A Conjugated Carboranyl Main Chain Polymer with Aggregation-Induced Emission in the Near-Infrared.

Materials exhibiting aggregation-induced emission (AIE) are both highly emissive in the solid state and prompt a strongly red-shifted emission and should therefore pose as good candidates toward emerging near-infrared (NIR) applications of organic semiconductors (OSCs). Despite this, very few AIE materials have been reported with significant emissivity past 700 nm. In this work, we elucidate the potential of ortho-carborane as an AIE-active component in the design of NIR-emitting OSCs. By incorporating ortho-carborane in the backbone of a conjugated polymer, a remarkable solid-state photoluminescence quantum yield of 13.4% is achieved, with a photoluminescence maximum of 734 nm. In contrast, the corresponding para and meta isomers exhibited aggregation-caused quenching. The materials are demonstrated for electronic applications through the fabrication of nondoped polymer light-emitting diodes. Devices employing the ortho isomer achieved nearly pure NIR emission, with 86% of emission at wavelengths longer than 700 nm and an electroluminescence maximum at 761 nm, producing a significant light output of 1.37 W sr-1 m-2.

Conjugated Polymer Heteroatom Engineering Enables High Detectivity Symmetric Ambipolar Phototransistors.

Solution-processed high-performing ambipolar organic phototransistors (OPTs) can enable low-cost integrated circuits. Here, a heteroatom engineering approach to modify the electron affinity of a low band gap diketopyrrolopyrole (DPP) co-polymer, resulting in well-balanced charge transport, a more preferential edge-on orientation and higher crystallinity, is demonstrated. Changing the comonomer heteroatom from sulfur (benzothiadiazole (BT)) to oxygen (benzooxadiazole (BO)) leads to an increased electron affinity and introduces higher ambipolarity. Organic thin film transistors fabricated from the novel PDPP-BO exhibit charge carrier mobility of 0.6 and 0.3 cm2 Vs⁻1 for electrons and holes, respectively. Due to the high sensitivity of the PDPP-based material and the balanced transport in PDPP-BO, its application as an NIR detector in an OPT architecture is presented. By maintaining a high on/off ratio (9 × 104), ambipolar OPTs are shown with photoresponsivity of 69 and 99 A W⁻1 and specific detectivity of 8 × 107 for the p-type operation and 4 × 109 Jones for the n-type regime. The high symmetric NIR-ambipolar OPTs are also evaluated as ambipolar photo-inverters, and show a 46% gain enhancement under illumination.

p-Type Conjugated Polymers Containing Electron-Deficient Pentacyclic Azepinedione.

Bisthienoazepinedione (BTA) has been reported for constructing high-performing p-type conjugated polymers in organic electronics, but the ring extended version of BTA is not well explored. In this work, we report a new synthesis of a key building block to the ring expanded electron-deficient pentacyclic azepinedione (BTTA). Three copolymers of BTAA with benzodithiophene substituted by different side chains are prepared. These polymers exhibit similar energy levels and optical absorption in solution and solid state, while significant differences are revealed in their film morphologies and behavior in transistor and photovoltaic devices. The best-performing polymers in transistor devices contained alkylthienyl side chains on the BDT unit (pBDT-BTTA-2 and pBDT-BTTA-3) and demonstrated maximum saturation hole mobilities of 0.027 and 0.017 cm2 V-1 s-1. Blends of these polymers with PC71BM exhibited a best photovoltaic efficiency of 6.78% for pBDT-BTTA-3-based devices. Changing to a low band gap non-fullerene acceptor (BTP-eC9) resulted in improved efficiency of up to 13.5%. Our results are among the best device performances for BTA and BTTA-based p-type polymers and highlight the versatile applications of this electron-deficient BTTA unit.

Functionalisation of conjugated macrocycles with type I and II concealed antiaromaticity via cross-coupling reactions.

Conjugated macrocycles can exhibit concealed antiaromaticity; that is, despite not being antiaromatic, under specific circumstances, they can display properties typically observed in antiaromatic molecules due to their formal macrocyclic 4n π-electron system. Paracyclophanetetraene (PCT) and its derivatives are prime examples of macrocycles exhibiting this behaviour. In redox reactions and upon photoexcitation, they have been shown to behave like antiaromatic molecules (requiring type I and II concealed antiaromaticity, respectively), with such phenomena showing potential for use in battery electrode materials and other electronic applications. However, further exploration of PCTs has been hindered by the lack of halogenated molecular building blocks that would permit their integration into larger conjugated molecules by cross-coupling reactions. Here, we present two dibrominated PCTs, obtained as a mixture of regioisomers from a three-step synthesis, and demonstrate their functionalisation via Suzuki cross-coupling reactions. Optical, electrochemical, and theoretical studies reveal that aryl substituents can subtly tune the properties and behaviour of PCT, showing that this is a viable strategy in further exploring this promising class of materials.

