RESUMO
In this study, we present an efficient approach for the depolymerization of poly(methyl methacrylate) (PMMA) copolymers synthesized via conventional radical polymerization. By incorporating low mol % phthalimide ester-containing monomers during the polymerization process, colorless and transparent polymers closely resembling unfunctionalized PMMA are obtained, which can achieve >95% reversion to methyl methacrylate (MMA). Notably, our catalyst-free bulk depolymerization method exhibits exceptional efficiency, even for high-molecular-weight polymers, including ultrahigh-molecular-weight (106-107 g/mol) PMMA, where near-quantitative depolymerization is achieved. Moreover, this approach yields polymer byproducts of significantly lower molecular weight, distinguishing it from bulk depolymerization methods initiated from chain ends. Furthermore, we extend our investigation to polymethacrylate networks, demonstrating high extents of depolymerization. This innovative depolymerization strategy offers promising opportunities for the development of sustainable polymethacrylate materials, holding great potential for various applications in polymer science.
RESUMO
Alcohol use disorder (AUD) is a significant public health concern and people with AUD are more likely to develop severe acute respiratory distress syndrome (ARDS) in response to respiratory infections. To examine whether AUD was a risk factor for more severe outcome in response to severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) infection, we examined early responses to infection using cultured differentiated bronchial epithelial cells derived from brushings obtained from people with AUD or without AUD. RNA-seq analysis of uninfected cells determined that AUD cells were enriched for expression of epidermal genes as compared with non-AUD cells. Bronchial epithelial cells from patients with AUD showed a significant decrease in barrier function 72 h postinfection, as determined by transepithelial electrical resistance. In contrast, barrier function of non-AUD cells was enhanced 72 h after SARS-CoV-2 infection. AUD cells showed claudin-7 that did not colocalize with zonula occludens-1 (ZO-1), indicative of disorganized tight junctions. However, both AUD and non-AUD cells showed decreased ß-catenin expression following SARS-CoV-2 infection. To determine the impact of AUD on the inflammatory response to SARS-CoV-2 infection, cytokine secretion was measured by multiplex analysis. SARS-CoV-2-infected AUD bronchial cells had enhanced secretion of multiple proinflammatory cytokines including TNFα, IL-1ß, and IFNγ as opposed to non-AUD cells. In contrast, secretion of the barrier-protective cytokines epidermal growth factor (EGF) and granulocyte macrophage-colony stimulating factor (GM-CSF) was enhanced for non-AUD bronchial cells. Taken together, these data support the hypothesis that AUD is a risk factor for COVID-19, where alcohol primes airway epithelial cells for increased inflammation and increased barrier dysfunction and increased inflammation in response to infection by SARS-CoV-2.NEW & NOTEWORTHY Alcohol use disorder (AUD) is a significant risk factor for severe acute respiratory distress syndrome. We found that AUD causes a phenotypic shift in gene expression in human bronchial epithelial cells, enhancing expression of epidermal genes. AUD cells infected with severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) had higher levels of proinflammatory cytokine secretion and barrier dysfunction not present in infected non-AUD cells, consistent with increased early COVID-19 severity due to AUD.
Assuntos
Alcoolismo , COVID-19 , Síndrome do Desconforto Respiratório , Humanos , SARS-CoV-2/metabolismo , Citocinas/metabolismo , InflamaçãoRESUMO
We report the controlled synthesis of ultra-high molecular weight (UHMW) polymers (Mn ≥ 106 g/mol) via continuous flow in a tubular reactor. At high monomer conversion, UHMW polymers in homogeneous batch polymerization exhibit high viscosities that pose challenges for employing continuous flow reactors. However, under heterogeneous inverse miniemulsion (IME) conditions, UHMW polymers can be produced within the dispersed phase, while the viscosity of the heterogeneous mixture remains approximately the same as the viscosity of the continuous phase. Conducting such IME polymerizations in flow results in a faster rate of polymerization compared to batch IME polymerizations while still providing excellent control over molecular weight up to 106 g/mol. Crucial emulsion parameters, such as particle size and stability under continuous flow conditions, were examined using dynamic light scattering. A range of poly(N,N-dimethylacrylamide) and poly(4-acryloylmorpholine) polymers with molecular weights of 104-106 g/mol (D ≤ 1.31) were produced by this method using water-soluble trithiocarbonates as photoiniferters.
