RESUMO
Renewable energy is crucial for sustainable future, and Cu2 ZnSnS4 (CZTS) based solar cells shine as a beacon of hope. CZTS, composed of abundant, low-cost, and non-toxic elements, shares similarities with Cu(In,Ga)Se2 (CIGS). However, despite its promise and appealing properties for solar cells, CZTS-based solar cells faces performance challenges owing to inherent issues with CZTS material, and conventional substrate structure complexities. This review critically examines these roadblocks, explores ongoing efforts and breakthroughs, providing insight into the evolving landscape of CZTS-based solar cells research. Furthermore, as an optimistic turn in the field, the review first highlights the crucial need to transition to a superstrate structure for CZTS-based single junction devices, and summarizes the substantial progress made in this direction. Subsequently, dive into the discussion about the fascinating realm of CZTS-based tandem devices, providing an overview of the existing literature as well as outlining the possible potential strategies for enhancing the efficiency of such devices. Finally, the review provides a useful outlook that outlines the priorities for future research and suggesting where efforts should concentrate to shape the future of CZTS-based solar cells.
RESUMO
Several strategies and approaches have been reported for improving the resilience and optoelectronic properties of perovskite films. However, fabricating a desirable and stable perovskite absorber layer is still a great challenge due to the optoelectronic and fabrication limitations of the materials. Here, we introduce diethylammonium bromide (DABr) as a post-treatment material for the pre-deposited methylammonium lead iodide (MAPbI3) film to fabricate a high-quality two-dimensional/three-dimensional (2D/3D) stacked hetero-structure perovskite film. The post-treatment method of DABr not only induces the small crystals of MAPbI3 perovskite secondary growth into a large crystal, but also forms a 2D capping layer on the surface of the 3D MAPbI3 film. Meanwhile, the grains and crystallization of 3D film with DABr post-treatment are significantly improved, and the surface defect density is remarkably reduced, which in turn effectively suppressed the charge recombination in the interface between the perovskite layer and the charge transport layer. The perovskite solar cell based on the DABr-treatment exhibited a significantly enhanced power conversion efficiency (PCE) of 19.10% with a notable improvement in the open circuit voltage (VOC) of 1.06 V and good stability, advocating the potential of this perovskite post-treatment approach.
Assuntos
Brometos , Compostos de Cálcio , Óxidos , Recombinação GenéticaRESUMO
Infrared solar cells (IRSCs) can supplement silicon or perovskite SCs to broaden the utilization of the solar spectrum. As an ideal infrared photovoltaic material, PbS colloidal quantum dots (CQDs) with tunable bandgaps can make good use of solar energy, especially the infrared region. However, as the QD size increases, the energy level shrinking and surface facet evolution makes us reconsider the matching charge extraction contacts and the QD passivation strategy. Herein, different to the traditional sol-gel ZnO layer, energy-level aligned ZnO thin film from a magnetron sputtering method is adopted for electron extraction. In addition, a modified hybrid ligand recipe is developed for the facet passivation of large size QDs. As a result, the champion IRSC delivers an open circuit voltage of 0.49 V and a power conversion efficiency (PCE) of 10.47% under AM1.5 full-spectrum illumination, and the certified PCE is over 10%. Especially the 1100 nm filtered efficiency achieves 1.23%. The obtained devices also show high storage stability. The present matched electron extraction and QD passivation strategies are expected to highly booster the IR conversion yield and promote the fast development of new conception QD optoelectronics.