Extra-articular subcutaneous "inverted king post-truss" ligament reconstruction for severe swan neck deformity (snapping finger).

A swan neck deformity (SND) can be well tolerated for a long time, until the appearance of a disabling "snapping finger". In its most advanced condition, the other hand is needed to initiate finger flexion. We propose a technique of extra-articular, subcutaneous ligament reconstruction with an "inverted king post-truss" configuration use in roofs and to reinforce railway bridges. An artificial ligament (MaxBraid™ polyethylene surgical suture, 5 metric, Biomet) makes a figure of eight between transosseous tunnels in the proximal and middle phalanges, crossing over top of the A3 pulley. We limited our series to severe SND cases with "snapping finger". We excluded isolated SNDs without functional disability. Eleven patients were followed for 3.4 years on average. The cause was an acute injury 8 times (7 balloon accidents), rheumatoid arthritis 2 times and overuse once (saxophone). Only one case was a poor outcome of mallet finger. The 11 patients were reassessed by a telephone survey. Two patients underwent reoperation: one for a ligament rupture, the other one for a knot that became untied. One patient had a suspected late rupture but without recurrence of the disabling snapping finger. The 11 patients considered themselves improved by the intervention. Nine patients did not notice any difference between their operated finger and the contralateral side. Return to manual activity was possible once the skin had healed. The technique is simpler than the spiral oblique retinacular ligament (SORL) reconstruction technique described by Thomson-Littler and also less demanding because it does not involve the distal interphalangeal joint. It requires only a short incision in the volar crease of the proximal interphalangeal joint. No tendon or ligament is sacrificed. Neither postoperative immobilization nor lengthy physical therapy is needed. Complications can be avoided by selecting the appropriate artificial ligament material and careful knot tying.

Is coracoclavicular stabilisation alone sufficient for the endoscopic treatment of severe acromioclavicular joint dislocation (Rockwood types III, IV, and V)?

BACKGROUND: The primary objective was to evaluate correlations linking anatomical to functional outcomes after endoscopically assisted repair of acute acromioclavicular joint dislocation (ACJD). HYPOTHESIS: Combined acromioclavicular and coracoclavicular stabilisation improves radiological outcomes compared to coracoclavicular stabilisation alone. MATERIAL AND METHODS: A prospective multicentre study was performed. Clinical outcome measures were pain intensity on a visual analogue scale (VAS), subjective functional impairment (QuickDASH score), and Constant's score. Anatomical outcomes were assessed on standard radiographs (anteroposterior view of the acromioclavicular girdle and bilateral axillary views) obtained preoperatively and postoperatively and on postoperative dynamic radiographs taken as described by Tauber et al. RESULTS: Of 116 patients with acute ACJD included in the study, 48% had type III, 30% type IV, and 22% type V ACJD according to the Rockwood classification. Coracoclavicular stabilisation was achieved using a double endobutton in 93% of patients, and concomitant acromioclavicular stabilisation was performed in 50% of patients. The objective functional outcome was good, with an unweighted Constant's score ≥ 85/100 and a subjective QuickDASH functional disability score ≤ 10 in 75% of patients. The radiographic analysis showed significant improvements from the preoperative to the 1-year postoperative values in the vertical plane (decrease in the coracoclavicular ratio from 214 to 128%, p=10(-6)) and in the horizontal plane (decrease in posterior displacement from 4 to 0mm, p=5×10(-5)). The anatomical outcome correlated significantly with the functional outcome (absolute R value=0.19 and p=0.045). We found no statistically significant differences across the various types of constructs used. Intra-operative control of the acromioclavicular joint did not improve the result. Implantation of a biological graft significantly improved both the anatomical outcome in the vertical plane (p=0.04) and acromioclavicular stabilisation in the horizontal plane (p=0.02). The coracoclavicular ratio on the anteroposterior radiograph was adversely affected by a longer time from injury to surgery (p=0.02) and by a higher body mass index (BMI) (p=0.006). High BMI also had a negative effect on the difference in the distance separating the anterior edge of the acromion from the anterior edge of the clavicle between the injured and uninjured sides, as assessed on the axillary views (p=0.009). CONCLUSION: This study demonstrates that acute ACJD requires stabilisation in both planes, i.e., at the coracoclavicular junction and at the acromioclavicular joint. Coracoclavicular stabilisation alone is not sufficient, regardless of the type of implant used. Implantation of a biological graft should be considered when the time from injury to surgery is longer than 10days. The weight of the upper limb should be taken into account, with 6weeks of immobilisation to unload the construct in patients who have high BMI values. LEVEL OF EVIDENCE: II, prospective non-randomised comparative study.

