Application of soil magnetometry and geochemical methods to investigate soil contamination with antimony.

The aim of the study was an assessment of the pollution level and identification of the antimony sources in soils in areas subjected to industrial anthropopressure from: transport, metallurgy and electrical waste recycling. The combination of soil magnetometry, chemical analyzes using atomic spectrometry (ICP-OES and ICP-MS), Sb fractionation analysis, statistical analysis (Pearson's correlation matrix, factor analysis) as well as Geoaccumulation Index, Pollution Load Index, and Sb/As factor allowed not only the assessment of soil contamination degree, but also comprehensive identification of different Sb sources. The results indicate that the soil in the vicinity of the studied objects was characterized by high values of magnetic susceptibility and thus, high contents of potentially toxic elements. The most polluted area was in the vicinity of electrical waste processing plants. Research has shown that the impact of road traffic and wearing off brake blocks, i.e. traffic anthropopression in general, has little effect on the surrounding soil in terms of antimony content. Large amounts of Pb, Zn, As and Cd were found in the soil collected in the vicinity of the heap after the processing of zinc-lead ores, the average antimony (11.31 mg kg-1) content was lower in the vicinity of the heap than in the area around the electrical and electronic waste processing plant, but still very high. Antimony in the studied soils was demobilized and associated mainly with the residual fraction.

Studies on the Content of Selected Technology Critical Elements (Germanium, Tellurium and Thallium) in Electronic Waste.

The article draws attention to the problem of the presence of metals: germanium (Ge), tellurium (Te), thallium (Tl), and others (Cd, Ba, Co, Mn, Cr, Cu, Ni, Pb, Sr, and Zn) in selected waste of electrical and electronic equipment (WEEE). As a result of the growing demand for new technologies, the global consumption of TECs has also been increasing. Thus, the amount of metals in circulation, of which the impacts on the environment have not yet been fully understood, is constantly increasing. Due to the low content of these metals in WEEE, they are usually ignored during e-waste analyses. The main aim of this study was to determine the distribution of Ge, Te, and Tl (and other elements) in ground sieve fractions (1.0, 0.5, 0.2, and 0.1 mm) of selected electronic components (solar lamps, solar cell, LED TV screens, LCD screens, photoresistors, photodiodes, phototransistors) and to determine the possible tendency of the concentrations of these metals in fractions. This problem is particularly important because WEEE recycling processes (crushing, grinding, and even collection and transport operations) can lead to dispersion and migration of TCE pollutants into the environment. The quantitative composition of e-waste was identified and confirmed by ICP-MS, ICP-OES and SEM-EDS, and XRD analyses. It was found that Ge, Te, and Tl are concentrated in the finest fractions of ground e-waste, together with Cd and Cr, which may favor the migration of these pollutants in the form of dust during storage and processing of e-waste.

Application of Mössbauer Spectroscopy for Identification of Iron-Containing Components in Upper Silesian Topsoil Being under Industrial Anthropopressure.

The main objective of the presented preliminary study was the identification of iron-containing phases. Iron-containing phases had accumulated in organic topsoil horizons collected from an area that has long been affected by the steel industry and emissions from power plants. X-ray diffraction and Mössbauer spectroscopy methods were used for the determination of the iron-containing mineral phases in topsoil subsamples which, after two-staged separation, varied in terms of magnetic susceptibility and granulometry. The Mössbauer spectra were recorded using paramagnetic and magnetic components, although the latter occurred only in the strongly magnetic fraction. The central part of spectra was fitted by two doublets (D1 and D2), which were identified as aluminosilicates. Simultaneously, the experimental spectra were described using several Zeeman sextets (Z1, Z2, and Z3) corresponding to the occurrence of hematite and magnetite-like phases with iron in tetrahedral and octahedral sites. Identification of magnetic phases in the tested material, including hematite, led to the conclusion that soil contamination in the studied area was presumably caused by emissions from a nearby power plant. Magnetite-like phases with a different iron content detected in topsoil samples could be related to metallurgical and coking processes, reflecting the specificity of the industrial area from which the samples were taken. The specific composition of the iron-containing aluminosilicates also illustrated the intense and long-lasting impact of the steel and coking industries on the studied area.

