Electrically Induced Structural Transformations of a Chiral Nematic under Tangential-Conical Boundary Conditions.

In this study, structural transformations induced by an electric field in the chiral nematic under tangential-conical boundary conditions have been considered. The composition influence of the orienting polymer films on the director tilt angles, the formation of orientational structures in the LC layer, as well as the electro-optical response and relaxation processes have been studied. It has been shown that the poly(tert-butyl methacrylate) concentration change in the orienting polymer mixture allows for smoothly controlling the director tilt angle without fixing its azimuthal orientation rigidly.

Nematic Structures under Conical Anchoring at Various Director Tilt Angles Specified by Polymethacrylate Compositions.

Dependence of the director tilt angle of nematic liquid crystal (LC) under conical anchoring from the two-component polymer mixture composition has been studied. We varied the ratio of poly(isobutyl methacrylate) (PiBMA), which specifies a conical anchoring for the nematic liquid crystal LN-396, and poly(methylmethacrylate) (PMMA) assigning a tangential alignment for the same nematic. An oblique incidence light technique to determine a tilt angle has been used. It has been shown that the tilt angle increases from 0∘ to 47.7∘ when PiBMA:PMMA ratio changes in the range 30:70 to 100:0. The specific optical textures viewed under the polarizing microscope and proper orientational structures have been considered for various compositions of the polymer films. An electric field action on the formed orientational structures has been investigated. The obtained results are promising for the application in various electro-optical LC devices with a conical anchoring in which the director tilt angle is a crucial parameter: a controlled diffraction gratings, an electrically operated achromatic rotators of linear light polarization, etc.

Electrically induced transformations of defects in cholesteric layer with tangential-conical boundary conditions.

Electric-field-induced changes of the orientational structures of cholesteric liquid crystal layer with the tangential-conical boundary conditions have been investigated. The samples with the ratio of the cholesteric layer thickness d to the helix pitch p equalled to 0.57 have been considered. The perpendicularly applied electric field causes a decrease of the azimuthal director angle at the substrate with the conical surface anchoring. In the cells with d = 22 µm, the defect loops having the under-twisted and over-twisted areas are formed. At the defect loop the pair of point peculiarities is observed where the 180° jump of azimuthal angle of the director occurs. Under the action of electric field the loops shrink and disappear. In the cells with d = 13 µm, the over-twisted and under-twisted defect lines are formed. Applied voltage results in the shortening of lines or/and their transformation into a defect of the third type. The director field distribution near defect lines of three types has been investigated by the polarising microscopy techniques. It has been revealed that the length ratio between the over-twisted and third-type defect lines can be controlled by the electric field.

Orientational structures in cholesteric droplets with homeotropic surface anchoring.

The dependency of orientational structures in cholesteric droplets with homeotropic surface anchoring on the helicity parameter has been studied by experiment and simulations. We have observed a sequence of structures, in which the director configurations and topological defects were identified by comparison of polarized microscopy pictures with simulated textures. A toron-like and low-symmetry intermediate layer-like structures have been revealed and studied in detail. The ranges of stability of the observed structures have been summarized in a general diagram and explained by the helicity parameter dependence of the free energy terms.

Bipolar configuration with twisted loop defect in chiral nematic droplets under homeotropic surface anchoring.

Optical textures and appropriate orientational structures have been studied within droplets of chiral nematic dispersed in polymer assigning the homeotropic anchoring. The helix axis of the chiral structure inside droplets forms the bipolar configuration. The optical droplet textures were analysed in the unpolarised light, analyser switching-off scheme and in crossed polarisers. The twisted loop defect reveals itself convincingly in all schemes. Its appearance at the optical patterns of the chiral nematic droplets has been examined depending on their size and the aspect direction. The existence of the defect has been verified by the structural and optical calculations. The effect of an electric field on both the defect line shape and the orientational structure of chiral nematic has been studied.