Benchmarking of a microgel-reinforced hydrogel-based aqueous lubricant against commercial saliva substitutes.

Xerostomia, the subjective sensation of 'dry mouth' affecting at least 1 in 10 adults, predominantly elders, increases life-threatening infections, adversely impacting nutritional status and quality of life. A patented, microgel-reinforced hydrogel-based aqueous lubricant, prepared using either dairy or plant-based proteins, has been demonstrated to offer substantially enhanced lubricity comparable to real human saliva in in vitro experiments. Herein, we present the benchmarking of in vitro lubrication performance of this aqueous lubricant, both in its dairy and vegan formulation against a range of widely available and employed commercial saliva substitutes, latter classified based on their shear rheology into "liquids", "viscous liquids" and "gels", and also had varying extensional properties. Strikingly, the fabricated dairy-based aqueous lubricant offers up to 41-99% more effective boundary lubrication against liquids and viscous liquids, irrespective of topography of the tested dry mouth-mimicking tribological surfaces. Such high lubricity of the fabricated lubricants might be attributed to their limited real-time desorption (7%) from a dry-mouth mimicking hydrophobic surface unlike the tested commercial products including gels (23-58% desorption). This comprehensive benchmarking study therefore paves the way for employing these microgel-based aqueous lubricant formulations as a novel topical platform for dry mouth therapy.

Effect of polymer architecture on the adsorption behaviour of amphiphilic copolymers: A theoretical study.

HYPOTHESIS: Polymer architecture is known to have significant impact on its adsorption behaviour. Most studies have been concerned with the more concentrated, "close to surface saturation" regime of the isotherm, where complications such as lateral interactions and crowding also additionally affect the adsorption. We compare a variety of amphiphilic polymer architectures by determining their Henry's adsorption constant (kH), which, as with other surface active molecules, is the proportionality constant between surface coverage and bulk polymer concentration in a sufficiently dilute regime. It is speculated that not only the number of arms or branches, but also the position of adsorbing hydrophobes influence the adsorption, and that by controlling the latter the two can counteract each other. METHODOLOGY: The Self-consistent field calculation of Scheutjens and Fleer was implemented to calculate the adsorbed amount of polymer for many different polymer architectures including linear, star and dendritic. Using the adsorption isotherms at very low bulk concentrations, we determined the value of kH for these. FINDINGS: It is found that the branched structures (star polymers and dendrimers) can be viewed as analogues of linear block polymers based on the location of their adsorbing units. Polymers containing consecutive trains of adsorbing hydrophobes in all cases showed higher level of adsorption compared to their counterparts, where the hydrophobes were more uniformly distributed on the chains. While increasing the number of branches (or arms for star polymers) also confirmed the known result that the adsorption decreased with the number of arms, this trend can be partially offset by the appropriate choice of the location of anchoring groups.