RESUMO
This paper presents a modified fatigue life model of the Basquin equation using the stress parameter of the magnetic flux leakage signal. Most pipeline steels experience cyclic loading during service and the influence of the load history makes assessing fatigue behaviour more difficult. The magnetic flux leakage signal's response to a uniaxial cyclic test of API X65 steel was measured with eight levels of ultimate tensile stress loads. The influence of dH(y)/dx on fatigue failure was the main concern in this study, the aim being to represent localised stress parameters in the modified Basquin equation. Both fatigue lives, experimental and predicted from the modified Basquin equation, were validated through reliability analysis, producing a 60% value when approaching 1.8 × 105 cycles. The fatigue data from the experiment produced a higher mean-cycle-to-failure value than the prediction data, with slightly different values of 3.37 × 105 and 3.28 × 105. Additionally, the modified Basquin equation's predicted and the experimental fatigue lives were found to have a high R2 correlation value of 0.9022. The Pearson correlation also showed a good relationship between the fatigue lives, with an r value of 0.9801. Finally, the modified Basquin equation based on dH(y)/dx signals provided an accurate and alternative method for durability assessment.
RESUMO
As industrial globalisation and waste output continue to grow, solid waste management is one of the most pressing worldwide environmental challenges. Solid wastes include both the heterogeneous mass of urban throwaways and the homogeneous accumulations of agricultural, industrial, and mineral wastes. Clinical waste (CW) has a significant negative influence on both human health and the environment. To dispose hazardous CW, a proper waste management system should be necessary, and incineration should be the best possible option for reducing the volume of this hazardous waste. Incineration is being developed in Malaysia as a means of disposing clinical and hazardous waste. Currently, 170 common CW treatment facilities with 140 incinerators are accessible around the country. The combustion procedure kills pathogens and reduces waste volume and weight, but it leaves a solid residue known as clinical waste ash (CWA), which raises heavy metal, inorganic salt, and organic compound levels in the environment. Because metals are not eliminated during incineration, dumping CWA in a landfill could contaminate groundwater. Leachate is the liquid created when waste decomposes in a landfill and water filters through it. The most common method of disposing of CW ashes is to transfer them to a landfill. Landfills should install a top cover after closure for hazardous waste landfills. Due to a lack of space and the high expense of land disposal, recycling technologies and the reuse of ash in various systems have developed. Clinical waste incineration fly ash (CWIFA), a solid waste substance from CW incineration, typically includes mobile heavy metals and can cause significant pollution when reused. The standard requirement for removing CWIFA in dumpsites should be below the metal limit stated by the U.S. Environmental Protection Agency (USEPA). Much recent research on the usage of CWIFA has concentrated on mitigating their effects on the environment. Several studies have confirmed the utilisation of CWIFA in the construction field and agriculture to reduce the leaching of its hazardous components into the environment. Compressive strength decreased with the percentage amount of CWIFA due to the substitution of cement with CWIFA. CWIFA mix with 20% cement is the broad-scale application of CWIFA for geotechnical constructions. Heavy metals (Cd, Cu, Ni, Pb, and Zn) are strongly immobilised by the cementitious matrix. Solidification/stabilisation (S/S) materials can be dumped in landfills with less environmental protection than untreated waste. When utilising a CWIFA in mortar, the primary environmental concern is if any harmful materials leach out during the initial curing process or throughout the life of the mortar. Toxicity characteristic of leaching procedure (TCLP) analysis of all CWIFA specimens found amounts of heavy metals below regulatory limits. Solidification of waste with cement and solidified waste has become a popular way of minimising the atmosphere's emissions. The amount of CWIFA generated is expected to increase nationally and globally. There is an immediate need for further evaluation of ash leachate investigations for proper disposal and usage of ash in construction materials.