RESUMO
We present the Focus-Induced Photoresponse (FIP) technique, a novel approach to optical distance measurement. It takes advantage of a universally-observed phenomenon in photodetector devices, an irradiance-dependent responsivity. This means that the output from a sensor is not only dependent on the total flux of incident photons, but also on the size of the area in which they fall. If probe light from an object is cast on the detector through a lens, the sensor response depends on how far in or out of focus the object is. We call this the FIP effect. Here we demonstrate how to use the FIP effect to measure the distance to that object. We show that the FIP technique works with different sensor types and materials, as well as visible and near infrared light. The FIP technique operates on a working principle, which is fundamentally different from all established distance measurement methods and hence offers a way to overcome some of their limitations. FIP enables fast optical distance measurements with a simple single-pixel detector layout and minimal computational power. It allows for measurements that are robust to ambient light even outside the wavelength range accessible with silicon.
RESUMO
Copper nanowire (Cu NW) based transparent conductors are promising candidates to replace ITO (indium-tin-oxide) owing to the high electrical conductivity and low-cost of copper. However, the relatively low performance and poor stability of Cu NWs under ambient conditions limit the practical application of these devices. Here, we report a solution-based approach to wrap graphene oxide (GO) nanosheets on the surface of ultrathin copper nanowires. By mild thermal annealing, GO can be reduced and high quality Cu r-GO core-shell NWs can be obtained. High performance transparent conducting films were fabricated with these ultrathin core-shell nanowires and excellent optical and electric performance was achieved. The core-shell NW structure enables the production of highly stable conducting films (over 200 days stored in air), which have comparable performance to ITO and silver NW thin films (sheet resistance â¼28 Ω/sq, haze â¼2% at transmittance of â¼90%).
RESUMO
Colloidal metal nanowire based transparent conductors are excellent candidates to replace indium-tin-oxide (ITO) owing to their outstanding balance between transparency and conductivity, flexibility, and solution-processability. Copper stands out as a promising material candidate due to its high intrinsic conductivity and earth abundance. Here, we report a new synthetic approach, using tris(trimethylsilyl)silane as a mild reducing reagent, for synthesizing high-quality, ultrathin, and monodispersed copper nanowires, with an average diameter of 17.5 nm and a mean length of 17 µm. A study of the growth mechanism using high-resolution transmission electron microscopy reveals that the copper nanowires adopt a five-fold twinned structure and evolve from decahedral nanoseeds. Fabricated transparent conducting films exhibit excellent transparency and conductivity. An additional advantage of our nanowire transparent conductors is highlighted through reduced optical haze factors (forward light scattering) due to the small nanowire diameter.