Thermal effect on the geo-engineering characteristics of a rock salt.

Rock salt caverns are considered one of the best hosts to store oil, natural gas, radioactive and toxic wastes due to their low permeability, self-healing characteristics and wide distribution on the Earth. Stored nuclear waste in rock salts will radiate for many years. Therefore, the thermal energy and also temperature in the host environment will increase depending on time. In this study, P-wave velocity (Vp), Brazilian tensile strength (σt), uniaxial compression strength (σc) of Çankiri rock salt were investigated under different temperatures ranging from 20°C to 250°C since the temperature is a factor that causes changes in some physical and geo-mechanical properties of rocks. The acoustic emission technique was utilized during uniaxial compression strength tests, to monitor the crack accumulation. Additionally, X-ray micro-computed tomography technique was employed to observe the microstructure and determine the porosity of rock salt samples depending on the temperature. The Vp and the σt of Çankiri rock salt decrease with increasing temperatures of samples whereas the σc increases. The ductility of rock salt tends to increase with augmented temperature and the axial strain at the ultimate stress level is 2.96% at 20°C whereas it reaches up to 6.29% at 250°C. The AE activity of rock salt generates at the early stages of loading and AE count prominently increases with the increasing temperature of samples. Therefore, the stress levels of crack initiation (σi) and crack damage (σcd) thresholds were reached earlier than the previous one with each temperature increment. According to X-ray micro-CT images of rock salts, the number of cracks increased markedly in thermally treated rock salt samples and therewith the porosity increases from 1.12% to 2.73% with an increase in temperature from 50°C to 250°C.

Removal of naproxen from wastewater using chitosan-aerogel-activated carbon biocomposites: Theory, equilibrium, kinetics, thermodynamics, and process optimization.

This study investigated the performance of chitosan-aerogel-activated carbon (CHT:AEO:AC) biocomposite as an adsorbent for the removal of naproxen from wastewater. Naproxen removal in % was 99, 33, 62, and 90 using 300 mg of raw AC, raw CHT, CHT:AEO, and CHT:AEO:AC, respectively. Langmuir, Freundlich, Dubinin-Radushkevich (D-R), and Temkin isotherm models were used to obtain adsorption isotherms. Chi-squared (χ2 ) and correlation coefficients (R2 ) values showed that the parameters of the Freundlich, Temkin, and D-R models were more suitable for naproxen adsorption than the Langmuir model for raw CHT, CHT:AEO, and CHT:AEO:AC, whereas the Langmuir model fitted well for raw AC. The adsorption of naproxen onto biocomposites was defined by pseudo-second-order kinetic model, and adsorption rate constants were 0.245, 0.036, 0.075, and 0.147 mg g-1  min-1 for raw AC, raw CHT, CHT:AEO, and CHT:AEO:AC, respectively. The impact of optimum process conditions on naproxen adsorption was explored using response surface methodology. The optimum independent variables were 288.94 mg, 29.64°C, and 372.5 min, leading to a rate of naproxen removal onto CHT:AEO:AC of 90.29%. PRACTITIONER POINTS: Naproxen adsorption from wastewater using chitosan-aerogel-activated carbon biocomposite (CHT:AEO:AC) was investigated. The effects of the amount of biocomposite, temperature, and time on the adsorption were investigated. Optimization of the process conditions was carried out using the response surface methodology.

Activated carbon embedded alginate beads for removing nonsteroidal anti-inflammatory drug naproxen from wastewater: equilibrium, kinetics, thermodynamics, desorption, and reusability.

In the present study, activated carbon/alginate (AC/ALG) beads were successfully synthesized with different AC:ALG ratios of 1.0-3.0 (w/v) and used for the adsorption of the nonsteroidal anti-inflammatory drug naproxen from wastewater. The beads were characterized by Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and Brunauer-Emmett-Teller (BET) analysis, and adsorbent dosage, initial pH, initial naproxen concentration, and contact time in removal efficiency were investigated. Maximum naproxen removal percentage was achieved using 350 mg of AC/ALG beads with a ratio of 3.0% (w/v) within six hours and naproxen removal performance was determined to be 98.0%. Freundlich, Temkin, and Dubinin-Radushkevich (D-R) isotherm models were fitted to the equilibrium data better than the Langmuir model. According to kinetics results, the equilibrium time for the AC/ALG beads was reached in four hours and the kinetic model was determined by the pseudo-second-order equation. The thermodynamic parameters were calculated and enthalpy of naproxen adsorption was found to be positive for all AC/ALG beads. After the adsorption process the beads can easily be regenerated by ethanol and reused within seven cycles.

Bone complications after pelvic radiation therapy: evaluation with MRI.

INTRODUCTION: The purpose of this study was to assess the incidence, distribution and MRI characteristics of pelvic bone complications after radiation therapy. METHODS: The medical charts of 345 patients who received pelvic radiation therapy were retrospectively reviewed. A total of 122 patients, 99 women and 23 men, with a mean age of 57 (range 32-87 years) were included in this study. The MR images were retrospectively reviewed by two radiologists. RESULTS: Fatty replacement of bone marrow was seen in all patients. Pelvic bone complications and focal red marrow changes were identified in a total of 38 patients (31.1%). Pelvic insufficiency fracture was diagnosed in 17 patients (13.9%, with a total of 64 lesions) and radiation osteitis was diagnosed in 5 patients (4.1%, with a total of 13 lesions). Avascular necrosis of the femoral head was detected in one patient (0.8%). Focal red bone marrow changes were seen in 15 patients (12.3%). The median time from the end of radiotherapy to the diagnosis of pelvic bone complications or changes was 25 months (range 2-45 months). The 1-, 2-, and 3-year cumulative incidences were 22%, 41% and 49%, respectively. The distribution of insufficiency fractures was as follows: sacral ala, sacral body, ilium, acetabulum, pubis and lumbar spinal vertebra. The distribution of radiation osteitis was as follows: sacral ala, ilium and pubis. CONCLUSION: Radiation-induced pelvic bone complications are not uncommon, and knowledge of characteristic imaging patterns is essential in order to rule out bone metastases and to avoid inaccurate or excessive treatment.