RESUMO
PURPOSE: Dislocation remains 1 of the leading causes of revision after primary total hip arthroplasty (THA) and there is clear evidence the dual-mobility (DM) is used more frequently to minimise this. But in smaller cups, whether the use of DM with smaller 22-mm heads imparts any increased stability compared to standard bearing is unknown; especially when those smaller cups now allow for large single-bearing (SB) heads. METHODS: 3 primary cup sizes (48 mm, 50 mm, 52 mm) were chosen a priori for modelling. Head sizes trialled for the standard bearing (SB) constructs group were 28-0 mm, 32-0 mm and 36-0 mm against neutral polyethylene liners. In the modular sub-hemispheric DM constructs the inner head sizes for the DM constructs were altered where appropriate (22-0 mm vs. 28-0 mm). Cup position, stem offset, and stem size were standardised. RESULTS: Both DM constructs outperformed all SB constructs because of a statistically significant jump distance increase (p < 0.001). However, there was no difference in range of motion (ROM) or jump distances between the 22-mm and 28-mm DM inner heads.The ROM angle before impingement between the DM (with 22-mm or 28-mm heads) and SB (with different head sizes where appropriate) showed no statistically significant difference. However, DM constructs presented significantly larger jump distances than SB constructs for both provocative dislocation tests across all 3 cup sizes.Of interest, for 50-mm and 52-mm cup sizes (for which this particular DM construct design can accommodate both 22-mm and 28-mm inner heads), there were no differences in ROM or jump distance between 22-mm versus 28-mm inner heads. CONCLUSIONS: In this computer-modelling study, DM constructs are advantageous over SB constructs for improving jump distances in clinically provocative positions, but not range of motion angles. Inner head diameter of DM has no effect on stability.