RESUMO
Methylene blue (MB) is a prevalent pollutant in organic wastewater. For this research, eucalyptus wood was used as a template, into which quartz powder dissolved in NaOH was grown, resulting in a low-cost and efficient porous silica adsorbent material (PSAM). This PSAM successfully replaces expensive materials for MB removal from water. Through the application of Scanning Electron Microscopy (SEM) and Brunauer-Emmett-Teller (BET) analysis, it became evident that PSAM displays a porous slit pore structure characterized by numerous active sites, leading to an impressive maximum specific surface area of 88.05â m²/g. The central objective of this research was to investigate the impact of experimental temperature, initial dye concentration, and pH on the adsorption process. The adsorption kinetics were analyzed using the pseudo-first-order and pseudo-second-order models, as well as the Langmuir model. Remarkably, PSAM exhibited a substantial maximum adsorption capacity of 90.01â mg/g at 293â K, achieving an adsorption rate of over 85% within a mere 10-minute timeframe. The thermodynamic analysis revealed that the adsorption of MB onto PSAM was characterized by spontaneity and accompanied by heat absorption. Fourier Transform Infrared (FTIR) and SEM comparisons of PSAM before and after adsorption indicated that MB adsorption primarily occurred through electrostatic gravitational binding. In comparison to other adsorbents, PSAM exhibited exceptional efficacy in removing MB from water.
RESUMO
Materials with a high density of heterophase interfaces, which are capable of absorbing and annihilating radiation-induced point defects, can exhibit a superior radiation tolerance. In this paper, we investigated the interaction behaviors of point defects and heterophase interfaces by implanting helium atoms into the ZrN/TaN multilayered nanofilms. It was found that the point defect-interface interaction on the two sides of the ZrN/TaN interface was asymmetric, likely due to the difference in the vacancy formation energies of ZrN and TaN. The helium bubbles could migrate from the ZrN layers into the TaN layers through the heterophase interfaces, resulting in a better crystallinity of the ZrN layers and a complete amorphization of the TaN layers. The findings provided some clues to the fundamental behaviors of point defects near the heterophase interfaces, which make us re-examine the design rules of advanced radiation-tolerant materials.