Unexpected sequel to the application of silver fluoride followed by stannous fluoride to an open carious lesion in a primary molar: A case report.

OBJECTIVES: The use of silver fluoride followed by stannous fluoride was designed for the treatment of open carious lesions in primary molars in dental outreach programs. However, during the COVID-19 pandemic when aerosol-producing procedures were inadvisable, one dental location started using it as the first stage in a two-visit restorative procedure for carious primary molars. If the gap between the fluoride application and the restoration placement stages was around 3-5 weeks it was noticed that a black friable crust appeared on the caries surface. To investigate further a normally discarded crust from one patient was retrieved and sent for analysis. MATERIALS AND METHODS: Two techniques suitable for identification and preliminary analysis of material of unknown composition, scanning electron microscopy and energy dispersive spectroscopy (EDS) were used. The only preparation was that the specimen was dried and coated beforehand. RESULTS AND CONCLUSIONS: This preliminary examination showed two unexpected findings. The first was that the crust surface indicated a possible dentine derivation as it was covered with reasonably evenly spaced holes. In addition, the EDS spectrum showed it to be, at least, partially mineralized. The second unexpected finding was that the surface was coated with electron-dense particles. The size of the particles and the EDS spectrum pointed to the likelihood of the majority of them being nanosilver. These unexpected findings suggest a possible new direction for research.

NH(4)OH-KOH pulping mechanisms and kinetics of rice straw.

The mechanisms and kinetics of NH(4)OH-KOH mixture pulping rice straw were studied. When aqueous ammonia was mixed with a small amount of caustic potash (ratio of 1:5), three distinct delignification phases were observed in the pulping process: a bulk delignification phase from the beginning of the cooking period to 100 degrees C, a supplementary delignification phase from 100 degrees C to 155 degrees C lasting a further 45 min, and a residual delignification phase until the end of the cooking period. There were two silica removal phases; the first phase was from the beginning of the cooking period to 100 degrees C and the second phase was from 100 degrees C to the end of the cooking period. The rate of delignification reaction was first order with respect to residual lignin and 0.3 order with respect to [OH(-)]. The silica removal was pseudo-first-order with respect to residual silica and 0.6 order with respect to [OH(-)]. The activation energies of the delignification and removal of silica reactions were 35.6 and 30.9 kJ/mol, respectively.

A new pulping process for wheat straw to reduce problems with the discharge of black liquor.

Aqueous ammonia mixed with caustic potash as wheat straw pulping liquor was investigated. The caustic potash did not only reduce the NH3 usage and cooking time, but also provided a potassium source as a fertilizer in the black liquor. Excess NH3 in the black liquor was recovered and reused by batch distillation with a 98% recovery rate of free NH3. The black liquor was further treated for reuse by coagulation under alkaline conditions. The effects of different flocculation conditions, such as the dosage of 10% aluminium polychloride, the dosage of 0.1% polyacrylamide, the reaction temperature and the pH of the black liquor on the flocculating process were studied. The supernatant was recycled as cooking liquor by adding extra NH4OH and KOH. The amount of delignification and the pulp yield for the process remained steady at 82-85% and 48-50%, respectively, when reusing the supernatant four times. The coagulated residues could be further processed as solid fertilizers. This study provided a new pulping process for wheat straw to reduce problems of discharge black liquor.