Composite of methyl polysiloxane and avocado biochar as adsorbent for removal of ciprofloxacin from waters.

Two carbon composite materials were prepared by mixing avocado biochar and methyl polysiloxane (MK). Firstly, MK was dissolved in ethanol, and then the biochar was added at different times. In sample 1 (R1), the time of adding biochar was immediately after dissolving MK in ethanol, and in sample 2 (R2), after 48 h of MK dissolved in ethanol. The samples were characterized by nitrogen adsorption/desorption measurements obtaining specific surface areas (SBET) of 115 m2 g-1 (R1) and 580 m2 g-1 (R2). The adsorbents were further characterized using scanning electron microscopy, FTIR and Raman spectroscopy, adsorption of vapors of n-heptane and water, thermal analysis, Bohem titration, pHpzc, and C H N elemental analysis. R1 and R2 adsorbents were employed as adsorbents to remove the antibiotic ciprofloxacin from the waters. The t1/2 and t0.95 based on the interpolation of Avrami fractional-order were 20.52 and 246.4 min (R1) and 14.00 and 157.6 min (R2), respectively. Maximum adsorption capacities (Qmax) based on the Liu isotherm were 10.77 (R1) and 63.80 mg g-1 (R2) for ciprofloxacin. The thermodynamic studies showed a spontaneous and exothermic process for both samples, and the value of ΔH° is compatible with physical adsorption.

Single-step pyrolysis for producing magnetic activated carbon from tucumã (Astrocaryum aculeatum) seed and nickel(II) chloride and zinc(II) chloride. Application for removal of nicotinamide and propanolol.

The present research describes the synthesis of new nanomagnetic activated carbon material with high magnetization, and high surface area prepared in a single pyrolysis step that is used for the carbonization, activation, and magnetization of the produced material. The pyrolysis step of tucumã seed was carried out in a conventional tubular oven at 600 °C under N2-flow. It was prepared three magnetic carbons MT-1.5, MT-2.0, MT-2.5, that corresponds to the proportion of biomass: ZnCl2 always 1:1 and varying the proportion of NiCl2 of 1.5, 2.0, and 2.5, respectively. These magnetic nanocomposites were characterized by Vibrating Sample Magnetometer (VSM), X-ray diffraction, scanning electron microscopy, thermogravimetric analysis, hydrophobic/hydrophilic balance, CHN/O elemental analysis, modified Boehm titration, N2 adsorption-desorption isotherms; and pHpzc. All the materials obtained presented Ni particles with an average crystallite size of less than 33 nm. The MT-2.0 was employed for the removal of nicotinamide and propranolol from aqueous solutions. Based on Liu isotherm, the Qmax was 199.3 and 335.4 mg g-1 for nicotinamide and propranolol, respectively. MT-2.0 was used to treat simulated pharmaceutical industry effluents attaining removal of all organic compounds attaining up to 99.1 % of removal.

Evaluation of efficiency and selectivity in the sorption process assisted by chemometric approaches: Removal of emerging contaminants from water.

This paper describes, by the first time, a chemometric approach that combines a simple set of the UV-Vis spectra and partial least square regression (PLSR) for measuring the removal of five pharmaceuticals present in simulated hospital effluents by sorption using activated carbon. The use of multivariate calibration allowed the quantification of the remaining concentrations of the studied drugs present in a complex mixture with high accuracy, avoiding the need for the use of sophisticated methodologies based on chromatography. Isothermal sorption studies were performed on single-component solutions containing amoxicillin, paracetamol, propranolol, sodium diclofenac, or tetracycline as well as on a solution containing a mixture of all these 5 compounds. The isotherm data obtained were fitted to the Langmuir, Freundlich and Liu models. It was observed that for each pharmaceutical, the maximum sorption capacity of the activated carbon was higher for the single component than in the mixture. It was observed that the removal of paracetamol, propranolol, and tetracycline, the removal was complete (100%) and for amoxicillin and sodium diclofenac it was at least 92.71 ±â€¯3.15% and 91.82 ±â€¯0.95% respectively, indicating that the avocado seed activated carbon is an adsorbent with high sorption capacity that can remove five pharmaceuticals from simulated hospital effluents.