Mean lung pressure during adult high-frequency oscillatory ventilation: an experimental study using a lung model.

In adult high-frequency oscillatory ventilation (HFOV), stroke volume (SV) and mean lung pressure (PLung) are important for lung protection. We measured the airway pressure at the Y-piece and the lung pressure during HFOV using a lung model and HFOV ventilators for adults (R100 and 3100B). The lung model was made of a 20-liter, airtight rigid plastic container (adiabatic compliance: 19.3 ml/cmH2O) with or without a resistor (20 cmH2O/l/sec). The ventilator settings were as follows: mean airway pressure (MAP), 30 cmH2O; frequency, 5-15 Hz (every 1 Hz); airway pressure amplitude (AMP), maximum;and % of inspiratory time (IT), 50% for R100, 33% or 50% for 3100B. The measurements were also performed with an AMP of 2/3 or 1/3 maximum at 5, 10 and 15 Hz. The PLung and the measured MAP were not consistently identical to the setting MAP in either ventilator, and decreasing IT decreased the PLung in 3100B. In conclusion, we must pay attention to the possible discrepancy between the PLung and the setting MAP during adult HFOV.

Oxygen supersaturated fluid using fine micro/nanobubbles.

Microbubbles show peculiar properties, such as shrinking collapse, long lifetime, high gas solubility, negative electric charge, and free radical production. Fluids supersaturated with various gases can be easily generated using microbubbles. Oxygen microbubble fluid can be very useful for oxygen delivery to hypoxic tissues. However, there have been no reports of comparative investigations into adding fluids containing oxygen fine micro/nanobubbles (OFM-NBs) to common infusion solutions in daily medical care. In this study, it was demonstrated that OFMNBs can generate oxygen-supersaturated fluids, and they may be sufficiently small to infuse safely into blood vessels. It was found that normal saline solution is preferable for generating an oxygen-rich infusion fluid, which is best administered as a 30-minute intravenous infusion. It was also concluded that dextran solution is suitable for drug delivery substances packing oxygen gas over a 1-hour intravenous infusion. In addition, normal saline solution containing OFMNBs was effective for improving blood oxygenation. Thus, the use of OFMNB-containing fluids is a potentially effective novel method for improving blood oxygenation in cases involving hypoxia, ischemic diseases, infection control, and anticancer chemoradiation therapies.

Immediate screening method for predicting the necessity of massive transfusions in trauma patients: a retrospective single-center study.

BACKGROUND: Hemostatic resuscitation might improve the survival of severely injured trauma patients. Our objective was to establish a simplified screening system for determining the necessity of massive transfusions (MT) at an early stage in trauma cases. METHODS: We retrospectively analyzed the cases of trauma patients who had been transported to our institution between November 2011 and October 2013. Patients who were younger than 18 years of age or who were confirmed to have suffered a cardiac arrest at the scene or on arrival were excluded. MT were defined as transfusions involving the delivery of ≥10 units of red blood cell concentrate within the first 24 h after arrival. RESULTS: A total of 259 trauma patients were included in this study (males: 178, 69%). Their mean age was 49 ± 20, and their median injury severity score was 14.4. Thirty-three (13%) of the patients required MT. The presence of a shock index of ≥1, a base excess of ≤ -3 mmol/L, or a positive focused assessment of sonography for trauma (FAST) result was found to exhibit sensitivity and specificity values of 0.97 and 0.81, respectively, for predicting the necessity of MT. Furthermore, this method displayed an area under the receiver operating characteristic curve of 0.934 (95% confidence interval, 0.891-0.978), which indicated that it was highly accurate. CONCLUSIONS: Our screening method based on the shock index, base excess, and FAST result is a simple and useful way of predicting the necessity of MT early after trauma.

Evaluating the need for and effect of percutaneous transluminal angioplasty on arteriovenous fistulas by using total recirculation rate per dialysis session ("clearance gap").

