RESUMO
Aqueous zinc-bromine batteries hold immense promise for large-scale energy storage systems due to their inherent safety and high energy density. However, achieving a reliable zinc metal electrode reaction is challenging because zinc metal in the aqueous electrolyte inevitably leads to dendrite growth and related side reactions, resulting in rapid capacity fading. Here, it is reported that combined cationic and anionic additives in the electrolytes using CeCl3 can simultaneously address the multiple chronic issues of the zinc metal electrode. Trivalent Ce3+ forms an electrostatic shielding layer to prevent Zn2+ from concentrating at zinc metal protrusions, while the high electron-donating nature of Cl- mitigates H2O decomposition on the zinc metal surface by reducing the interaction between Zn2+ and H2O. These combined cationic and anionic effects significantly enhance the reversibility of the zinc metal reaction, allowing the non-flow aqueous ZnâBr2 full-cell to reliably cycle with exceptionally high capacity (>400 mAh after 5000 cycles) even in a large-scale battery configuration of 15 × 15 cm2.
RESUMO
Herein, a novel combination of Mg- and Ga-co-doped ZnO (MGZO)/Li-doped graphene oxide (LGO) transparent electrode (TE)/electron-transporting layer (ETL) has been applied for the first time in Cu2 ZnSn(S,Se)4 (CZTSSe) thin-film solar cells (TFSCs). MGZO has a wide optical spectrum with high transmittance compared to that with conventional Al-doped ZnO (AZO), enabling additional photon harvesting, and has a low electrical resistance that increases electron collection rate. These excellent optoelectronic properties significantly improved the short-circuit current density and fill factor of the TFSCs. Additionally, the solution-processable alternative LGO ETL prevented plasma-induced damage to chemical bath deposited cadmium sulfide (CdS) buffer, thereby enabling the maintenance of high-quality junctions using a thin CdS buffer layer (≈30 nm). Interfacial engineering with LGO improved the Voc of the CZTSSe TFSCs from 466 to 502 mV. Furthermore, the tunable work function obtained through Li doping generated a more favorable band offset in CdS/LGO/MGZO interfaces, thereby, improving the electron collection. The MGZO/LGO TE/ETL combination achieved a power conversion efficiency of 10.67%, which is considerably higher than that of conventional AZO/intrinsic ZnO (8.33%).
RESUMO
Uncontrollable Zn dendrite formations and parasitic side reactions on Zn electrodes induce poor cycling stability and safety issues, preventing the large-scale commercialization of Zn-ion batteries. Herein, to achieve uniform Zn deposition and suppress side reactions, an electrospun ferroelectric poly(vinylidene fluoride-co-trifluoroethylene) copolymer, a P(VDF-TrFE) nanofiber layer, is introduced as an artificial solid-electrolyte interface on a Cu substrate acting as a current collector. The aligned molecular structure of ß-P(VDF-TrFE) can effectively suppress localized current density on the Cu surface, lead to uniform Zn deposition, and suppress side reactions by preventing direct contact between electrodes and aqueous electrolytes. The half-cell configuration formed by the newly fabricated electrode can achieve an average coulombic efficiency of 99.2% over 300 cycles without short-circuiting at a current density of 1 mA cm-2 and areal capacity of 1 mAh cm-2. Stable cycling stability is also maintained for 200 cycles at a current density of 0.5 A g-1 in a full-cell test using MnO2 as a cathode.
RESUMO
BACKGROUND: Barley straw (Hordeum vulgare L.) is an attractive lignocellulosic material and one of the most abundant renewable resources for fuel ethanol production. Although it has high cellulose and hemicellulose contents, there are several challenges and limitations in the process of converting it to fuel ethanol. High ash, silica and lignin contents in barley straw make it an inferior feedstock for enzymatic hydrolysis. Therefore pretreatment of barley straw could play an important role in inducing structural and compositional changes that increase the efficiency of enzymatic hydrolysis and make the whole process economically viable. RESULTS: Saccharification was enhanced using various concentrations (0.0, 0.5, 1.0, 2.0 and 3.0% v/v) of a solution of sodium hypochlorite (NaClO) and hydrogen peroxide (H2O2) and various reaction times (15, 30 and 45 min) during pretreatment at 121 °C. The highest yield of glucose (447 mg g⻹) was achieved by pretreatment with 2.0% NaClO+H2O2 solution for 30 min, representing an increase of 65.99% compared with untreated barley straw (152 mg g⻹). During fermentation, the highest amount of ethanol (207 mg g⻹) was obtained under anaerobic plus 0.4 mmol L⻹ benzoic acid conditions, representing an increase of 57.49, 38.16 and 10.14% compared with untreated sample (88 mg g⻹), aerobic (128 mg g⻹) and anaerobic (186 mg g⻹) conditions respectively. CONCLUSION: The results suggest that pretreatment with 2.0% NaClO+H2O2 solution disrupted the recalcitrant structure of barley straw and enhanced the glucose yield and subsequent bioethanol production.