Correction: Magnetic sodium alginate grafted with waste carbonaceous material for diclofenac sodium removal: optimization of operational parameters and process mechanism.

[This corrects the article DOI: 10.1039/D3RA00495C.].

Magnetic sodium alginate grafted with waste carbonaceous material for diclofenac sodium removal: optimization of operational parameters and process mechanism.

As their manufacturing and consumption have increased, pharmaceutical chemicals have increasingly been found in wastewater. It is necessary to look into more effective methods, including adsorption, because current therapies can't completely eliminate these micro contaminants. This investigation aims to assess the diclofenac sodium (DS) adsorption onto an Fe3O4@TAC@SA polymer in a static system. Through Box-Behnken design (BBD), system optimization was carried out, and the ideal conditions - adsorbent mass of 0.01 g and agitation speed of 200 rpm - were chosen. The adsorbent was created utilizing X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FT-IR), allowing us to gain a comprehensive understanding of its properties. The analysis of the adsorption process revealed that the external mass transference was the primary rate-controlling step, and the Pseudo-Second-Order model demonstrated the best correlation to kinetic experimental results. An endothermic, spontaneous adsorption process took place. The removal capacity was 858 mg g-1, which is a respectable result when compared to other adsorbents that have been utilized in the past to remove DS. Ion exchange, π-π interactions, electrostatic pore filling and hydrogen bonding all play a role in the adsorption of DS on the Fe3O4@TAC@SA polymer. After careful examination of the adsorbent towards a true sample, it was determined to be highly efficient after three regenerative cycles.

Facile synthesis and characterization of magnesium and manganese mixed oxides for the efficient removal of tartrazine dye from aqueous media.

Nanomaterials are the most effective class of substances for use as adsorbents in wastewater treatment. Hence, the current study involves the facile and low-cost synthesis of MgMn2O4/Mn2O3 and MgMn2O4/Mn2O3/Mg6MnO8 as novel nanostructures from mixed solutions of Mg(ii) and Mn(ii) ions using the Pechini sol-gel method. After that, the remaining powder was calcined at 500, 700, and 900 °C for 3 h; the products were designated as G500, G700, and G900, respectively. The G500 sample consists of MgMn2O4 and Mn2O3, while the G700 and G900 samples consist of MgMn2O4, Mg6MnO8, and Mn2O3. The synthesized nanostructures were characterized using several tools, such as X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and N2 adsorption/desorption analysis. The average crystallite size of the G500, G700, and G900 samples is 210.53, 95.27, and 83.43 nm, respectively. The SEM images showed that the G500 sample consists of square and rectangular bars with an average diameter of 3.18 µm. Also, the G700 and G900 samples consist of hexagonal, polyhedral, and irregular shapes with an average diameter of 1.12 and 0.54 µm, respectively. The synthesized nanostructures were further utilized as adsorbents for the efficient removal of tartrazine dye from aqueous media. The experimental data showed a good fit with the Langmuir isotherm and pseudo-first-order model. The maximum adsorption capacities of the G500, G700, and G900 adsorbents toward tartrazine dye are 328.95, 359.71, and 395.26 mg g-1, respectively.

Exploring the Antifungal Activity and Action of Saussurea costus Root Extracts against Candida albicans and Non-albicans Species.

The isolation and assessment of the active constituents in polar and non-polar crude extracts of Saussurea costus roots as antifungal agents, against Candida albicans and non-C. albicans (NAC) species, was the aim of this current investigation. The SEM "Scanning electron microscopy" imaging provided potential action modes of n-hexane extract (nhhE) toward Candida spp., whereas the TLC-DB "Thin layer chromatography-direct bioautography" was employed for detecting the anticandidal compounds. nhhE had the greatest biocidal activity against all strains and clinical isolates of Candida spp. with maximum zones of inhibition. SEM revealed the occurrence of irregular, dense inclusions of C. albicans cell walls after treatment with nhhE for 12 h. Complete morphological distortions with lysed membranes and deterioration signs appeared in most treated cells of C. parapsilosis. The most effectual compound with anticandidal activity was isolated using TLC-BD and identified as sesquiterpene by GC/MS analysis. The infra-red analysis revealed the presence of lactone ring stretching vibrations at 1766.72 cm-1. The anticandidal activity of nhhE of S. costus roots was confirmed from the results, and the treated cotton fabrics with nhhE of S. costus possessed observable activity against C. albicans. Data could recommend the practical usage of S. costus extracts, particularly nhhE, as influential natural bioactive sources for combating pathogenic Candida spp.

