Effect of dye bath pH in dyeing of cotton knitted fabric with reactive dye (Remazol Yellow RR) in exhaust method: impact on color strength, chromatic values and fastness properties.

The significance of textile coloration is inevitable as coloration is a critical process and it can be affected by several parameters i. e. time, temperature, pH, and liquor ratio (M:L). This research reveals the behavior of different dye bath pH (2 to 12) on the basis of spectrophotometric characteristics and colorfastness using the most useable brand of reactive dye in Bangladesh i. e. Remazol Yellow RR. Earlier researches were performed on the basis of other coloration controlling factors i. e. temperature, time and liquor ratio (M:L) where pH acts as the dependent variable. However in this study, pH was taken as an independent variable where lower pH (2, 4 and 6), medium pH (8 and 10) and higher pH (12) were taken into consideration for verifying the dyeing performance. Meanwhile, the mentioned pH was achieved by adding acetic acid, soda ash and caustic soda respectively. In this study, the impact of pH is analyzed on the basis of color strength, chromaticity, hue angle, CIELAB color space, spectrophotometric image, reflectance percentage and color fastness tests i. e color fastness to rubbing, color fastness to wash, color fastness to perspiration, color fastness to light. Gradually elevated pH boosts up the color strength and chromaticity, at the same time downgrades of hue angle results orangish tone in the dyed fabric. Even more, the lightness of dyed fabric decreases and redness rises with the increment of dyebath pH which results in orangish red darker tone of dyed fabric. Consequently, fabric dyed at acidic dye bath pH exhibits higher resistance in case of color change and color staining from the dyed fabric and multifiber fabric respectively and vice versa.

Green synthesis of silver nanoparticles using Cinnamomum tamala (Tejpata) leaf and their potential application to control multidrug resistant Pseudomonas aeruginosa isolated from hospital drainage water.

Green Synthesis of Metal Nanoparticles is becoming a more common method for producing nanoparticles with a diameter of 1-100 nm that may be employed in a variety of medical applications. The antibacterial efficacy of silver nanoparticles (AgNPs) derived from Cinnamomum tamala (Tejpata) leaf extract against antibiotic-resistant Pseudomonas aeruginosa is investigated in this study. Green AgNP synthesis is safe, cost-effective, and ecologically friendly. The biosynthesized AgNPs were studied using UV-Visible spectroscopy, Fourier Transform Infrared Spectroscopy (FTIR), Dynamic Light Scattering (DLS), X-ray Diffraction (XRD), and Transmission Electron Microscopy (TEM). The AgNPs were virtually spherical, with an average size of 25-30 nm, according to TEM observations. Biochemical and molecular identification were used to isolate multidrug-resistant P. aeruginosa from the hospital's drainage water. The antibacterial potential of AgNPs against P. aeruginosa is determined using the agar diffusion method. Silver nanoparticles produced from Cinnamomum tamala (Tejpata) leaf extract were shown to be effective in inhibiting four strains of P. aeruginosa. According to the agar disc diffusion method, AgNPs had the largest inhibition zone of 17.67 ± 0.577 mm, while aqueous extract had 5.67 ± 0.5777 mm, indicating that AgNPs had antibacterial activity. This study on AgNPs might assist with managing multidrug resistant pathogenic bacteria and be a possible source of medicinal application due to its potential antibacterial effect.

Optical and Electronic Structural Properties of Cu3N Thin Films: A First-Principles Study (LDA + U).

A comprehensive study on the electronic structure and optical properties of a Cu3N film is performed by the first-principles study using density functional theory. The Hubbard (U) term is added in the local density approximation approach for improvement of the theoretical band gap energy. The band structure of the Cu3N unit cell shows a strong hybridization of Cu 3d and N 2p orbitals in the near-valence band region (M) because of their antibonding states which are also observed by molecular orbitals (HOMO-LUMO). The conduction band is dominated by a very small amount of Cu 3p and N 2p orbitals. The density of states exhibits a negligible deformation in Cu-N bonding. The Cu3N thin film deposited by the DC magnetron-sputtering technique shows a polycrystalline structure with a nonstoichiometric Cu3N phase. The experimentally obtained optical band gap and refractive index of the Cu3N film are 1.44 eV and 2.14, respectively, which are comparable with those from the theoretical approximation.