Surface Planarization-Epitaxial Growth Enables Uniform 2D/3D Heterojunctions for Efficient and Stable Perovskite Solar Modules.

Two-dimensional/three-dimensional (2D/3D) halide perovskite heterojunctions are widely used to improve the efficiency and stability of perovskite solar cells. However, interfacial defects between the 2D and 3D perovskites and the poor coverage of the 2D capping layer still hinder long-term stability and homogeneous charge extraction. Herein, a surface planarization strategy on 3D perovskite is developed that enables an epitaxial growth of uniform 2D/3D perovskite heterojunction via a vapor-assisted process. The homogeneous charge extraction and suppression of interfacial nonradiative recombination is achieved by forming a uniform 2D/3D interface. As a result, a stabilized power output efficiency of 25.97% is achieved by using a 3D perovskite composition with a bandgap of 1.55 eV. To demonstrate the universality of the strategy applied for different perovskites, the champion device based on a 1.57 eV bandgap 3D perovskite results in an efficiency of 25.31% with a record fill factor of 87.6%. Additionally, perovskite solar modules achieve a designated area (24.04 cm2) certified efficiency of 20.75% with a high fill factor of 80.0%. Importantly, the encapsulated uniform 2D/3D modules retain 96.9% of the initial efficiency after 1246 h operational tracking under 65 °C (ISOS-L-3 protocol) and 91.1% after 862 h under the ISOS-O-1 protocol.

Lead Iodide Redistribution Enables In Situ Passivation for Blading Inverted Perovskite Solar Cells with 24.5% Efficiency.

Blade-coating stands out as an alternative for fabricating scalable perovskite solar cells. However, it demands special control of the precursor composition regarding nucleation and crystallization and currently exhibits lower performance than the spin-coating process. It is mainly the resulting film morphology and excess lead iodide (PbI2) distribution that influences the optoelectronic properties. Here, the effectiveness of introducing N-Methyl-2-pyrrolidone (NMP) to regulate the structure of the perovskite layer and the redistribution of PbI2 is found. The introduction of NMP leads to the accumulation of excess PbI2, mainly on the top surface, reducing residual PbI2 at the perovskite buried interface. This not only facilitates the passivation of perovskite grain boundaries but also eliminates the potential degradation of the PbI2 triggered by light illumination in the perovskite buried interface. The optimized NMP-modified inverted perovskite solar cell achieves a champion efficiency of 24.5%, among the highest reported blade-coated perovskite solar cells. Furthermore, 13.68 cm2 blading perovskite solar modules are fabricated and demonstrate an efficiency of up to 20.4%. These findings underscore that with proper modulation of precursor composition, blade-coating can be a feasible and superior alternative for manufacturing high-quality perovskite films, paving the way for their large-scale applications in photovoltaic technology.