Prognostic factors to succeed in surgical treatment of chronic acromioclavicular dislocations.

INTRODUCTION: Treatment of chronic acromioclavicular joint dislocation (ACJD) remains a poorly known and controversial subject. Given the many surgical options, it is not always easy to determine which steps are indispensable. METHODS: This article reports a multicenter prospective study. The clinical and radiological follow-up involved a comparative analysis of the preoperative and postoperative data at 1 year, including pain (visual analogue scale), subjective functional incapacity (QuickDASH), and the objective Constant score, as well as a comparative analysis of vertical and horizontal movements measured on simple x-rays. RESULTS: Based on a series of 140 operated ACJDs, we included 24 chronic ACJDs. The mean time to surgery was 46 weeks (range, 1 month to 4 years). The patients' mean age was 41 years, with a majority of males (75%), 72% of whom participated in recreational sports. Professionally, 40% of the subjects had jobs involving manual labor. We noted 40% grade III, 24% grade IV, and 36% grade V injury according to the Rockwood classification. In 92% of cases, coracoclavicular stabilization was provided by a double button implant, reinforced with a biological graft in 88% of the cases. In 29%, millimeters to centimeters of the distal clavicle were resected and acromioclavicular stabilization was associated in 54%. We observed complications in 33% of the cases. At 1 year postoperative, 21 patients underwent clinical and radiological follow-up (87.5%). Only 35% of the patients were satisfied or very satisfied, whereas 100% of them would recommend the operation. Full-time work was resumed in 91% of the cases and all sports could be resumed in 86%. The pre- and postoperative values at 1 year changed as follows: the mean Constant score improved from 61 to 87 (p=0.00002); the subjective QuickDASH score decreased from 41 to 9 (p=0.00002); and radiologically significant reduction of the initial displacement was observed in the vertical plane (p<10(-3)) and the horizontal plane (p=0.022). CONCLUSION: In this study, the favorable prognostic factors found were: time to surgery less than 3 months (p=0.02), associated acromioclavicular stabilization, and postoperative immobilization with a sling extended to 6 weeks. However, resection of the distal clavicle did not influence the final result. LEVEL OF PROOF: Level II prospective non-randomized comparative study.

Reactions of [NH3+*, H2O] with carbonyl compounds: a McLafferty rearrangement within a complex?

The reactions of the water solvated ammonia radical cation [NH(3)(+*), H(2)O] with a variety of aldehydes and ketones were investigated. The reactions observed differ from those of low energy aldehydes and ketones radical cations, although electron transfer from the keto compound to ionized ammonia is thermodynamically allowed within the terbody complexes initially formed. The main process yields an ammonia solvated enol with loss of water and an alkene. This process corresponds formally to a McLafferty fragmentation within a complex. With aldehydes, another reaction can take place, namely the transfer of the hydrogen from the CHO group to ammonia, leading to the proton bound dimer of ammonia and water, and to the NH(4)(+) cation. Comparison between the available experimental results leads to the conclusion that the McLafferty fragmentation occurs within the terbody complex initially formed, with no prior ligand exchange, the water molecule acting as a spectator partner.

Reactions of CH(3)CHO(.+) and of CH(3)COH(.+) with water upon Fourier transform ion cyclotron resonance conditions.

The reactions of CH(3)CHO(+) and of CH(3)COH(+) with water yield the same products, at almost the same rate. It is shown, by using a characteristic reaction of the carbene structure, that a molecule of water converts CH(3)COH(+) into its more stable isomer CH(3)CHO(+), which is a new example of catalyzed 1,2-H transfer. The dominant product is the proton-bound dimer of water which, in fact, comes from the [H(2)OH(+)...CH(3)(.)] and [H(2)OH(+)...CO] primary products whose observed abundances are poor. In a related system, ionized formamide/water, a water molecule catalyzes the 1,3-transfer leading from the solvated carbene to the [H(2)O...H(+)...H(2)N-C=O)] stable intermediate, which eliminates CO without back energy. In contrast, such a process does not take place in the studied system since the cleavage of the so formed [H(2)OH(+)...CH(3)CO] transient intermediate involves a high back energy; this is explained by the charge repartition within this intermediate. In fact, a different pathway takes place. The solvated acetaldehyde ion isomerizes into a terbody intermediate in which protonated water is bonded to a CO molecule on the one hand and to a methyl radical on the other hand. Simple cleavages of this complex yield the observed products.

