RESUMO
Transformation induced plasticity (TRIP) leads to enhancements in ductility in low stacking fault energy (SFE) alloys, however to achieve an unconventional increase in strength simultaneously, there must be barriers to dislocation motion. While stacking faults (SFs) contribute to strengthening by impeding dislocation motion, the contribution of SF strengthening to work hardening during deformation is not well understood; as compared to dislocation slip, twinning induced plasticity (TWIP) and TRIP. Thus, we used in-situ neutron diffraction to correlate SF strengthening to work hardening behavior in a low SFE Fe40Mn20Cr15Co20Si5 (at%) high entropy alloy, SFE ~ 6.31 mJ m-2. Cooperative activation of multiple mechanisms was indicated by increases in SF strengthening and γ-f.c.c. â ε-h.c.p. transformation leading to a simultaneous increase in strength and ductility. The present study demonstrates the application of in-situ, neutron or X-ray, diffraction techniques to correlating SF strengthening to work hardening.
RESUMO
Nanoindentation of three metastable dual-phase high entropy alloys (HEAs) was performed to obtain their inherent elastoplastic deformation responses. Excellent combination of hardness and elastic modulus in as-cast condition confirmed that, their inherently higher strength compared to other HEAs reported in literature, can be attributed to alloy chemistry induced phase stability. Further, hardness of 8.28 GPa combined with modulus of 221.8 GPa was obtained in Fe-Mn-Co-Cr-Si-Cu HEA by annealing the as-cast material, which is the best hardness-modulus combination obtained to date in HEAs from nanoindentation. On the other hand, although Fe-Mn-Co-Cr-Si HEA showed lower hardness and modulus than Fe-Mn-Co-Cr-Si-Al and Fe-Mn-Co-Cr-Si-Cu HEAs, the former alloy exhibited the highest strain rate sensitivity, as determined from tests performed at five different strain rates. The three alloys also had subtle differences in incipient plasticity and elastoplastic behavior, while retaining similar levels of hardness; and nanoindentation response showed microstructural dependence in friction stir processed, annealed and tensile-deformed specimens. Thus, the study highlighted that while higher strength was achieved by designing a class of HEAs with similar composition, any of the individual alloys can be tuned to obtain enhanced properties.
RESUMO
Design of multi-phase high entropy alloys uses metastability of phases to tune the strain accommodation by favoring transformation and/or twinning during deformation. Inspired by this, here we present Si containing dual phase Fe42Mn28Co10Cr15Si5 high entropy alloy (DP-5Si-HEA) exhibiting very high strength (1.15 GPa) and work hardening (WH) ability. The addition of Si in DP-5Si-HEA decreased the stability of f.c.c. (γ) matrix thereby promoting pronounced transformation induced plastic deformation in both as-cast and grain refined DP-5Si-HEAs. Higher yet sustained WH ability in fine grained DP-5Si-HEA is associated with the uniform strain partitioning among the metastable γ phase and resultant h.c.p. (ε) phase thereby resulting in total elongation of 12%. Hence, design of dual phase HEAs for improved strength and work hardenability can be attained by tuning the metastability of γ matrix through proper choice of alloy chemistry from the abundant compositional space of HEAs.
RESUMO
The potential of high-entropy alloys (HEAs) to exhibit an extraordinary combination of properties by shifting the compositional regime from the corners towards the centers of phase diagrams has led to worldwide attention by material scientists. Here we present a strong and ductile non-equiatomic HEA obtained after friction stir processing (FSP). A transformation-induced plasticity (TRIP) assisted HEA with composition Fe50Mn30Co10Cr10 (at.%) was severely deformed by FSP and evaluated for its microstructure-mechanical property relationship. The FSP-engineered microstructure of the TRIP HEA exhibited a substantially smaller grain size, and optimized fractions of face-centered cubic (f.c.c., γ) and hexagonal close-packed (h.c.p., ε) phases, as compared to the as-homogenized reference material. This results in synergistic strengthening via TRIP, grain boundary strengthening, and effective strain partitioning between the γ and ε phases during deformation, thus leading to enhanced strength and ductility of the TRIP-assisted dual-phase HEA engineered via FSP.
RESUMO
OBJECTIVE: this study was undertaken to examine and compare the effects of thrombus, thrombectomy, and thrombolysis on endothelial function as measured by endothelium-dependent vasorelaxation (EDR). METHODS: adult, male New Zealand white rabbits underwent ligation of the left common iliac to femoral artery to induce thrombosis and were then randomly assigned to one of five groups, n=6 in each. Group A consisted of ligation and thrombosis for 4 h. Group B underwent similar ligation for 4 h, but without intraluminal thrombus present. Following 4 h of ligation and thrombosis, Group C underwent thrombectomy while group D was treated with urokinase (UK), 4000 U/min for 30 min. Group E underwent UK infusion alone. The right external iliac artery served as control vessel in each group. All arteries were removed and endothelial function was determined by measuring EDR. RESULTS: the presence of thrombus reduced EDR by 50% (group A) compared to control. Vessels with interrupted flow, but not exposed to thrombus, retained normal EDR (group B). Thrombectomy decreased EDR significantly (group C) compared to thrombolysis (group D) and control. UK did not significantly alter EDR (groups D, E). CONCLUSIONS: exposure of endothelium to thrombus significantly decreases EDR. EDR was not affected by interruption of blood flow in the absence of thrombus. Thrombectomy appeared to cause a further additive insult to the endothelium. In contrast, thrombolysis with UK preserved residual endothelial function. These data suggest that it is important to differentiate the effects of thrombus on endothelium from effects due to thrombectomy or thrombolysis when evaluating treatment modalities for arterial thrombosis.
Assuntos
Endotélio Vascular/fisiologia , Trombectomia , Terapia Trombolítica , Trombose/fisiopatologia , Análise de Variância , Animais , Endotélio Vascular/efeitos dos fármacos , Endotélio Vascular/ultraestrutura , Artéria Femoral/efeitos dos fármacos , Artéria Femoral/patologia , Artéria Femoral/cirurgia , Artéria Ilíaca/efeitos dos fármacos , Artéria Ilíaca/patologia , Artéria Ilíaca/cirurgia , Ligadura , Masculino , Microscopia Eletrônica de Varredura , Ativadores de Plasminogênio/administração & dosagem , Coelhos , Distribuição Aleatória , Trombose/tratamento farmacológico , Trombose/cirurgia , Ativador de Plasminogênio Tipo Uroquinase/administração & dosagem , Vasodilatação/fisiologiaRESUMO
211 sera obtained from domestic animals generally used for human consumption in this area, were tested for Toxoplasma antibodies by the Indirect Haemagglutination Test (IHA). Goat (34.4%) and pig sera (26.6%) showed a higher prevalence as compared to cattle (16.6%) and sheep (7.4%). Obviously, proper precautions at every stage of the preparation of a meat dish are necessary to avoid Toxoplasma infection.