The functioning of an arteriovenous fistula (AVF) used for vascular access during hemodialysis has been assessed mainly by dilution methods. Although these techniques indicate the immediate recirculation rate, the results obtained may not correlate with Kt/V. In contrast, the clearance gap (CL-Gap) method provides the total recirculation rate per dialysis session and correlates well with Kt/V. We assessed the correlation between Kt/V and CL-Gap as well as the change in radial artery (RA) blood flow speed in the fistula before percutaneous transluminal angioplasty (PTA) in 45 patients undergoing continuous hemodialysis. The dialysis dose during the determination of CL-Gap was 1.2 to 1.4 Kt/V. Patients with a 10% elevation or more than a 10% relative increase in CL-Gap underwent PTA (n = 45), and the values obtained for Kt/V and CL-Gap before PTA were compared with those obtained immediately afterward. The mean RA blood flow speed improved significantly (from 52.9 to 97.5cm/sec) after PTA, as did Kt/V (1.07 to 1.30) and CL-Gap (14.1% to -0.2%). A significant correlation between these differences was apparent (r = -0.436 and p = 0.003). These findings suggest that calculating CL-Gap may be useful for determining when PTA is required and for assessing the effectiveness of PTA, toward obtaining better dialysis.

Overheated and melted intracranial pressure transducer as cause of thermal brain injury during magnetic resonance imaging: case report.

Magnetic resonance imaging is used with increasing frequency to provide accurate clinical information in cases of acute brain injury, and it is important to ensure that intracranial pressure (ICP) monitoring devices are both safe and accurate inside the MRI suite. A rare case of thermal brain injury during MRI associated with an overheated ICP transducer is reported. This 20-year-old man had sustained a severe contusion of the right temporal and parietal lobes during a motor vehicle accident. An MR-compatible ICP transducer was placed in the left frontal lobe. The patient was treated with therapeutic hypothermia, barbiturate therapy, partial right temporal lobectomy, and decompressive craniectomy. Immediately after MRI examination on hospital Day 6, the ICP monitor was found to have stopped working, and the transducer was subsequently removed. The patient developed meningitis after this event, and repeat MRI revealed additional brain injury deep in the white matter on the left side, at the location of the ICP transducer. It is suspected that this new injury was caused by heating due to the radiofrequency radiation used in MRI because it was ascertained that the tip of the transducer had been melted and scorched. Scanning conditions--including configuration of the transducer, MRI parameters such as the type of radiofrequency coil, and the specific absorption rate limit--deviated from the manufacturer's recommendations. In cooperation with the manufacturer, the authors developed a precautionary tag describing guidelines for safe MR scanning to attach to the display unit of the product. Strict adherence to the manufacturer's guidelines is very important for preventing serious complications in patients with ICP monitors undergoing MRI examinations.

Humidification of base flow gas during adult high-frequency oscillatory ventilation: an experimental study using a lung model.

In adult high-frequency oscillatory ventilation (HFOV) with an R100 artificial ventilator, exhaled gas from patient's lung may warm the temperature probe and thereby disturb the humidification of base flow (BF) gas. We measured the humidity of BF gas during HFOV with frequencies of 6, 8 and 10 Hz, maximum stroke volumes (SV) of 285, 205, and 160 ml at the respective frequencies, and, BFs of 20, 30, 40 l/min using an original lung model. The R100 device was equipped with a heated humidifier, Hummax Ⅱ, consisting of a porous hollow fiber in circuit. A 50-cm length of circuit was added between temperature probe (located at 50 cm proximal from Y-piece) and the hollow fiber. The lung model was made of a plastic container and a circuit equipped with another Hummax Ⅱ. The lung model temperature was controlled at 37℃. The Hummax Ⅱ of the R100 was inactivated in study-1 and was set at 35℃ or 37℃ in study-2. The humidity was measured at the distal end of the added circuit in study-1 and at the proximal end in study-2. In study-1, humidity was detected at 6 Hz (SV 285 ml) and BF 20 l/min, indicating the direct reach of the exhaled gas from the lung model to the temperature probe. In study-2 the absolute humidity of the BF gas decreased by increasing SV and by increasing BF and it was low with setting of 35℃. In this study setting, increasing the SV induced significant reduction of humidification of the BF gas during HFOV with R100.

Picosecond master-oscillator, power-amplifier system based on a mixed vanadate phase conjugate bounce amplifier.

We demonstrate a high average power approximately 4 ps output from a phase conjugate laser system based on a diode-side-pumped Nd:Gd(0.6)Y(0.4)VO(4) bounce amplifier. An average output power of 16.2 W with a peak power of 210 kW was achieved. A corresponding extraction efficiency of 23% was measured.