Laser-induced electron transfer desorption/ionization on MoO3 and WO3 surfaces for the determination of dithiocarbamates.

Surface layers of molybdenum oxide MoO3 and tungsten oxide WO3 produced by thermal oxidation of molybdenum and tungsten plates in the air were studied for the first time as a platform for laser-induced electron transfer desorption/ionization. High analytical performance of such layers for the determination of metal complexes with dithiocarbamates, such as tetramethylthiuram disulfide, tetraethylthiuram disulfide, and diethyldithiocarbamate, has been demonstrated. All studied complexes are detected as radical cations, with no fragment ions. The ion yields from MoO3 and WO3 surfaces were found to be more than two orders of magnitude higher than those from nanocrystalline silicon surfaces. A novel method has been developed for the determination of trace amounts of dithiocarbamates based on the complexation of analytes with gold ions, followed by laser-induced electron transfer desorption/ionization. The limits of detection of dithiocarbamates were estimated to be about 1 ng/mL. The proposed method was successfully applied to the rapid screening of tetramethylthiuram disulfide residues in juice.

Silicon surface assisted laser desorption ionization mass spectrometry for quantitative analysis.

The approach to quantitative analysis by silicon Surface Assisted Laser Desorption Ionization Mass Spectrometry (Si-SALDI) is proposed. The approach is based on the new method for forming an active surface layer on a silicon substrate by exposing to laser radiation directly in the ion source of a mass spectrometer. The method can be used repeatedly on the same substrate, providing high reproducibility of its surface ionization properties and high ionization efficiency of organic compounds. Within the proposed approach, the methods of improvement of signal reproducibility are also considered, including continuous monitoring of the silicon surface ionization properties using a Knudsen effusion cell; scanning the surface of a silicon substrate with a laser beam; selecting the optimal value of laser fluence and using a reproducible sample introduction technique. It is demonstrated that this approach can be successfully applied to quantify clinically relevant concentrations of pharmaceutical drugs in extracts of blood.

Ionization of organic molecules with metal ions formed in the laser plasma.

A laser plasma ion source was used to ionize volatile organic compounds in a gas sample. The plasma was generated on a metal target in the intermediate vacuum region of ~0.3 Torr using a pulsed Nd:YAG laser with a wavelength of 1 µm. The resulting ions mass spectra were acquired using orthogonal time-of-flight mass spectrometer (O-TOF MS). When using a copper target, the ions formed are simple complexes (CuM+ ) of copper ions with organic molecules. The possibility of online identification of trace amounts of alkanes in nitrogen and air, with a detection limit of ~10 ppb, was demonstrated. The ionization efficiency of volatile organic compounds through the formation of clusters with metal ions is 10-4 in terms of the quasimolecular complex ions. The rate constants of ion-molecular reactions of copper ions with octane and water molecules in nitrogen and air are estimated.