Simulated and measured piezoelectric energy harvesting of dynamic load in tires.

From 2007 in US and from 2022 in EU it is mandatory to use TPMS monitoring in new cars. Sensors mounted in tires require a continuous power supply, which currently only is from batteries. Piezoelectric energy harvesting is a promising technology to harvest energy from tire movement and deformation to prolong usage of batteries and even avoid them inside tires. This study presents a simpler method to simultaneous model the tire deformation and piezoelectric harvester performance by using a new simulation approach - dynamic bending zone. For this, angular and initial velocities were used for rolling motion, while angled polarization was introduced in the model for the piezoelectric material to generate correct voltage from tire deformation. We combined this numerical simulation in COMSOL Multiphysics with real-life measurements of electrical output of a piezoelectric energy harvester that was mounted onto a tire. This modelling approach allowed for 10 times decrease in simulation time as well as simpler investigation of systems parameters influencing the output power. By using experimental data, the simulation could be fine-tuned for material properties and for easier extrapolation of tire deformation with output harvested energy from simulations done at low velocity to the high velocity experimental data.

Removal of chloride from fly ash produced in hazardous waste incineration by leaching and displacement washing in a vertical filter press.

Fly ash is generated in large quantities by waste incineration processes. Chloride is commonly present in the fly ash produced by the incineration of hazardous materials, such as polyvinylchloride plastic. Major difficulties related to the disposal and handling of fly ash include the high concentration of easily leachable chlorides, heavy metals and toxic compounds. In order to avoid adverse environmental effects from the disposal of fly ash, the content of soluble chlorides must be reduced. One of the most effective options for chloride removal is leaching and displacement washing in a filter press. The primary aim of this study was to obtain efficient removal of chloride from fly ash by utilizing a leaching and displacement washing process, carried out in a filter press. The secondary objective was to obtain high filtration capacities and low filter cake moisture contents. The slurry was prepared by mixing fly ash with water at an ash:water ratio of 1:2 and filtered to separate the solids from the liquid. After solid-liquid separation, most of the dissolved residual chloride was removed from the filter cake by washing the cake with fresh water in the second stage of separation. It was possible to remove up to 98% of the total chloride and to obtain sufficient filtration capacities. The residual moisture content of the filter cakes varied from 22 to 35 wt%, which meant that the cakes could be disposed of in landfill, or possibly utilized as a construction material.