Preparation of graphene thin films for radioactive samples.

A new method for the preparation of conductive thin films is presented. The metallization of VYNS films guarantees the electrical conductivity but it results in the breaking of a high proportion of them. Graphene, a two-dimensional nanostructure of monolayer or few layers graphite has attracted a great deal of attention because of its excellent properties such as a good chemical stability, mechanical resistance and extraordinary electronic transport properties. In this work, the possibilities of graphene have been explored as a way to produce electrical conductive thin films without an extra metallization process. The procedure starts with preparing homogenous suspensions of reduced graphene oxide (rGO) in conventional VYNS solutions. Ultra-sonication is used to ensure a good dispersibility of rGO. Graphene oxide (GO) is prepared via oxidation of graphite and subsequent exfoliation by sonication. Different chemically rGO were obtained by reaction with hydrazine sulfate, sodium borohydride, ascorbic acid and hydroiodic acid as reducing agents. The preparation of the thin graphene films is done in a similar way as the conventional VYNS foil preparation procedure. Drops of the solution are deposited onto water. The graphene films have been used to prepare sources containing some electron capture radionuclides ((109)Cd, (55)Fe, (139)Ce) with an activity in the order of 3kBq. The samples have been measured to test the attainable low energy electron efficiency and the energy resolution of Auger and conversion electrons by 4π (electron capture)-γ coincidence measurements. The 4π (electron capture)-γ coincidence setup includes a pressurized proportional counter and a NaI(Tl) detector. Tests with different pressures up to 1000kPa were carried out. All these tests show similar values in both parameters (efficiency and resolution) as those obtained by using the conventional metallized films without the drawback of the high percentage of broken films.

Measurement of the half-life of 68Ga.

The half-life of the positron-emitter (68)Ga has been measured by following the decay rate with two systems based on ionization chamber and Ge detectors. The decay rate was measured for periods of time up to 10 half-lives. The combination of the 6 results obtained with both systems gives a value of T1/2=67.845(18) min, in good agreement with recommended data and with an uncertainty lower than any other previously reported value.

Standardization of Sn-113.

The radionuclide (113)Sn is a quasi-monoenergetic gamma emitter often used in the efficiency calibration of gamma spectrometers in the energy region around 390keV. This paper presents the results of the standardization of this radionuclide by three methods: integral (4π-γ) counting with a well-type NaI(Tl) detector, liquid scintillation counting applying the CIEMAT-NIST method and 4π coincidence counting (conversion electron-X) with a digital coincidence system.

Standardization of Ga-68 by coincidence measurements, liquid scintillation counting and 4πγ counting.

The radionuclide (68)Ga is one of the few positron emitters that can be prepared in-house without the use of a cyclotron. It disintegrates to the ground state of (68)Zn partially by positron emission (89.1%) with a maximum energy of 1899.1 keV, and partially by electron capture (10.9%). This nuclide has been standardized in the frame of a cooperation project between the Radionuclide Metrology laboratories from CIEMAT (Spain) and CNEA (Argentina). Measurements involved several techniques: 4πß-γ coincidences, integral gamma counting and Liquid Scintillation Counting using the triple to double coincidence ratio and the CIEMAT/NIST methods. Given the short half-life of the radionuclide assayed, a direct comparison between results from both laboratories was excluded and a comparison of experimental efficiencies of similar NaI detectors was used instead.

Standardization of 18F by coincidence and LSC methods.

The nuclide 18F disintegrates to 18O by beta+ emission (96.86%) and electron capture (3.14%) with a half-life of 1.8288 h. It is widely used in nuclear medicine for positron emission tomography (PET). A radioactive solution of this nuclide has been standardized by two techniques: coincidence measurements with a pressurized proportional counter and liquid scintillation counting using the CIEMAT/NIST method. One ampoule containing a solution calibrated in activity was sent for measurement at the International Reference System maintained by the BIPM. Results are in excellent agreement with SIR values.

Standardization of 67Ga by 4pigamma (NaI) and 4pibeta-gamma coincidence methods.

The nuclide 67Ga is widely used in nuclear medicine for diagnostic purposes. It decays with a half-life of 3.259 days to 67Zn, a stable nuclide. The decay mode is electron capture with several branches followed by gamma-de-excitation. One of the excited levels of 67Zn with energy 93 keV has a half-life of 9.1 micros, which makes its absolute standardization by coincidence methods difficult. Two methods were used to standardize a solution of this nuclide: (a) 4pi-EC(PPC)-gamma(NaI) coincidence counting with efficiency extrapolation to infinite dead time and (b) high-efficiency 4pigamma counting with a well-type NaI detector.