Geochemical characteristics of solid particles deposited on experimental plots established for traffic pollution monitoring in different countries.

The main aim of this research was to identify the mineralogical, morphological, and chemical characteristics of solid particles emitted by vehicular traffic and deposited on special monitoring plots located on the roadside of five countries with different climatic conditions and traffic structure. Within 24 months of exposure, the composition of the matrix used at the monitoring plots changed. Percentage quartz content decreased in all locations, and due to the input from local sources, the share of other mineral phases increased. In some locations, an increase in the share of mineral phases associated with local parent rock and soil erosion was noted (e.g. Helsinki, Böblingen). In other places, material associated with abrasion of the road surface was characteristic (e.g. Gliwice, Opole). The composition of pollutants accumulated at all the monitoring plots was varied, however the common feature was the presence of technogenic magnetic particles in the matrix after exposure. Analyses showed that numerous irregular, angular particles of iron oxides with porous surface, which are carriers for a number of metals and metalloids were present in the samples. Angular iron oxides containing zinc, chromium, and copper are usually considered as non-exhaust traffic emissions. Another type of iron oxides particles found in the samples were magnetic spherules related to exhaust emissions (smaller spherules, < 20 µm). Study of results confirmed the effectiveness of the testing method for roadside pollution monitoring related to currently emitted solid particles accumulated on matrix of known mineral composition.

Magnetic susceptibility of spider webs as a proxy of airborne metal pollution.

The purpose of this pilot study was to test spider webs as a fast tool for magnetic biomonitoring of air pollution. The study involved the investigation of webs made by four types of spiders: Pholcus phalangioides (Pholcidae), Eratigena atrica and Agelena labirynthica (Agelenidae) and Linyphia triangularis (Linyphiidae). These webs were obtained from outdoor and indoor study sites. Compared to the clean reference webs, an increase was observed in the values of magnetic susceptibility in the webs sampled from both indoor and outdoor sites, which indicates contamination by anthropogenically produced pollution particles that contain ferrimagnetic iron minerals. This pilot study has demonstrated that spider webs are able to capture particulate matter in a manner that is equivalent to flora-based bioindicators applied to date (such as mosses, lichens, leaves). They also have additional advantages; for example, they can be generated in isolated clean habitats, and exposure can be monitored in indoor and outdoor locations, at any height and for any period of time. Moreover, webs are ubiquitous in an anthropogenic, heavily polluted environment, and they can be exposed throughout the year. As spider webs accumulate pollutants to which humans are exposed, they become a reliable source of information about the quality of the environment. Therefore, spider webs are recommended for magnetic biomonitoring of airborne pollution and for the assessment of the environment because they are non-destructive, low-cost, sensitive and efficient.

Integration of soil magnetometry and geochemistry for assessment of human health risk from metallurgical slag dumps.

The main objective of the study was an assessment of the pollution level of agricultural land located close to dumps of industrial waste remaining after former Zn and Pb ore processing in Poland. The integrated geophysical-geochemical methods were applied for assessment of soil quality with respect to trace element pollution. Additionally, human health risk induced by the contaminated arable soil and dusting slag heap was estimated. The investigations pointed out that soils in the vicinity of the metallurgical slag dump in Piekary were heavily polluted. Spatial distribution of magnetic susceptibility corresponding well with distribution of the content of potentially toxic elements indicated the local "pollution hotspots." Proper geophysical and geochemical data interpretation supported by statistical factor analysis enabled identification of three different sources of pollution including metallurgical slug dump as a main source, but also traffic pollution influencing the area located along the busy road and relatively strong influence of the geochemical background. Computed health hazard index revealed no adverse health effect to the farmers cultivating arable soil, but in the direct vicinity of dusting, slag dump health risk occurred, caused mostly by very toxic elements as As and Tl. In the future, investigation should be focused on contribution of different sources to the heavy metal pollution in soil-crop system in this area. It should be highlighted that a site-specific approach should be taken in order to redevelop this kind of area in order to reduce ecological and human health threat. The study proved the integrated two-stage geophysical-geochemical method to be a feasible, reliable, and cost-effective tool for identification of the extent of soil pollution and areas at risk.

