Enhanced Interface Adhesion by Novel Eco-Epoxy Adhesives Based on the Modified Tannic Acid on Al and CFRP Adherends.

This paper presents a new process for obtaining eco-epoxide adhesives synthesized from bio-renewable raw material (tannic acid-TA) and used for bonding lightweight materials (aluminum (Al) and carbon fiber reinforced polymer (CFRP)). Two synthesized bio-epoxy components based on TA, (A) glycidyl ether and (B) glycidyl phosphate ester of TA, were used as a replacement for the toxic epoxy component based on Bisphenol A. The effect of eco-epoxy components on the interface adhesion was measured by the determination of adhesion parameter b, which was compared to the reference epoxy (REF). The increase of adhesion parameter b was 77.5% for A and 151.5% for B. The adhesion of both eco-adhesives was tested using the bell peel test (BPT) with the Al and CFRP adherends. When compared to REF, the average peel load for B was 17.6% (39.3%) and 58.3% (176.9%) higher for the Al and CFRP adherends, respectively. Complete adhesion failure of REF reflected the weak adhesion to both Al and CFRP, which was improved by the addition of eco-epoxy components A and B showing the presence of cohesive failure. The microhardness testing method of interface adhesion was proven to be a fast and reliable testing method, providing a qualitative indication in adhesive selection.

A new experimental methodology for assessing adhesive properties shows that Neandertals used the most suitable material available.

The use of adhesives for hafting stone tools at least 191 ka was a major technological development. Stone tools could be more securely attached to handles, thus improving their efficiency and practicality. To produce functional adhesives required forethought and planning, as well as expertise and knowledge of the resources available in the landscape. This makes adhesives important in discussions about Neandertal and early modern human technological and mental capabilities. However, we currently know very little about how these early adhesive materials behaved under different circumstances, or why certain materials were used and others were not. Here we present the results of controlled laboratory bulk property tests (hardness, rheology and thermogravimetric analysis) on replica Paleolithic adhesives. We conclude that birch tar is more versatile, has better working properties, and is more reusable than pine resin, the most likely alternative material. Neandertals may therefore have invested more time and resources to produce birch tar because it was the best material available, both functionally and economically, throughout the majority of Europe during the Middle to Late Pleistocene. Our results further demonstrate that Neandertals had high levels of technological expertise and knowledge of the natural resources available to them in their environment.