Ter-body intermediates in the gas phase: reaction of ionized enols with tert-butanol.

In the gas phase, the CH2CHOH.+ enol radical cation 1 as well as its higher homologues CH3CHCHOH.+ 2 and (CH3)2CCHOH.+ 3, undergo exactly the same sequence of reactions with tert-butanol, leading to the losses of isobutene, water and water plus alkene. Fourier transform ion cyclotron resonance (FT-ICR) experiments using labeled reactants as well as ab initio calculations show that independent pathways can be proposed to explain the observed reactivity. For ion 1, taken as the simplest model, the first step of the reaction is formation of a proton bound complex which gives, by a simple exothermic proton transfer, the ter-body intermediate [CH2CHO., H2O, C(CH3)3+]. This complex, which was shown to possess a significant lifetime, is the key intermediate which undergoes three reactions. First, it can collapse to yield tert-butylvinyl ether with elimination of water. Second, by a regiospecific proton transfer, this complex can isomerize into three different ter-body complexes formed of water, isobutene and ionized enol. Within one of these complexes, which does not interconvert with the others, elimination of isobutene leads to the formation of a solvated enol ion. Within the others, a cycloaddition-cycloreversion process can proceed to yield the ionized enol 3 (loss of water and ethylene channel).

Proton affinity and heat of formation of vinyloxy [CH2CHO]· and Acetonyl [CH2COCH3]· radicals.

Frequently found in hydrocarbon oxidation and in the photochemistry of carbonyl compounds, the ß-carbonyl radicals are of interest. The experimental proton affinities of the two title radicals have been determined from proton transfer reactions (as shown) monitored in an FT-ICR mass spectrometer. This led to an estimation of their heats of formation (1: 13±3; 2: -34±3 kJ mol(-1)). Ab initio molecular orbital calculations, up to the G2 level, confirmed these results.

The

The bimolecular reaction of the CH2CHOH+ enol ion (m/z 44) with acetaldehyde gives a strongly dominant product, m/z 45, formed mainly by proton transfer from the ion to the molecule. The abundance of the product coming from a H* abstraction reaction from the neutral, albeit more exothermic, is negligible. In order to explain this result, the long lived [CH2CHOH*+, CH3CHO] solvated ion was generated by reaction of the CH2CHOH*+ enol ion with (CH3CHO)n in the cell of a Fourier transform ion cyclotron resonance mass spectrometer. The structure of this solvated ion was clearly established. Labeling indicates that [CH2CHOH+, CH3CHO], upon low energy collisions, reacts by H* abstraction more rapidly than by H+ transfer to the neutral moiety. This shows that the entropic factors are determinant when the enol ion reacts directly with acetaldehyde.

Insights into the C(4)H(8)(+.) potential energy surface: fourier transform ion cyclotron resonance studies of ion-molecule reactions of D-labeled partners

Reactions of [ethylene](+.) with ethylene and of [acetylene](+.) with ethane were studied by Fourier transform ion cyclotron resonance spectrometry using labeled reactants. The results confirm and clarify the different steps of the mechanism proposed previously and elaborated with other methods. The [[acetylene](+.), ethane] system can either dissociate to give the ethyl cation product, or isomerize into [[ethylene](+.), ethylene]. The latter system can either dissociate to yield ionized ethylene or convert into ionized but-2-ene, which undergoes a complete H-exchange prior to dissociation, leading to methyl radical, hydrogen radical and ethylene losses. The transfers of labeled atoms and the existence of H-exchange prior to formation of the products were used as a probe to check the different steps of the mechanism. The influence of the initial energy of the system on the reaction pathway is discussed. Copyright 1999 John Wiley & Sons, Ltd.

Pins and Rubbers Traction System.

The Pins and Rubbers Traction System (PRTS) is a mobile frame created with wires to support elastic traction, which produces a ligamentotaxis effect in the same direction and of the same intensity whatever the position of the joint. This technique has been used in 11 cases of complex PIP joint fractures with eight excellent results. The advantages are simplicity, adaptability, the possibility of immediate mobilization, reasonable cost and relatively small bulk.