Cellulose Acetate-Cellulose Nanowhisker Nanocomposite Immobilized with a DCDHF-Hydrazone Chromophore toward a Smart Test Strip for Colorimetric Detection of Diethyl Chlorophosphate as a Nerve Agent Mimic.

Exposure to nerve agents, which are usually colorless and odorless gases, may cause organ failure, paralysis, or even quick death. Diethyl chlorophosphate (DCP) has been recognized as one of the most well-known chemical warfare nerve agent mimics. In the current study, we introduce a simple strategy for the development of a portable and reversible nanocomposite-based microporous strip for naked-eye detection of DCP within a few seconds. A dicyanomethylenedihydrofuran hydrazone (DCDHF-H) chromophore was synthesized by an easy azo-coupling reaction and encapsulated in situ during the preparation of cellulose acetate/cellulose nanowhisker/hydrazone (CA-CNW-H) nanocomposites. These CA-CNW-H nanocomposites displayed a bathochromic shift in the absorption intensity of about 142 nm from 438 to 580 nm with the increase of the DCP concentration. The present CA-CNW-H sensor strip displayed a detection limit for DCP ranging from 25 to 200 ppm. The color change of CA-CNW-H from yellow to purple due to exposure to DCP was detected by CIE Lab analysis. The morphology, fibrous crystallinity, thermal stability, and mechanical properties of the prepared CA-CNW-H sensor strips were investigated.

Development of photoluminescent, superhydrophobic, and electrically conductive cotton fibres.

A simple method for the preparation of multifunctional nanocomposite was developed towards the production of water-repellent, electrically conductive, and photoluminescent film onto cotton fibres. The nanocomposite was composed of lanthanide-doped strontium aluminium oxide and silicon rubber dispersed in petroleum ether. The electrically conductive fabric was woven from nickel strips twisted with cotton filaments as core yarns, which were wrapped with pure cotton yarns. The nanoparticles (NPs) of lanthanide-doped strontium aluminium oxide were mixed with environmentally friendly room-temperature vulcanizing silicon rubber (RTV-SR) dissolved in petroleum ether to give the silicon rubber/strontium aluminate nanocomposites. The produced nanocomposites were applied onto electrically conductive cotton/nickel fibres using spray-coating technology. The surface of the cotton/nickel fibres showed different hierarchical morphologies depending on the total content of the silicon rubber. Additionally, the superhydrophobic effect was found to be improved upon increasing the total content of the luminescence pigment NPs. The morphologies of the prepared phosphor NPs were determined using transmission electron microscopy (TEM). The generated transparent luminescence film demonstrated an absorbance peak at 358 nm and an emission peak at 515 nm. Photoluminescence of cotton fibres was monitored with the generation of different colours, including grey, green-yellow, bright white, and turquoise shades as recognized using CIE Laboratory colorimetric parameters. The emission, excitation, lifetime, and decay time spectra of the phosphorescent spray-coated cotton samples were studied. The surface morphologies and chemical compositions of the spray-coated cotton/nickel were investigated using wavelength-dispersive X-ray fluorescence (WD-XRF), scanning electron microscope (SEM), Fourier-transform infrared spectra (FTIR), and energy-dispersive X-ray analyzer (EDAX). The superhydrophobic effects were characterized by measuring static water contact angle. The comfort characteristics of the treated cotton/nickel substrates were assessed by investigating their air permeability and stiffness. The treated cotton/nickel fabrics also displayed an antimicrobial activity. The results displayed water repellence with high electrical conductivity and photoluminescence properties.

Luminescence feature of new 3,6-di(thiazolidin-5-one-2-yl)-carbazole derivative: synthesis, photophysical properties, density functional theory studies, and crystal shape effect.