Geostatistical Microscale Study of Magnetic Susceptibility in Soil Profile and Magnetic Indicators of Potential Soil Pollution.

Directional variograms, along the soil profile, can be useful and precise tool that can be used to increase the precision of the assessment of soil pollution. The detail analysis of spatial variability in the soil profile can be also an important part of the standardization of soil magnetometry as a screening method for an assessment of soil pollution related to the dust deposition. The goal of this study was to investigate the correlation between basic parameters of spatial correlations of magnetic susceptibility in the soil profile, such as a range of correlation and a sill, and selected magnetometric indicators of soil pollution. Magnetic indicators were an area under the curve of magnetic susceptibility versus a depth in the soil profile, values of magnetic susceptibility at depths ranging from 1 to 10 cm, and maximum and background values of magnetic susceptibility in the soil profile. These indicators were previously analyzed in the literature. The results showed that a range of correlation of magnetic susceptibility was significantly correlated with magnetic susceptibility measured at depths 1, 2, and 3 cm. It suggests that a range of correlation is a good measure of pollutants' dispersion in the soil profile. The sill of the variogram of magnetic susceptibility was found to be significantly correlated with the area under the curve of plot of magnetic susceptibility that is related to the soil pollution. In consequence, the parameters of microscale spatial variability of magnetic susceptibility in s soil profile are important measures that take into consideration the spatial aspect of s soil pollution.

Coke industry and steel metallurgy as the source of soil contamination by technogenic magnetic particles, heavy metals and polycyclic aromatic hydrocarbons.

Application of integrated magnetic, geochemical and mineralogical methods for qualitative and quantitative assessment of forest topsoils exposed to the industrial emissions was the objective of this manuscript. Volume magnetic susceptibility (κ) in three areas of southern Poland close to the coke and metallurgical plants was measured directly in the field. Representative topsoil samples were collected for further chemical and mineralogical analyses. Topsoil magnetic susceptibility in the studied areas depended mainly on the content of technogenic magnetic particles (TMPs) and decreased downwind at increasing distance from the emitters. In the vicinity of coking plants a high amount of polycyclic aromatic hydrocarbons (PAHs) was observed, especially the most carcinogenic ones with four- and five-member rings. No significant concentration of TMPs (estimated on the base of κ values) and heavy metals (HM) was observed in area where the coke plant was the only pollution source. In areas with both coke and metallurgical industry, higher amounts of TMPs, PAHs and HM were detected. Morphological and mineralogical analyses of TMPs separated from contaminated soil samples revealed their high heterogeneity in respect of morphology, grain size, mineral and chemical constitution. Pollution load index and toxicity equivalent concentration of PAHs used for soil quality assessment indicated its high level of pollution.

Magnetic anomalies of forest soils in the Upper Silesia-Northern Moravia region.

Previous investigations revealed a strong magnetic anomaly due to soil magnetic enhancement in the industrialized cross-border area of Upper Silesia (Poland) and Northern Moravia (Czech Republic). Since industrial and urban dusts contain magnetic particles, this soil magnetic enhancement is assumed to be of anthropogenic origin, caused by a high concentration of atmospherically deposited magnetic particles, accumulated in topsoil layers. This assumption is proved by investigations of vertical profiles of magnetic susceptibility along a transect crossing the border area of the two countries. The results show that the population of magnetic minerals in the organic horizon is different from that in the mineral horizons. The vertical distribution of magnetic susceptibility and thermomagnetic analysis suggests negligible lithogenic contribution. The observed relationship between magnetic susceptibility and some heavy metals, confirmed by micromorphological observations and microchemical analysis of magnetic particles separated from the organic horizons of forest topsoil, has proved the usefulness of soil magnetometry for pollution study.