Spin-to-Charge Conversion in All-Oxide La2/3Sr1/3MnO3/SrIrO3 Heterostructures.

Spin injection and spin-charge conversion processes in all-oxide La2/3Sr1/3MnO3/SrIrO3 (LSMO/SIO) heterostructures with different SIO layer thickness and interfacial features have been studied. Ferromagnetic resonance (FMR) technique has been used to generate pure spin currents by spin pumping (SP) in ferromagnetic (FM) half-metallic LSMO. The change of the resonance linewidth in bare LSMO layers and LSMO/SIO heterostructures suggests a successful spin injection into the SIO layers. However, low values of the spin mixing conductance, compared to more traditional permalloy (Py)/Pt or yttrium iron garnet (YIG)/Pt systems, are found. A thorough analysis of the interfaces by high-resolution scanning transmission electron microscopy (HR-STEM) imaging suggests that they are structurally clean and atomic sharp, but a compositional analysis by energy-dispersive X-ray spectroscopy (EDS) reveals the interdiffusion of La, Ir, and Mn atomic species in the first atomic layers close to the interface. Inverse spin Hall effect (ISHE) measurements evidence that interfacial features play a very relevant role in controlling the effectiveness of the spin injection process and low transversal ISHE voltage signals are detected. In addition, it is found that larger voltage signals are detected for the lowest SIO layer thickness highlighting the role of the spin diffusion length (λsd)/SIO layer thickness ratio. The values of ISHE voltage are rather low but allow us to determine the spin Hall angle of SIO (θSH ≈ 1.12% at T = 250 K), which is remarkably similar to that obtained for the well-known Py/Pt system, therefore suggesting that SIO could be a promising spin-Hall material.

Suppression of spin rectification effects in spin pumping experiments.

Spin pumping (SP) is a well-established method to generate pure spin currents allowing efficient spin injection into metals and semiconductors avoiding the problem of impedance mismatch. However, to disentangle pure spin currents from parasitic effects due to spin rectification effects (SRE) is a difficult task that is seriously hampering further developments. Here we propose a simple method that allows suppressing SRE contribution to inverse spin Hall effect (ISHE) voltage signal avoiding long and tedious angle-dependent measurements. We show an experimental study in the well-known Py/Pt system by using a coplanar waveguide (CPW). Results obtained demonstrate that the sign and size of the measured transverse voltage signal depends on the width of the sample along the CPW active line. A progressive reduction of this width evidences that SRE contribution to the measured transverse voltage signal becomes negligibly small for sample width below 200 µm. A numerical solution of the Maxwell equations in the CPW-sample setup, by using the Landau-Lifshitz equation with the Gilbert damping term (LLG) as the constitutive equation of the media, and with the proper set of boundary conditions, confirms the obtained experimental results.