Directly compressed rosuvastatin calcium tablets that offer hydrotropic and micellar solubilization for improved dissolution rate and extent of drug release.

The objective was to use caffeine and Soluplus® to improve the dissolution rate and to maintain a concentration of BCS Class II rosuvastatin calcium that exceeds its solubility. Caffeine and Soluplus® together substantially improved the dissolution rate and the extent of rosuvastatin release. Formulations for direct compression tablets included Formulation F1, a control with drug but with neither caffeine nor Soluplus® present; F2 with drug-caffeine complex; F3 with drug and Soluplus® and F4 with drug-caffeine complex and Soluplus®. Each formulation blend provided satisfactory flow properties. Tablets were comparable in mass, hardness and friability. A marked decrease in disintegration time occurred when the hydrotropic or micellar agent was included in the formulation. Assay (98-100%) and content uniformity (99-100%) results met requirements. Release studies in pH 1.2, 6.6, and 6.8 buffers revealed the superiority of F4. At 45 min sampling time, F3 and F4 tablets each provided a cumulative drug release greater than 70% in each medium. F2 tablets exhibited compliance to official standards in pH 6.6 and 6.8 buffers but not in pH 1.2 buffer, whereas tablets based on F1 failed in each medium. Two-factor ANOVA of the release data revealed a statistical difference across the four formulations in each release medium. Pairwise comparison of release profiles demonstrated that, of the four formulations, F4 provided the most effectively enhanced dissolution rate, improvement to the extent of drug release and support of a concentration higher than the solubility of rosuvastatin calcium.

Guar gum, xanthan gum, and HPMC can define release mechanisms and sustain release of propranolol hydrochloride.

The objectives were to characterize propranolol hydrochloride-loaded matrix tablets using guar gum, xanthan gum, and hydroxypropylmethylcellulose (HPMC) as rate-retarding polymers. Tablets were prepared by wet granulation using these polymers alone and in combination, and physical properties of the granules and tablets were studied. Drug release was evaluated in simulated gastric and intestinal media. Rugged tablets with appropriate physical properties were obtained. Empirical and semi-empirical models were fit to release data to elucidate release mechanisms. Guar gum alone was unable to control drug release until a 1:3 drug/gum ratio, where the release pattern matched a Higuchi profile. Matrix tablets incorporating HPMC provided near zero-order release over 12 h and erosion was a contributing mechanism. Combinations of HPMC with guar or xanthan gum resulted in a Higuchi release profile, revealing the dominance of the high viscosity gel formed by HPMC. As the single rate-retarding polymer, xanthan gum retarded release over 24 h and the Higuchi model best fit the data. When mixed with guar gum, at 10% or 20% xanthan levels, xanthan gum was unable to control release. However, tablets containing 30% guar gum and 30% xanthan gum behaved as if xanthan gum was the sole rate-retarding gum and drug was released by Fickian diffusion. Release profiles from certain tablets match 12-h literature profiles and the 24-h profile of Inderal(®) LA. The results confirm that guar gum, xanthan gum, and HPMC can be used for the successful preparation of sustained release oral propranolol hydrochoride tablets.