Ecological risk assessment for different macrophytes and fish species in reservoirs using biota-sediment accumulation factors as a useful tool.

Metal content was evaluated in the sediment, macrophytes and fish in the Medjuvrsje reservoir (Western Serbia). Concentrations of 16 trace elements (Ag; Al; As; B; Ba; Cd; Co; Cr; Cu; Fe; Li; Mn; Ni; Pb; Sr; Zn) were analysed in the sediment, macrophytes and fish of an aquatic ecosystem. Five macrophyte species and three fish tissues (liver, muscle, gills) from five fish species (freshwater bream, common nase, Prussian carp, chub, wels catfish) were sampled and the metal content was analysed with ICP-OES. The sediment concentrations of Cu, Cd, and Zn exceeded the Canadian sediment quality guidelines while concentrations of Cr and Ni were above the Netherlands' target values. Bioaccumulation factors (BSAF) were calculated for analysed macrophytes and fish tissue. The BSAF had higher values for macrophytes for all investigated elements except for Cu and Zn; Cu had a higher value in the liver of the freshwater bream (0.823) and Zn had a higher value in the liver of freshwater bream (0.914) and chub (0.834) as well as in gills of Prussian carp (2.58) and chub (1.26). Potamogeton pectinatus, Ceratophylum demersum and the root of Phragmites communis showed higher accumulation of elements than Trapa natans and Potamogeton fluitans and the body of P. communis. The highest BSAF values for Ba, Mn, Sr and Ni were recorded in the gills. Cd and Cu had the highest BSAF values in the liver. Results confirmed that particular macrophyte and fish species could be a good indicator of reservoir water and sediment pollution.

Build-up and characterisation of pollutants on urban impervious surfaces.

This paper presents the results of the investigation of pollutant build-up on impervious surfaces of a parking lot in Belgrade, Serbia during the summer months. Contaminant build-up was found to be greater on asphalt surfaces directly exposed to vehicular traffic than on concrete walkways. The difference in the amounts of accumulated pollutants between asphalt and concrete were significant: for total solids (TS), total suspended solids (TSS), chemical oxygen demand (COD), heavy metals and total phosphorus (TP) accumulations were two to three times higher, while only 30% higher for total nitrogen (TN) and anions. Build-up of most of the measured parameters was best described by power functions. The highest surface loads were found for solids, COD, iron and zinc. A strong correlation was found between turbidity, TS, TSS, COD, heavy metals and phosphorus, while conductivity, nitrates and nitrites were weakly correlated to other parameters.

Prediction of fish catch in the Danube River based on long-term variability in environmental parameters and catch statistics.

The effects of physical factors on fish catch in the Serbian part of the Danube River were studied for period of six decades. The data on total catch for the Danube River from river kilometre 845 to river kilometre 1433 were collected from Statistical Office of the Republic of Serbia, while water level and water temperature data were collected from 16 water gauge stations along the investigated part of the Danube River for the period 1948-2009. Cross-correlation functions have been used to analyse the functional connection between Danube water level, water temperature and fish catch while ARMA model which combines cyclic (deterministic) and random (stochastic) components of the analysed sequences was used for the forecasts. The cross-correlation function showed negative correlation between water level and temperature as well as between water temperature and catch and positive correlation between water level and catch. The Danube water level and catch were coherent at the periods of 2.06, 4.13, 6.2, 10.33, 20.66years, while the cross correlation function between these time series did not show phase lag. The results of reconstruction and forecast of water level, temperature, and catch of fish in the Danube River, obtained by summing the cyclic and stochastic components, was used for the forecast till 2029. In 2016, seven years after, the initial forecasts were made, validity of the model was checked by obtaining data for water temperature, water level and fish catch in the Danube River for the period 2010-2015. Model gave the best prediction for water temperature; average standard error was 1.6 times higher for predicted value than for model value while for fish catch and water level they were 1.96 and 4.97, respectively. Methods used in this work could be powerful tool for prediction of fish catch and serve as the basis for better fisheries management.

Further insight into the mechanism of heavy metals partitioning in stormwater runoff.

