RESUMO
In the current study, synthesis and use of a novel adsorbent (composite in nature) are presented for treatment of one of the most commonly found pharmaceutical compound, viz, diclofenac sodium (DCF) in waste water. Synthesis of the composite adsorbent was done by hydrothermal method metal organic framework (MOF) based on Zr metal and multi-walled carbon nanotube (MWCNT). The composite adsorbent is termed as UiO-66/MWCNT. The confirmation of successful synthesis of the adsorbent is done with the help of sophisticated characterization techniques like FTIR, XRD, zeta potential analyser, and SEM. The synthesized composite adsorbent is found to have good adsorption capacity for DCF. The experiments related to the process of adsorption were done in batch mode and the significance of various operating parameters affecting the specific uptake of DCF. Maximum adsorption is observed at 3 pH (acidic condition) when the initial concentration of DCF and adsorbent dose was 30 mg/L and 100 mg/L, respectively. The Langmuir isotherm model best describes the process of adsorption with a maximum adsorption capacity of 256.41 mg/g. Experimental results obtained through the studies conducted related to the kinetics displayed that the process followed pseudo-second order model, and intraparticle studies suggested that diffusion through pores controls the rate. Thermodynamic studies suggest that the adsorption of DCF on UiO-66/MWCNT was completely spontaneous with ΔH = -22.089 kJ/mol. The possible mechanism for the adsorptive removal of DCF through UiO-66/MWCNT as found from this study is electrostatic interaction.
RESUMO
The presence of arsenic and fluoride in groundwater has been observed throughout the world. Many technologies have been developed by various research groups in order to tackle this problem. Adsorption has emerged as one of the best possible technique for the removal of arsenic, fluoride and many other pollutants from drinking water. Although a considerable amount of work has been published on the adsorptive removal of arsenic and fluoride, the area related to the management of spent adsorbent is not well explored. Present paper deals with the adsorptive removal of arsenic and fluoride from aqueous solution by three different types of adsorbents, namely, thermally treated laterite (TTL), acid-base treated laterite (ABTL) and aluminum oxide/hydroxide nanoparticles (AHNP). Under the experimental conditions in batch operation, the adsorption capacities of TTL, ABLT and AHNP for arsenic are found to be 6.43 µg/g, 9.25 µg/g and 48.5 µg/g respectively, whereas for fluoride, these values are found as 0.21 mg/g, 0.85 mg/g and 4.65 mg/g respectively. After adsorption, the spent adsorbents have been stabilized in the form of clay bricks. The effects of spent adsorbent concentration on the properties of bricks and their leaching properties are investigated. The bricks have been tested for various properties like density, percentage water absorption, shrinkage, compressive strength and efflorescence. The maximum values of density and shrinkage of the bricks formed are found as 2.3 g/cm3 and 10.2%, whereas the percentage water absorption and compressive strength of the bricks are found between 11 and 14% and 35 to 150 kgf/cm2 respectively. All the test results are in accordance with the criteria set by Indian Standards. The leaching test of arsenic and fluoride from the bricks reveals that their maximum values in leachate are 510 µg/L and 2.1 mg/L respectively, which are below the permissible limits of USEPA standards.