Enhanced Organic Electrochemical Transistor Performance of Donor-Acceptor Conjugated Polymers Modified with Hybrid Glycol/Ionic Side Chains by Postpolymerization Modification.

Emergent bioelectronic technologies are underpinned by the organic electrochemical transistor (OECT), which employs an electrolyte medium to modulate the conductivity of its organic semiconductor channel. Here we utilize postpolymerization modification (PPM) on a conjugated polymer backbone to directly introduce glycolated or anionic side chains via fluoride displacement. The resulting polymers demonstrated increased volumetric capacitances, with subdued swelling, compared to their parent polymer in p-type enhancement mode OECTs. This increase in capacitance was attributed to their modified side chain configurations enabling cationic charge compensation for thin film electrochemical oxidation, as deduced from electrochemical quartz crystal microbalance measurements. An overall improvement in OECT performance was recorded for the hybrid glycol/ionic polymer compared to the parent, owing to its low swelling and bimodal crystalline orientation as imaged by grazing-incidence wide-angle X-ray scattering, enabling its high charge mobility at 1.02 cm2·V-1·s-1. Compromised device performance was recorded for the fully glycolated derivative compared to the parent, which was linked to its limited face-on stacking, which hindered OECT charge mobility at 0.26 cm2·V-1·s-1, despite its high capacitance. These results highlight the effectiveness of anionic side chain attachment by PPM as a means of increasing the volumetric capacitance of p-type conjugated polymers for OECTs, while retaining solid-state macromolecular properties that facilitate hole transport.

Highly Deformed o-Carborane Functionalised Non-linear Polycyclic Aromatics with Exceptionally Long C-C Bonds.

The effect of substituting o-carborane into the most sterically hindered positions of phenanthrene and benzo(k)tetraphene is reported. Synthesised via a Bull-Hutchings-Quayle benzannulation, the crystal structures of these non-linear acenes exhibited the highest aromatic deformation parameters observed for any reported carborane compound to date, and among the largest carboranyl C-C bond length of all organo-substituted o-carboranes. Photoluminescence studies of these compounds demonstrated efficient intramolecular charge-transfer, leading to aggregation induced emission properties. Additionally, an unusual low-energy excimer was observed for the phenanthryl compound. These are two new members of the family of carborane-functionalised non-linear acenes, notable for their peculiar structures and multi-luminescent properties.

Post-polymerisation functionalisation of conjugated polymer backbones and its application in multi-functional emissive nanoparticles.

Backbone functionalisation of conjugated polymers is crucial to their performance in many applications, from electronic displays to nanoparticle biosensors, yet there are limited approaches to introduce functionality. To address this challenge we have developed a method for the direct modification of the aromatic backbone of a conjugated polymer, post-polymerisation. This is achieved via a quantitative nucleophilic aromatic substitution (SNAr) reaction on a range of fluorinated electron-deficient comonomers. The method allows for facile tuning of the physical and optoelectronic properties within a batch of consistent molecular weight and dispersity. It also enables the introduction of multiple different functional groups onto the polymer backbone in a controlled manner. To demonstrate the versatility of this reaction, we designed and synthesised a range of emissive poly(9,9-dioctylfluorene-alt-benzothiadiazole) (F8BT)-based polymers for the creation of mono and multifunctional semiconducting polymer nanoparticles (SPNs) capable of two orthogonal bioconjugation reactions on the same surface.

Carborane-Induced Excimer Emission of Severely Twisted Bis-o-Carboranyl Chrysene.

The synthesis of a highly twisted chrysene derivative incorporating two electron deficient o-carboranyl groups is reported. The molecule exhibits a complex, excitation-dependent photoluminescence, including aggregation-induced emission (AIE) with good quantum efficiency and an exceptionally long singlet excited state lifetime. Through a combination of detailed optical studies and theoretical calculations, the excited state species are identified, including an unusual excimer induced by the presence of o-carborane. This is the first time that o-carborane has been shown to induce excimer formation ab initio, as well as the first observation of excimer emission by a chrysene-based small molecule in solution. Bis-o-carboranyl chrysene is thus an initial member of a new family of o-carboranyl phenacenes exhibiting a novel architecture for highly-efficient multi-luminescent fluorophores.