Stabilization of chloro-organics using organophilic bentonite in a cement-blast furnace slag matrix.

The application of cement-based stabilisation/solidification treatment to organic-containing wastes is made difficult by the adverse effect of organics on cement hydration. The use of organophilic clays as pre-solidification adsorbents of the organic compounds can reduce this problem because of the high adsorption power of these clays and their compatibility with the cementitious matrix. This work presents an investigation of the effect on hydration kinetics, physico-mechanical properties and leaching behaviour of cement-based solidified waste forms containing 2-chlorophenol and 1-chloronapthalene adsorbed on organophilic bentonites. These were prepared by cation exchange with benzyldimethyloctadecylammonium chloride and trimethyloctadecylammonium chloride. The binder was a 30% pozzolanic cement, 70% granulated blast furnace slag mixture. Several binder-to-bentonite ratios and different concentrations of the organics on the bentonite were used. Kinetics of hydration were studied by measurement of chemically bound water and by means of thermal and calorimetric analyses. Microstructure and other physico-mechanical properties of the solidified forms were studied by means of mercury intrusion porosimetry, scanning electron microscopy and unconfined compressive strength measurement. Leaching was checked by two different leaching tests: one dynamic, on monolithic samples, and the other static, on powdered samples. This study indicates that the incorporation of the organic-loaded bentonite in the binder matrix causes modifications in the hardened samples by altering cement hydration. The effects of the two organic contaminants are differentiated.

Adsorption of the organic fraction of a tannery sludge by means of organophilic bentonite.

Two different organophilic bentonites obtained by cationic exchange with benzyldimethyloctadecylammonium chloride and trimethyloctadecylammonium chloride have been used to adsorb the organic fraction of a tannery sludge. The exchange process was carried out to different extents to obtain bentonite samples with different organophilicities and different interlayer spacings. Before adsorption, the organic matter was extracted by contacting the sludge with a Ca(OH)2 saturated solution. The adsorption capacity was found to increase with the amount of ammonium salt exchanged for both bentonites, but the one exchanged with benzyldimethyloctadecylammonium chloride proved to be more active: up to about 80% TOC could be removed from the contacting solution. The adsorption of the organic matter caused a further increase of the bentonite interlayer spacing. In both cases, the adsorption isotherms were found to be of cooperative type, due to weak adsorbent-adsorbate interactions at low loading followed by increasing adsorbate-adsorbate interactions at increasing loading. The results may be applied to tannery sludge stabilization by cementitious systems.

Laparoscopic gastrojejunostomy: a case presentation.

Laparoscopic gastrojejunostomy is demonstrated as an alternative to open gastric bypass procedures. We performed the operative procedure safely and with reasonable anesthesia time, using stapling devices. It is hoped that further patient benefit will be obtained from this laparoscopic procedure in the future.