RESUMO
Wastewater surveillance has proven to be an effective tool to monitor the transmission and emergence of infectious agents at a community scale. Workflows for wastewater surveillance generally rely on concentration steps to increase the probability of detection of low-abundance targets, but preconcentration can substantially increase the time and cost of analyses while also introducing additional loss of target during processing. To address some of these issues, we conducted a longitudinal study implementing a simplified workflow for SARS-CoV-2 detection from wastewater, using a direct column-based extraction approach. Composite influent wastewater samples were collected weekly for 1 year between June 2020 and June 2021 in Athens-Clarke County, Georgia, USA. Bypassing any concentration step, low volumes (280 µl) of influent wastewater were extracted using a commercial kit, and immediately analyzed by RT-qPCR for the SARS-CoV-2 N1 and N2 gene targets. SARS-CoV-2 viral RNA was detected in 76% (193/254) of influent samples, and the recovery of the surrogate bovine coronavirus was 42% (IQR: 28%, 59%). N1 and N2 assay positivity, viral concentration, and flow-adjusted daily viral load correlated significantly with per-capita case reports of COVID-19 at the county-level (ρ = 0.69-0.82). To compensate for the method's high limit of detection (approximately 106-107 copies l-1 in wastewater), we extracted multiple small-volume replicates of each wastewater sample. With this approach, we detected as few as five cases of COVID-19 per 100 000 individuals. These results indicate that a direct-extraction-based workflow for SARS-CoV-2 wastewater surveillance can provide informative and actionable results.
RESUMO
We report on a fundamental feature of photoiniferter polymerizations mediated with trithiocarbonates and xanthates. The polymerizations were found to be highly dependent on the activated electronic excitation of the iniferter. Enhanced rates of polymerization and greater control over molecular weights were observed for trithiocarbonate- and xanthate-mediated photoiniferter polymerizations when the n â π* transition of the iniferter was targeted compared to the polymerizations activating the π â π* transition. The disparities in rates of polymerization were attributed to the increased rate of C-S photolysis which was confirmed using model trapping studies. This study provides valuable insight into the role of electronic excitations in photoiniferter polymerization and provides guidance when selecting irradiation conditions for applications where light sensitivity is important.
Assuntos
Compostos de Enxofre , Tionas , Polimerização , FotóliseRESUMO
The synthesis, structure, and magnetic properties of three related iron(III)-oxo clusters are reported, [Fe7O3(O2CPh)9(mda)3(H2O)] (1), [Fe22O14(OH)3(O2CMe)21(mda)6](ClO4)2 (2), and [Fe24O15(OH)4(OEt)(O2CMe)21(mda)7](ClO4)2 (3), where mdaH2 is N-methyldiethanolamine. 1 was prepared from the reaction of [Fe3O(O2CPh)6(H2O)3](NO3) with mdaH2 in a 1:2 ratio in MeCN, whereas 2 and 3 were prepared from the reaction of FeCl3/NaO2CMe/mdaH2 in a 2:â¼13:2 ratio and FeCl3/NaO2CMe/mdaH2/pyridine in a 2:â¼13:2:25 ratio, respectively, both in EtOH. The core of 1 consists of a central octahedral FeIII ion held within a nonplanar Fe6 loop by three µ3-O2- and three µ2-RO- arms from the three mda2- chelates. The cores of the cations of 2 and 3 consist of an A:B:A three-layer topology, in which a central Fe6 (2) or Fe8 (3) layer B is sandwiched between two Fe8 layers A. The A layers structurally resemble 1 with the additional Fe added at the center to retain virtual C3 symmetry. The central Fe6 layer B of 2 consists of a {Fe4(µ4-O)2(µ3-OH)2}6+ cubane with an Fe on either side attached to cubane O2- ions, whereas that of 3 has the same cubane but with an {Fe3(µ3-O)(µ-OH)} unit attached on one side and a single Fe on the other. Variable-temperature dc and ac magnetic susceptibility studies revealed dominant antiferromagnetic coupling in all complexes leading to ground-state spins of S = 5/2 for 1 and S = 0 for 2 and 3. All Fe2 pairwise exchange parameters (Jij) for 1-3 were estimated by two independent methods: density functional theory (DFT) calculations using broken symmetry methods and a magnetostructural correlation previously developed for high-nuclearity FeIII/O complexes. The two approaches gave satisfyingly similar Jij values, and the latter allowed rationalization of the experimental ground states by identification of the spin frustration effects operative and the resultant relative spin vector alignments at each FeIII ion.