Various particles and materials, including pollutants, deposited on urban surfaces are washed off by stormwater runoff during rain events. The interactions between the solid and dissolved compounds in stormwater runoff are phenomena of importance for the selection and improvement of optimal stormwater management practices aimed at minimizing pollutant input to receiving waters. The objective of this research was to further investigate the mechanisms responsible for the partitioning of heavy metals (HM) between the solid and liquid phases in urban stormwater runoff. The research involved the collection of samples from urban asphalt surfaces, chemical characterization of the bulk liquid samples, solids separation, particle size distribution fractionation and chemical and physico-chemical characterization of the solid phase particles. The results revealed that a negligible fraction of HM was present in the liquid phase (less than 3% by weight), while there was a strong correlation between the total content of heavy metals and total suspended solids. Examinations of surface morphology and mineralogy revealed that the solid phase particles consist predominantly of natural macroporous materials: alpha quartz (80%), magnetite (11.4%) and silicon diphosphate (8.9%). These materials have a low surface area and do not have significant adsorptive capacity. These materials have a low surface area and do not have significant adsorptive capacity. The presence of HM on the surface of solid particles was not confirmed by scanning electron microscopy and energy dispersive X-ray microanalyses. These findings, along with the results of the liquid phase sample characterization, indicate that the partitioning of HM between the liquid and solid phases in the analyzed samples may be attributed to precipitation processes.

The application of a multi-parameter analysis in choosing the location of a new solid waste landfill in Serbia.

This article presents a process of evaluation and selection of the most favourable location for a sanitary landfill facility from three alternative locations, by applying a multi-criteria decision-making (MCDM) method. An incorrect choice of location for a landfill facility can have a significant negative economic and environmental impact, such as the pollution of air, ground and surface waters. The aim of this article is to present several improvements in the practical process of landfill site selection using the VIKOR MCDM compromise ranking method integrated with a fuzzy analytic hierarchy process approach for determining the evaluation criteria weighing coefficients. The VIKOR method focuses on ranking and selecting from a set of alternatives in the presence of conflicting and non-commensurable (different units) criteria, and on proposing a compromise solution that is closest to the ideal solution. The work shows that valuable site ranking lists can be obtained using the VIKOR method, which is a suitable choice when there is a large number of relevant input parameters.

A sustainability analysis of an incineration project in Serbia.

The only option for municipal solid waste (MSW) treatment adopted so far in Serbia is landfilling. Similarly to other south-eastern European countries, Serbia is not recovering any energy from MSW. Fifty percent of electricity in Serbia is produced in coal-fired power plants with emission control systems dating from the 1980s. In this article, the option of MSW incineration with energy recovery is proposed and examined for the city of Novi Sad. A sustainability analysis consisting of financial, economic and sensitivity analyses was done in the form of a cost-benefit analysis following recommendations from the European Commission. Positive and negative social and environmental effects of electricity generation through incineration were valuated partly using conversion factors and shadow prices, and partly using the results of previous studies. Public aversion to MSW incineration was considered. The results showed that the incineration project would require external financial assistance, and that an increase of the electricity and/or a waste treatment fee is needed to make the project financially positive. It is also more expensive than the landfilling option. However, the economic analysis showed that society would have net benefits from an incineration project. The feed-in tariff addition of only €0.03 (KWh)(-1) to the existing electricity price, which would enable the project to make a positive contribution to economic welfare, is lower than the actual external costs of electricity generation from coal in Serbia.

Investigation of microbial inactivation efficiency of a UV disinfection system employing an excimer lamp.

An ultraviolet (UV) disinfection reactor based on excimer lamp technology was designed by integration of the results of numerical simulations based on computational fluid dynamics and a fluence rate (E') distribution model for cylindrical excimer lamps. The E' distribution model was developed based on a point source approach that accounts for absorption, dissipation, reflection, and refraction within the reactor system. A prototype reactor was constructed with a xenon-bromide excimer lamp and an internal spiral baffle. Experiments were conducted on the reactor to test its effectiveness for disinfection of drinking water in situations where the use of mercury-based UV sources is restricted or undesirable; a similar design approach could be used to develop an excimer UV reactor for disinfection of other fluid media, including wastewater or air.

Development and performance of a fluence rate distribution model for a cylindrical excimer lamp.

Ultraviolet disinfection systems employing excimer lamp technology represent a suitable choice in situations where lamp mercury content is restricted, or otherwise undesirable. The XeBr* excimer lamp emits nearly monochromatic radiation at 282 nm, and dose-response experiments with Bacillus subtilis spores have shown that it is germicidally effective. A numerical model was developed to describe the fluence rate (E') distribution emanating from a cylindrical XeBr* excimer lamp, based on liquid water or air as the surrounding medium. The E' distribution model is based on physical phenomena that are known to govern excimer lamps; the model also accounts for refraction, reflection, and absorbance effects of the quartz lamp envelope and the media surrounding the lamp. Measurements of the E' distribution by local actinometry supported the validity of the numerical model. This model can be used as a component (submodel) of a more general model to simulate the behavior of photochemical reactors that employ excimer lamps as their source of electromagnetic radiation.