Combined Layer-by-Layer/Hydrothermal Synthesis of Fe3O4@MIL-100(Fe) for Ofloxacin Adsorption from Environmental Waters.

A simple not solvent and time consuming Fe3O4@MIL-100(Fe), synthesized in the presence of a small amount of magnetite (Fe3O4) nanoparticles (27.3 wt%), is here presented and discussed. Layer-by-layer alone (20 shell), and combined layer-by-layer (5 shell)/reflux or /hydrothermal synthetic procedures were compared. The last approach (Fe3O4@MIL-100_H sample) is suitable (i) to obtain rounded-shaped nanoparticles (200-400 nm diameter) of magnetite core and MIL-100(Fe) shell; (ii) to reduce the solvent and time consumption (the layer-by-layer procedure is applied only 5 times); (iii) to give the highest MIL-100(Fe) amount in the composite (72.7 vs. 18.5 wt% in the layer-by-layer alone); (iv) to obtain a high surface area of 3546 m2 g-1. The MIL-100(Fe) sample was also synthesized and both materials were tested for the absorption of Ofloxacin antibiotic (OFL). Langmuir model well describes OFL adsorption on Fe3O4@MIL-100_H, indicating an even higher adsorption capacity (218 ± 7 mg g-1) with respect to MIL-100 (123 ± 5 mg g-1). Chemisorption regulates the kinetic process on both the composite materials. Fe3O4@MIL-100_H performance was then verified for OFL removal at µg per liter in tap and river waters, and compared with MIL-100. Its relevant and higher adsorption efficiency and the magnetic behavior make it an excellent candidate for environmental depollution.

Zaltoprofen/4,4'-Bipyridine: A Case Study to Demonstrate the Potential of Differential Scanning Calorimetry (DSC) in the Pharmaceutical Field.

The Zaltoprofen/4,4'-Bipyridine system gives rise to two co-crystals of different compositions both endowed - in water and in buffer solution at pH 4.5 - with considerably higher solubility and dissolution rate than the pure drug. The qualitative and quantitative analysis of the DSC measurements, carried out on samples made up of mixtures prepared according to different methodologies, allows us to elaborate and propose an accurate thermodynamic model that fully takes into account the qualitative aspects of the complex experimental framework and which provides quantitative predictions (reaction enthalpies and compositions of the co-crystals) in excellent agreement with the experimental results. Co-crystal formation and cocrystal compositions were confirmed by X-ray diffraction measurements as well as by FT-IR and NMR spectroscopy measurements. The quantitative processing of DSC measurements rationalizes and deepens the scientific aspects underlying the so-called Tammann's triangle and constitutes a model of general validity. The work shows that DSC has enormous potential, which however can be fully exploited only by paying adequate attention to the experimental aspects and the quantitative processing of the measurements.

Zinc Based Metal-Organic Frameworks as Ofloxacin Adsorbents in Polluted Waters: ZIF-8 vs. Zn3(BTC)2.

Two different zinc-based metal-organic frameworks (MOFs) were investigated to remove one of the most used fluoroquinolone antibiotic, Ofloxacin (OFL), from polluted water. The most common zeolitic imidazolate framework-8 (ZIF-8) and the green Zn(II) and benzene-1,3,5-tri-carboxylate (Zn3(BTC)2) were prepared through a facile synthetic route and characterized by means of Fourier-Transform Infrared (FT-IR) Spectroscopy, X-ray Powder Diffraction (XRPD), and Scanning Electron Microscopy (SEM) analyses. The two MOFs were compared in terms of both adsorption and kinetic aspects under real conditions (tap water, natural pH). Results showed that OFL was adsorbed in remarkable amounts, 95 ± 10 and 25.3 ± 0.8 mg g-1 on ZIF-8 and Zn3(BTC)2, respectively, following different mechanisms. Specifically, a Langmuir model well described the ZIF-8 profile, while for Zn3(BTC)2, cooperative adsorption occurred. Moreover the kinetic results were quite different, pseudo-second-order and sigmoidal, respectively. The suitability of ZIF-8 and Zn3(BTC)2 as adsorbent phases for water depollution was tested on tap water samples spiked with OFL 10 µg L-1. The obtained removal efficiencies, of 88% for ZIF-8 and 72% for Zn3(BTC)2, make these materials promising candidates for removing fluoroquinolone antibiotics (FQs) from polluted waters, notwithstanding their limited reusability in tap water, as demonstrated by in-depth characterization of the two MOFs after usage.