aged surfaces across many paint types and the sustained reactivity during aging, these results suggest a mechanism for catalytic loss.

Composition of indoor organic surface films in residences: simulating the influence of sources, partitioning, particle deposition, and air exchange.

Indoor surfaces are coated with organic films that modulate thermodynamic interactions between the surfaces and room air. Recently published models can simulate film formation and growth via gas-surface partitioning, but none have statistically investigated film composition. The Indoor Model of Aerosols, Gases, Emissions, and Surfaces (IMAGES) was used here to simulate ten years of nonreactive film growth upon impervious indoor surfaces within a Monte Carlo procedure representing a sub-set of North American residential buildings. Film composition was resolved into categories reflecting indoor aerosol (gas + particle phases) factors from three sources: outdoor-originating, indoor-emitted, and indoor-generated secondary organic material. In addition to gas-to-film partitioning, particle deposition was modeled as a vector for organics to enter films, and it was responsible for a majority of the film mass after ∼1000 days of growth for the median simulation and is likely the main source of LVOCs within films. Therefore, the organic aerosol factor possessing the most SVOCs contributes most strongly to the composition of early films, but as the film ages, films become more dominated by the factor with the highest particle concentration. Indoor-emitted organics (e.g. from cooking) often constituted at least a plurality of the simulated mass in developed films, but indoor environments are diverse enough that any major organic material source could be the majority contributor to film mass, depending on building characteristics and indoor activities. A sensitivity analysis suggests that rapid film growth is most likely in both newer, more air-tight homes and older homes near primary pollution sources.