A new carbazole chromophore conjugated with substituted thiazolidine-4-one (CzPT) was synthesized by applying the Knoevenagel reaction between 3,6-diformyl-N-hexylcarbazole and ethyl 2-aceto-2-(5-oxo-3-phenylthiazolidin-2-ylidene)acetate. The chemical structure of the new derivative (CzPT) was elucidated by spectral studies. The CzPT absorption spectra in different solvents exhibited a red shift for λmax by increasing solvent polarity. Bands at 430-474 nm appeared and were attributed to intramolecular charge transfer with high π-π* characteristics. CzPT fluorescence spectra exhibited a red shift after increasing the solvent polarity. To understand the Stokes' shift ( ∆ ν ¯ ) behaviour of the CzPT derivative referring to the polarity of solvents, Lippert-Mataga and linear solvation-energy relationship (LSER) models were employed in which the LSER exhibited respectable results compared with Lippert-Mataga (r2 = 0.9707). Moreover, time-dependent density functional theory absorption spectra in hexane and dimethylformamide showed that λmax had a major contribution in the highest occupied molecular orbital to lowest unoccupied molecular orbital transition in both solvents. In addition, the reduced uniformity of crystal features may lead to dislocation or anomalous arrangement of crystals with irregular spacing, which automatically enhances the optical properties of such crystals.

A facile methodology using quantum dot multiplex labels for tracking co-transfection.

Advances in the field of genome engineering demand the development of efficient non-viral transfection agents capable of delivering multiple distinct nucleic acids efficiently to cells (co-transfection). However, current delivery methods result in lower co-transfection efficiency than single plasmid transfections, and the efficiency decreases further with increasing numbers of plasmids. The development of a high-throughput methodology is required for the validation of co-transfection platforms to facilitate independent tracking of not only the multiple DNA plasmids during transfection but also the localisation of transfection agents. This is pivotal to determine the bottlenecks in achieving high transfection efficiencies at various stages of the cell internalisation and plasmid expression process. Herein we demonstrate that this can be achieved using a facile methodology in which quantum dots (QDs) are used to label two different plasmid DNA assemblies that are delivered to cells simultaneously using a dendronised polymer system. Multispectral confocal imaging can be used to separate signals from each polyplex as well as the expressed fluorescent reporter proteins to determine whether co-transfection difficulties result from poor internalisation or the inability of DNA to escape from polyplexes. The results demonstrate the utility of this facile approach to label polyplexes without interfering with gene expression, and enable high-throughput screening of transfection reagents for achieving optimal co-transfection.

Intracellular speciation of gold nanorods alters the conformational dynamics of genomic DNA.

Gold nanorods are one of the most widely explored inorganic materials in nanomedicine for diagnostics, therapeutics and sensing1. It has been shown that gold nanorods are not cytotoxic and localize within cytoplasmic vesicles following endocytosis, with no nuclear localization2,3, but other studies have reported alterations in gene expression profiles in cells following exposure to gold nanorods, via unknown mechanisms4. In this work we describe a pathway that can contribute to this phenomenon. By mapping the intracellular chemical speciation process of gold nanorods, we show that the commonly used Au-thiol conjugation, which is important for maintaining the noble (inert) properties of gold nanostructures, is altered following endocytosis, resulting in the formation of Au(I)-thiolates that localize in the nucleus5. Furthermore, we show that nuclear localization of the gold species perturbs the dynamic microenvironment within the nucleus and triggers alteration of gene expression in human cells. We demonstrate this using quantitative visualization of ubiquitous DNA G-quadruplex structures, which are sensitive to ionic imbalances, as an indicator of the formation of structural alterations in genomic DNA.

Magnetically recoverable Fe3O4@Au-coated nanoscale catalysts for the A3-coupling reaction.

The utility of novel Fe3O4@Au nanoparticles as magnetically separable and recyclable heterogeneous catalysts for the A3-coupling reaction of aldehydes, amines and terminal alkynes to yield the corresponding propargylamines is demonstrated. Herein we present a comprehensive analysis of the experimentally observed trends in the conversions with computational analysis using LUMO density on molecular isosurfaces and the electrostatic potential (ESP) effects estimated using DFT calculations.