RESUMO
The paper considers the development of fillers representing mixtures of carbon nanotubes and graphene materials (graphene oxide and graphene nanoplatelets) in different mass ratios to modify epoxy resin. The graphene type and content effect on the dispersed phase particle effective sizes-both in aqueous suspensions and the resin-was analyzed. Hybrid particles were characterized by Raman spectroscopy and electron microscopy. The composites containing 0.15-1.00 wt.% CNTs/GO and CNTs/GNPs were thermogravimetrically analyzed, and their mechanical characteristics were determined. SEM images of the composite fracture surfaces were acquired. Optimal dispersions containing 75-100 nm particles were obtained at the CNTs:GO mass ratio of 1:4. It was shown that the CNTs can be located between the GO layers and on the GNP surface. The samples containing up to 0.2 wt.% CNTs/GO (at 1:1 and 1:4 ratios) were stable when heated in air up to 300 °C. For 0.15-0.20 wt.% CNTs/GO (at 1:1 ratio), the tensile strength and modulus of the composite increased by 84-88 and 40%, respectively. The increase in the strength characteristics was found to occur due to the interaction of the filler layered structure with the polymer matrix. The obtained composites can be used as structural materials in different fields of engineering.
RESUMO
This paper considers the synthesis of a novel nanocomposite based on reduced graphene oxide and oxidized carbon nanotubes modified with polyaniline and phenol-formaldehyde resin and developed through the carbonization of a pristine aerogel. It was tested as an efficient adsorbent to purify aquatic media from toxic Pb(II). Diagnostic assessment of the samples was carried out through X-ray diffractometry, Raman spectroscopy, thermogravimetry, scanning and transmission electron microscopy, and infrared spectroscopy. The carbonized aerogel was found to preserve the carbon framework structure. The sample porosity was estimated through nitrogen adsorption at 77 K. It was found that the carbonized aerogel predominantly represented a mesoporous material having a specific surface area of 315 m2/g. After carbonization, an increase in smaller micropores occurred. According to the electron images, the highly porous structure of the carbonized composite was preserved. The adsorption capacity of the carbonized material was studied for liquid-phase Pb(II) extraction in static mode. The experiment results showed that the maximum Pb(II) adsorption capacity of the carbonized aerogel was 185 mg/g (at pH 6.0). The results of the desorption studies showed a very low desorption rate (0.3%) at pH 6.5 and a rate of about 40% in a strongly acidic medium.